APW Wyott -36H Operating instructions

INSTALLATION
AND
OPERATING
INSTRUCTIONS
FRY HOLDING BIN
Model:
CFHS Series
RETAIN THIS MANUAL FOR FUTURE REFERENCE
WARNING
Improper installation, operation, service, or maintenance can cause property damage and/or result in
personal injury. Read this manual thoroughly before installing, operating, or servicing this equipment.
SAFETY PRECAUTIONS
APW Wyott's equipment is designed, built and sold for commercial use and should be operated
by
trained
personnel
only.
Make
sure
all
CAUTIONS,
WARNINGS
and
operating
instructions
are
clearly posted near each unit to insure proper operation and reduce the chance of personal injury
and/or equipment damage.
Always disconnect power before cleaning or servicing the unit. Surfaces will remain hot after
power has been removed, allow unit to cool before cleaning or servicing. Never clean the unit by
immersing it in water. The unit is not protected against water jets; DO NOT CLEAN UNIT WITH A
WATER JET. Always clean equipment properly before first use.
P/N: 95000018
Phone:
(214) 421-7366
Fax:
(214) 565-0976
9/05
APW WYOTT
Toll Free: (800) 527-2100
Website: www.apwwyott.com
Foodservice
E-mail:
729 Third Avenue,
info@apwwyott.com
1
Equipment
Company
Dallas, TX 75226
TABLE OF CONTENTS
SECTION
ITEM
PAGE
1
General Information
3
2
Installation
3
3
Operation Instructions
4
4
Cleaning Instructions
4
5
Troubleshooting
4
6
Replacement Parts
5
7
Wiring Diagrams
6
8
Warranty Policy
7
IMPORTANT FOR FUTURE REFERENCE
Please complete this information and retain this manual for the life of the equipment. For
Warranty Service and/or Parts, this information is required.
Model Number
Serial Number
Notes:
2
Date Purchased
1. GENERAL INFORMATION
Check the rating label for your model designation and electrical rating. Rating Label is located on
the rear base of the unit.
Overall dimensions:
CFHS-16
CFHS-21
22.31”
22.70”
(56.67 cm)
Electrical ratings:
Power Cord:
CFHS-16
CFHS-21
6
foot,
(57.66 cm)
120VAC, 880W, 60Hz, 7.33A, NEMA 5-15 Plug
120VAC, 1130W, 60Hz, 9.42A, NEMA 5-15 Plug
3
wire
grounded
cord.
If
the
supply
cord
is
damaged,
the
manufacturer or an authorized service agent or a similarly qualified person
must replace it in order to avoid a hazard.
Shipping Weight:
CFHS-16
CFHS-21
40.0 lbs. (18.14 kg)
50.0 lbs. (22.68 kg.)
2. INSTALLATION
The Fry Holding Station is shipped with the ribbon (model CFHS-21 only), divider and trivet
assembled. Care should be taken when removing unit from box, as ribbon, divider and trivet are
free to move.
1.
Remove unit from shipping container while in the upright position.
2.
Remove all internal packaging.
3.
Inspect bin area for damage. This includes ceramic elements and light
bulbs in overhead assembly.
4.
If
unit
needs
to
be
wiped
down
please
use
damp
cloth
with
warm
water.
5.
Unit should now have components in place as shown in Figure 1.
6.
Place unit in operating location.
Note Ambient Conditions
:
Make
sure
that
the
operating
ambient temperature is
held
location
constant
is
in
an
area
where
(minimum 70°F).
the
Please
avoid areas such as near exhaust fans, hoods and air conditioning
ducts.
Warning Operating environment
Figure 1.
:
Ensure that operation location is at a reasonable distance from combustible walls and materials
otherwise combustion or discoloration could occur.
Caution Operating environment
:
Place unit on a stable counter at a convenient height for use.
not intended to be used as a shelf.
The lid of the Fry Holding Station is
Objects over 25lbs (11.33kg) should not be placed on top of
unit.
7.
Before plugging unit into wall, make sure that the switch is in the off or “0” position.
8.
Plug unit into grounded electrical outlet with correct voltage, and plug configuration.
3
3. OPERATION INSTRUCTIONS
1.
