Astria Gemini CD / Superior DRC3000 Direct Vent Gas Fireplace Facade Manual

HEARTH PRODUCTS

KITS AND ACCESSORIES

Description

Façade Base Black

Façade Base

Stainless

Façade Panel Black

Façade Panel

Stainless

Trim Kit Black

Trim Kit Stainless

Table 1

Trim

Refer to Table 1.

one Façade Trim must be made. façade significant dimensions.

P506020-32

506020-32 REV.NC 04/2015

CONTEMPORARY

FAÇADE KITS

INSTALLATION INSTRUCTIONS FOR CONTEMPORARY FAÇADE KITS

GENERAL INFORMATION

FOR USE WITH GEMINI CD AND DRC3000 FIREPLACES

Contemporary Façade Units

35” Models

Base

40” Models

Catalog No. Model No. Catalog No. Model No.

F2460

F2461

F2464

F2465

F2468

F2470

FBBK35CD

FBSS35CD

FPBK35CD

FPSS35CD

TKBK35CD

TKSS35CD

F2462 FBBK40CD

F2463 FBSS40CD

F2466 FPBK40CD

F2467 FPSS40CD

F2469 TKBK40CD

F2471 TKSS40CD

The Contemporary Façade Kit is composed of three separate elements

(one base, one panel, and one trim kit) that are purchased separately.

NOTE: To complete one Façade a selection of one Base, one Panel and

The Panel must be installed on a properly positioned Gemini CD or

DRC3000 fireplace. Refer to Installation Instruction and Care and Op- erations (IICO) manuals for detailed instructions. Refer to Table 2 for

35” Model

40”

Models

Table 2

INSTRUCTIONS

Figure 1

A

44 1/2

(1130)

49 1/2

(1257)

E

A

C

F

Façade Dimensions

B

32 7/8

(835)

37 7/8

(962)

C

35 1/2

(902)

40 1/2

(1029)

D

23 7/8

(606)

28 7/8

(733)

E

29

(737)

34

(864)

D

F

16

(406)

21

(533)

B

Start by locating the fireplace face brackets indicated by the arrows at the top Figure 1 and the fireplace face foot slots indicated by the arrows at the bottom of Figure 1. Proceed with the steps on Page 2.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 1

Step 1. Slide top trim pieces over flange of panel until seated squarely. Step 2. Slide side trim pieces into place (top will overlap slightly). Repeat

Step 1 and Step 2 for bottom and opposite side trim for panel.

2

NOTE: Remove protective flim from all stainless components before installation.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Step 3. Plug lead wires into the IPI Switch on right side of facade base.

Facade

Base

Cutouts

Fireplace

Face

Bracket

Step 4a. Slide the foot tabs of the facade base into the slots (see Figure

1) on both sides near the bottom of the fireplace opening.

Step 4b. Tilting the facade base up on its foot tabs, secure the top by engaging the three brackets (see Figure 1) on the face of the fireplace with the three cut outs on the back top of the facade base.

Step 5. Slide the tabs on the back of both sides of the facade panel into the slots on the base.

(Black Base and Stainless Panel shown)

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 3