Lopi Northfield™ MV Gas Stove Instructions

O. Wall Mount Timer
TRAVIS INDUSTRIES SKU H 99300661
Operating Instructions For The Homeowner
The Wall Mount Timer is designed for use with appliances able to use a dry contact switch.
INSTALLING FRESH BATTERIES:
The fireplace MUST be OFF before replacing transmitter batteries.
INSTALL BATTERIES INTO THE WALL MOUNT TIMER:
Fresh Alkaline
AAA Batteries.
ES
OPERATION INSTRUCTIONS
WALL MOUNT TIMER OPERATION:
A. Flame On/Off (see figure 1)
1. Press the START TIMER button once to start the setting timer and turn on the fireplace.
2. Press the STOP OFF button once or at the end of the Timer Setting to turn off the fireplace.
WARNING: IT TAKES SOME TIME ! Figure 1 T > oo | |
| F/ C Selection |
FOR THE RECEIVER TO RESPOND TO | 648 | — Press and hold the STOP |
THE WALL MOUNT TIMER. DO NOT | ———| | OFF button for longer |
1... Room than 2 seconds. The °F or |
PRESS THE BUTTONS MORE THAN | Temperature BO A °C display will blink. |
ONCE WITHIN 2 SECONDS FOR | q -- Press the STOP OFF |
| (O) reune button to select |
CORRECT OPERATION. ı START TIMER temperature display in °F |
| button o or °C |
O / I
B. Setting: (see figure 1)
---F/°C Selection
1. press and hold the "STOP OFF" button for 2 seconds, the °F/°C display will blink. r-------------1
2. press the "STOP OFF" button to select temperature display in °F/°C .
3. press and hold the "STOP OFF" button for 4 seconds to exit setting.
C. Timer setting | |
1. Press the START TIMER button once enter a "Count-Down" Timer setting. The ' /-1-\ |
"Count down" timer has replaced the "Room Temperature" display. The default | |
is 30 minutes (blinking). Range: 30, 60, 90 or 120 minutes. (see figure 2),
Press the START TIMER button again to select the desired value. "Figure 3 |
2. Press START TIMER to review time left on "Count-Down" timer after activated, \ | / |
for example, "-25" means (blinking) the fireplace will run for 25 minutes. (see | = |
figure 3) | - C |
3. If you want to reset the "Count-Down" Timer after activated, you need to press | HN |
STOP OFF button once to turn off the fire place, then repeat step 1. ool
4. After the "Count down" timer has reached zero, it will automatically switch off
the fireplace.
Installation Instruction
Installing the Wall Mount Timer
Install the wall mount timer into a wall junction box
— Secure the wall mount timer to the wall mount.
— Use the screws provided to secure the face Plate to
the wall mount timer. See Figure 4.
Attaching the Timer
Connect the included wiring harness to the two terminals on
the timer. See Figure 5. Connect the harness to the on/off
circuit of the appliance (see "Series Connection" diagram
Installation of the
Transmitter to a Junction Box
» +
ART
MER
=
O
7]
|
Oz E!
Figure 4
O
below). >
Attach included wire
harness here >
(© /
Figure 5
Series Connection
On / Off Switch On / Off Switch
ON OFF
Thermostat / Heater is ON Heater is OFF
External Switch ON
Thermostat / Heater is OFF Heater is OFF
External Switch OFF
To wire the heater in series, follow the directions below:
a (©
On / Off Switch
Thermostat
N N (or External Switch) Wires
P/N: 81-131101-00