The On/Off switch should be in the offline position “0”.
2.
Flip switch to online position “I”.
Caution External Surface Temperatures
:
The unit's external surface temperatures will be hot.
Use caution when touching these areas to
avoid injury.
Warning Severe Burns - Ceramic Elements
:
Ceramic elements operate at high temperatures.
applied to the elements
changing decal
.
.
to black.
As the element reaches a certain temperature the decal will change from red
The decal will remain black until the element falls below the transition temperature
where it will then return to its original red color.
extremely hot.
However, the element even if red will still be
This color changing decal is used only for determining if element is operational.
4. CLEANING INSTRUCTIONS
Warning
UnplugPower
Warning
Cleaning
:
Do not touch elements after power is
red color
Incorporated into the front surface of the element is a
Before cleaning, ensure that the unit is unplugged and its components are cooled down. There should be no
power going to the unit.
:
Never spray water on the unit or controls nor submerge unit in water.
Damage to the unit as well as injury
could occur. Injury and burns may occur if you do not follow this instruction sheet.
Cleaning should be done Daily.
1.
Clean outside with warm soapy water and a soft cloth only.
Mild degreaser can be used.
Do not use
abrasive cleaners, as they will scratch the finish, which could induce dirt accumulation.
2.
DO NOT USE ANY
3.
Once a week, clean the inside of the cabinet with warm soapy water and a soft cloth only.
solvents or acetone type cleaner.
They will damage the sealant.
degreaser can be used.
5. TROUBLESHOOTING
Always ask and check the following:
1.
Is the unit connected to a live power source of the proper voltage?
2.
Check the circuit breaker.
3.
Is power switch “ON” and lights glowing?
4.
Check the rating label. Is the unit connected to the correct power source?
5.
If the above checks out, and you still have problems, call your local service agent.
4
Mild
6. REPLACEMENT PARTS
EXPLODED VIEW
1
7
2
3
4
5
6
ITEM PART NUMBER
1
75916
2
REPLACEMENT PARTS LIST
DESCRIPTION
QUANTITY
Lamp, 40w, Teflon Coated
2
95000026
Element, Ceramic, CFHS-21
2
95100006
Element, Ceramic, CFHS-16
1
3
95000035
Divider, Trivet
1
4
95000005
Trivet, CFHS-21
1
95100021
Trivet, CFHS-16
1
5
95000036
Ribbon, 6 Bag (CFHS-21 only)
1
6
95000046
Pan w/Bottom Heater, CFHS-21
1
95100020
Pan w/Bottom Heater, CFHS-16
1
Switch
1
Thermostat (Not Shown)
1
7
89488
8
95000041
5
7. WIRING DIAGRAMS FOR CFHS SERIES
CFHS-21
RACEWAY
5
6
1
L
N
L
(BLUE)
2
(BROWN)
9
N
3
N
L
4
OVERHEAD
N
3
7L 4
L
BASE
8
L
G
L
CFHS-16
RACEWAY
2N
1
3
4
N
L
(BLUE)
(BROWN)
7 G
L
OVERHEAD
N
2
5L 1
L
BASE
6
N
G
L
L
8. APW WYOTT EQUIPMENT LIMITED WARRANTY
APW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmanship, subject to the
following conditions:
This warranty applies to the original owner only and is not assignable.
Should any product fail to function in its intended manner under normal use within the limits defined in this warranty, at the option of
APW Wyott such product will be repaired or replaced by APW Wyott or its Authorized Service Agency. APW Wyott will only be
responsible
for
charges
incurred
or
service
performed
by
its Authorized
Service
Agencies.
The
use
of
other
than APW
Wyott
Authorized Service Agencies will void this warranty and APW Wyott will not be responsible for such work or any charges associated
with same. The closest APW Wyott Authorized Service Agent must be used.
This warranty covers products shipped into the 48 contiguous United States, Hawaii, metropolitan areas of Alaska and Canada. There
will be no labor coverage for equipment located on any island not connected by roadway to the mainland.
Warranty coverage on products used outside the 48 contiguous United States, Hawaii, and metropolitan areas of Alaska and Canada
may vary. Contact the international APW Wyott distributor, dealer, or service agency for details.
