Billion BiPAC 7202GR2 User`s manual

BiPAC 7202 / 7202GR2
(802.11g) ADSL2+ Router
Quick Start Guide
Billion BiPAC 7202 / 7202GR2 ADSL2+Router
For more detailed instructions on configuring and using the
(802.11g) ADSL2+ Router, please refer to the on-line
manual.
Package Contents
BiPAC 7202 series ADSL2+ Router
CD-ROM containing the on-line manual
RJ-11 ADSL/telephone Cable
Ethernet (CAT-5 LAN) Cable
AC-DC power adapter (12VDC, 1A)
This Quick Start Guide
Do not use the router in high humidity or high temperatures.
Do not use the same power source for the router as other
equipment.
Do not open or repair the case yourself. If the router are too hot,
turn off the power immediately and have it repaired at a qualified
service center.
Avoid using this product and all accessories outdoors.
Place the router on a stable surface.
Only use the power adapter that comes with the package. Using
a different voltage rating power adaptor may damage the router.
Warning
Attention
1
Quick Start Guide
The Front LEDs
BiPAC 7202
BiPAC 7202GR2
LED
2
Meaning
1
PPP :
Lit steady when there is a PPPoA / PPPoE connection.
2
ADSL:
Lit when successfully connected to an ADSL DSLAM (“linesync”).
3
LAN Port:
Lit when connected to an Ethernet device.
Green for 100Mbps; Orange for 10Mbps.
Blinking when data is Transmitted / Received.
4
WLAN :
(7202GR2
only)
Lit green when the wireless connection is established.
Flashes when sending/receiving data.
5
SYS :
Lit when the system is ready.
6
PWR :
Lit when power is ON.
Billion BiPAC 7202 / 7202GR2 ADSL2+Router
The Rear Ports
BiPAC 7202
2
3
5
4
BiPAC 7202GR2
5
4
1
3
2
Port
Meaning
1
Power Switch Power ON/OFF switch
2
PWR
3
4
5
Connect the supplied power adapter to this jack.
1. After the device is powered on, press it to perform Failure
recover for a dead routers:
Simply hold the Emergency/Failure Recovery Button” when power
on the routers and download the Application if necessary.
RESET
2. perform the Emergency Recover for the missing Password
(Emergency/Fai case:(Using LEDs indications)
lure Recovery)
Simply hold the Emergency/Failure Recovery Button, when router
can be accessed from GUI, until the LEDs all turn Off, turn On and
then Turn Off. Then, router will perform configuration factory reset
and router reboot
LAN
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the four
(RJ-45
LAN ports when connecting to a PC or an office/home network of
connector)
10Mbps or 100Mbps.
ADSL
Connect the supplied RJ-11 (“telephone”) cable to this port when
connecting to the ADSL/telephone network.
(LINE)
3
Quick Start Guide
Connecting BiPAC 7202
1. Connect the Router to a LAN (Local Area Network) and the ADSL/telephone (LINE) network.
2. Power on the device.
3. Make sure the PWR and SYS LEDs are lit steadily and that the relevant LAN LED is lit.
4
Billion BiPAC 7202 / 7202GR2 ADSL2+Router
Connecting BiPAC 7202GR2
1. Connect the Router to a LAN (Local Area Network) and the ADSL/telephone (LINE) network.
2. Power on the device.
3. Make sure the PWR, SYS, and WLAN LEDs are lit steadily and that the relevant LAN LED is
lit.
5
Quick Start Guide
Configuring PC in Windows XP
1. Go to Start / Control Panel (in Classic
View). In the Control Panel, double-click on
Network Connections
2. Double-click Local Area Connection.
3. In the Local Area Connection Status
window, click Properties.
4. Select Internet Protocol (TCP/IP) and click
Properties.
5. Select the Obtain an IP address
automatically and the Obtain DNS server
address automatically radio buttons.
6. Click OK to finish the configuration.
6
Billion BiPAC 7202 / 7202GR2 ADSL2+Router
Configuring PC in Windows 2000
1. Go to Start / Settings / Control Panel. In the Control
Panel, double-click on Network and Dial-up
Connections.
2. Double-click Local Area Connection.
3. In the Local Area Connection Status
window click Properties.
4. Select Internet Protocol (TCP/IP) and click
Properties.
5. Select the Obtain an IP address
automatically and the Obtain DNS server
address automatically radio buttons.
6. Click OK to finish the configuration.
Configuring PC in Windows 98/Me
7
Quick Start Guide
1. Go to Start / Settings / Control Panel. In
the Control Panel, double-click on Network
and choose the Configuration tab.
2. Select TCP/IP ->
NE2000 Compatible, or the name of your
Network Interface Card (NIC) in your PC.
3. Select the Obtain an IP address
automatically radio button.
4. Then select the DNS Configuration tab.
5. Select the Disable DNS radio button and
click OK to finish the configuration.
Configuring PC in Windows NT4.0
8
Billion BiPAC 7202 / 7202GR2 ADSL2+Router
1. Go to Start / Settings / Control Panel. In
the Control Panel, double-click on Network
and choose the Protocols tab.
2. Select TCP/IP Protocol and click
Properties.
3. Select the Obtain an IP address from a
DHCP server radio button and click OK.
9
Quick Start Guide
Configuring Your ADSL Firewall Router
To configure this device, you must have IE 5.0 / Netscape
4.5 or above installed
1.
Open the web browser and type
http://192.168.1.254 in the browser’s
address box. This number is the default IP
address for this router. Press Enter.
2. A username and password window will
appear. The default username and
password are admin and admin. Press
OK to proceed.
3. You will get a status report on web page.
10
Billion BiPAC 7202 / 7202GR2 ADSL2+Router
Verifying Your Local Network Connection with the Device
To see if this ADSL Router is
visible on the local network, go to
Start / Run. In the Run dialog box,
type “ping 192.168.1.254” then
press OK.
A command prompt window will
pop out. If your ping is successful
which means your local network is
able to reach to the device, then
the command prompt window will
close up automatically.
Connection fails, when you see
“Request timed out” in the
command prompt window. You
may need to check your set up.
Product Support and Contact Information
Most problems can be solved by referring to the Troubleshooting section in the User’s Manual.
If you cannot resolve the problem with the Troubleshooting chapter, please contact the dealer
where you purchased this product.
Contact Billion
AUSTRALIA
http://www.billion.com.au
©2005 Billion Electric Co, PC Range P/L. All Rights Reserved.
WORLDWIDE
http://www.billion.com
Mac OS is a registered Trademark of Apple Computer, Inc.
Windows 98, Windows NT, Windows 2000, Windows Me and Windows XP are registered Trademarks of Microsoft
11