W

ired Colour Camera

CCTV Kit

CWK1

Installa tion and Operating Instructions

T

hese instructions should be retained in a safe place for future reference.

INTR ODUCTION

Section 1

T he Response Wired Colour Camera is a colour, weatherproof day/night camera. The camera easily connects to your TV/VCR/DVR for the protection of your home or office, etc.

The camera is easily mounted on the wall or ceiling using the supplied mounting bracket.

Please r ead before you start:

Al ways use discretion when installing CCTV surveillance equipment especially when there is perceived policy. Enquire regarding local regulations applicable to the lawful installation of video recording / surveillance. Third party consent may be required.

SAFETY AND INSTALLATION TIPS:

Do not a ttempt to open the camera unit with the power adaptor plug connected to avoid any risk of personal injury.

When installing CCTV camera(s), always follow manufacturer’s advice when using power tools, steps, ladders, etc. and wear suitable protective equipment (e.g. safety goggles) when drilling holes, etc. Before drilling holes through walls or ceilings check for hidden electricity cables and water pipes. The use of a cable/pipe detector is advisable.

When installing this camera, it is advisable to use cable conduit to protect any video/ power extension cables from being exposed externally and to prevent/reduce the chances of the cables being tampered with. After drilling any hole though an external wall for a cable, ensure the hole is sealed up around the cable using a sealant to prevent drafts.

To prevent a fire or electrical shock hazard, do not attempt to open the housing while the unit is exposed to rain, water or wet conditions. There are no user serviceable parts inside. Refer servicing to qualified service personnel.

NIGHT VISION:

T he camera has built-in infra-red LEDs to allow you to view at night for 24hrs surveillance. The LEDs will automatically activate at night and the picture viewed will turn to black and white.

2

KIT CONTENTS

1 x Wired Colour Camera

1 x 10m RCA (male plug ) to RCA (male plug) extension cable

1 x 12VDC power supply adaptor

1 x Camera fixings kit - wall plugs and screws

1 x Installation and operating manual

1 x Window sticker

T ools Required:

Electric drill

5mm masonry drill bit

20mm masonry drill bit

No. 2 Philips screwdriver

3mm flat blade screwdriver

Section 2

INST ALLATION

Section 3

1.

Remove the bracket from the camera by unscrewing it from the main body as shown below:

Unscrew this washer nut to loosen Camera body from the bracket and unscrew Camera

Camera body position adjustment nut

2.

Use the base of the camera’s bracket to mark out the 3 mounting holes on the chosen surface. Mark out a hole for the cable connectors to pass through into the property next to the camera.

Note: It is r ecommended to pass the cable into the property as close to the camera as possible to reduce the chances of any exposed cables being tampered with.

If you

3

choose to run the cable along the wall outside the property, it is recommended to use cable conduit to hide the cable and reduce the chances of it being tampered with.

3.

Drill 3 x 5mm mounting holes for the bracket’s wall plugs and 1 x 20mm hole for the camera’s power and video connectors to pass through the wall or ceiling.

4.

Install the camera bracket using the supplied plugs and screws.

5.

Feed the video/power leads through the hole in the wall or ceiling, starting with the largest connector, and then refit the camera on to the bracket and adjust the position of the camera body as required by loosening the adjustment screw.

6.

The camera is supplied fitted with a 1m cable terminated with a RCA female plug and a female power connector.

7.

Connect the male end of the power connector from the extension cable into the camera along with the male RCA connector.

8.

Connect the RCA video end of the extension cable into video input of your TV/VCR/DVR.

9.

Tune your TV/VCR/DVR to auxiliary (AUX), A/V or video mode to view the camera.

(Note: R efer to your TV/VCR/DVR’s owner’s manual for setting this up).

10.

Adjust the camera again if necessary to the desired viewing angle.

Connection Summar y

TV / MONITOR

CAMERA

Extension Cable

Video Signal to Input

VCR / DVR

12VDC Power

Supply Adaptor

Note: If the supplied extension cable is not long enough, the extension cable for this camera can only be extended up to 30m in total length due to po wer loss.