Time Period
One year for parts and one year for labor, effective from the date of purchase by the original owner. The Authorized Service Agency
may, at their option, require proof of purchase. Parts replaced under this warranty are warranted for the un-expired portion of the
original product warranty only.
Exceptions
*Gas/Electric Cookline:
Models GCB, GCRB, GF, GGM, GGT, CHP-H, EF, EG, EHP. Three (3) Year Warranty on all
component parts, except switches and thermostats. (2 additional years on parts only. No labor on second or third year.)
*Broiler Briquettes, Rock Grates, Cooking Grates, Burner Shields, Fireboxes:
*Heat Strips:
*Glass Windows, Doors, Seals, Rubber Seals, Light Bulbs:
Models FD, FDL, FDD, FDDL.
90 Day Material Only. No Labor.
Two (2) Year Warranty on element only.
90 Day Material Only.
No labor second year.
No Labor.
In all cases, parts covered by extended warranty will be shipped FOB the factory after the first year.
Portable Carry In Products
Equipment weighing over 70 pounds or permanently installed will be serviced on-site as per the terms of this warranty. Equipment
weighing 70 pounds or under, and which is not permanently installed, i.e. with cord and plug, is considered portable and is subject to
the
following
warranty
handling
limitations.
If
portable
equipment
fails
to
operate
in
its
intended
manner
on
the
first
day
of
connection, or use, at APW Wyott's option or its Authorized Service Agency, it will be serviced on site or replaced.
From day two through the conclusion of this warranty period, portable units must be taken to or sent prepaid to the APW Wyott
Authorized Service Agency for in-warranty repairs. No mileage or travel charges are allowed on portable units after the first day of use.
If the customer wants on-site service, they may receive same by paying the travel and mileage charges. Exceptions to this rule: (1)
countertop warmers and cookers, which are covered under the Enhanced Warranty Program, and (2) toasters or rollergrills which have
in store service.
Exclusions
The following conditions are not covered by warranty:
*Equipment
failure
relating
to
improper
installation,
improper
utility
connection
or
supply
and
problems
due
to
ventilation.
*Equipment that has not been properly maintained, calibration of controls, adjustments, damage from improper cleaning
and water damage to controls.
*Equipment that has not been used in an appropriate manner, or has been subject to misuse or misapplication, neglect,
abuse, accident, alteration, negligence, damage during transit, delivery or installation, fire, flood, riot or act of god.
*Equipment that has the model number or serial number removed or altered.
If the equipment has been changed, altered, modified or repaired by other than an Authorized Service Agency during or after the
warranty period, then the manufacturer shall not be liable for any damages to any person or to any property, which may result from the
use of the equipment thereafter.
This warranty does not cover services performed at overtime or premium labor rates. Should service be required at times which
normally involve overtime or premium labor rates, the owner shall be charged for the difference between normal service rates and such
premium rates. APW Wyott does not assume any liability for extended delays in replacing or repairing any items beyond its control.
In all cases, the use of other than APW Wyott Authorized OEM Replacement Parts will void this warranty.
This equipment is intended for commercial use only. Warranty is void if equipment is installed in other than commercial application.
Water Quality Requirements
Water supply intended for a unit that has in excess of 3.0 grains of hardness per gallon (GPG) must be treated or softened before
being used. Water containing over 3.0 GPG will decrease the efficiency and reduce the operation life of the unit.
Note: Product failure caused by liming or sediment buildup is not covered under warranty.
“THE FOREGOING WARRANTY IS IN LIEU OF ANY AND ALL OTHER WARRANTIES EXPRESSED OR IMPLIED
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR PARTICULAR PURPOSES
AND CONSTITUTES THE ENTIRE LIABILITY OF APW WYOTT. IN NO EVENT DOES THE LIMITED WARRANTY
EXTEND BEYOND THE TERMS STATED HEREIN.”
9/05
7
Phone:
(214) 421-7366
Fax:
(214) 565-0976
Toll Free: (800) 527-2100
APW WYOTT
Website: www.apwwyott.com
729 Third Avenue
E-mail:
Dallas, TX 75226
info@apwwyott.com
8