4

TR OUBLE SHOOTING

Section 4

PR

P

OBLEM

No pictur e can be viewed oor picture quality

Some colour s viewed by the camer a do not appear to look lik e true colours

A w hite image appears a t night

SOLUTION

T he power supply adaptor is not plugged in.

The TV / VCR / DVR is not tuned to view the correct channel.

Clean the camer a lens.

Adjust the contrast/brightness on the TV.

T he camera’s lens is a CMOS type sensor. Its limita tion is that it will not produce all colours vie wed outside accurately.

T he camera’s infrared LEDs shine invisible light.

tha t reflects off surfaces such as glass causing white light. Place the camera on the other side of windows or place the lens of camera flush against the window to try to improve the night vision or place the camera in a well lit area.

5

TECHNICAL SPECIFICA TION

Section 5

ITEM

Ima ge sensor

Video format

Pixel resolution

WIRED COLOUR CAMERA

1/4” colour CMOS

PAL / NTSC

PAL: 628 (H) x 582 (V)

NTSC: 510 (H) x 492 (V)

380 TV lines Horizontal resolution

Minimum illumination

Viewing angle

Lens size

Night vision range

Number of infra-red LEDs

IP rating

Operating temperature

Power supply

0 Lux when the IR lamps are turned on

50°

6mm

Up to 9m

11

IP54

- 10°C to 55°C

12 VDC / 300mA

Cable type connections Fitted with 1m video cable terminated with female RCA and female jack (power) plugs

50 x 50 x 135mm Dimensions (W x D x H)

Weight 280g

6

A CCESSORIES IN THE RANGE

Section 6

T here are a range of accessories available in the Response CCTV product range to expand your system:

CA5

CA6

CA7

CA8

CA9

CA10

CA11

CA4

CA12

CA1

CA2

CWFK1

CA3

2 Channel Digital Video Image Recorder

LCD Screen for Wireless / Wired CCTV Kits

Wireless Colour Camera CCTV Kit

Wireless Colour Accessory Camera

(r equires CWFK1 CCTV KIT to operate)

Professional Heavy Duty Camera CCTV Kit

Dummy Professional Heavy Duty Camera

4 Channel Digital Video Image Recorder

Wired Internal Colour Dome Camera CCTV Kit

Dummy Internal Dome Camera

Heavy Duty Colour Camera CCTV Kit

Dummy Heavy Duty Camera

10m Extension Cable Kit

20m Extension Cable Kit

DISPOSAL – RECYCLING INSTRUCTIONS

Section 7

Directive (2002/96/EC)

T his product is classified by the Waste Electrical or Electronic

Equipment (WEEE) Directive. It should not be disposed of with other household or commercial waste.

At the end of its useful life the packaging and product should be disposed of via a suitable recycling centre.

For information on available facilities, please contact your local authority or the retailer from where the product was purchased.

7

GU ARANTEE

Section 8

No var ED&S undertakes to replace or repair at its discretion goods (excluding non rechargeable batteries) should they become defective within 1 year solely as a result of faulty materials and workmanship.

If the product has not been installed, operated or maintained in accordance with the instructions, has not been used appropriately or if any attempt has been made to rectify, dismantle or alter the product in any way the guarantee will be invalidated.

The guarantee states Novar ED&S entire liability. It does not extend to cover consequential loss or damage or installation costs arising from the defective product. This guarantee does not in any way affect the statutory or other rights of a consumer and applies to products installed within UK and Eire only.

If an item develops a fault, the product must be returned to the point of sale with:

1. Proof of purchase.

2. A full description of the fault.

3. All relevant batteries (disconnected).

Response is a trademark of Novar ED&S.

CUST

OMER HELPLINE

Most issues can be solved over the phone in a few minutes.

Please contact our Helpline Team on the number below for any installation and general advice regarding our products:

0844 736 9149

Lines open 9.00am to 5.00pm, Monday to Friday.

Calls charged at service providers national rate.

No var Electrical Devices and Systems Limited. (A Honeywell Company)

T he Arnold Centre, Paycocke Road, Basildon, Essex SS14 3EA. UK www.friedland.co.uk

© Novar Electrical Devices and Systems Limited. 2009 50043917 Rev.A