SATA QUICKPORT INTERN mUlTI
Manual
Brief Instructions:
1. Switch off your PC and disconnect the power cord.
2. Open the PC case.
3. Remove the 5.25" mounting bay’s front bezel.
4. Insert the docking station into the mounting bay.
5. Attach the docking station from both sides inside the mounting bay using the included screws.
6. Connect the docking station’s SATA data cables to the respective SATA connectors on the mainboard (for further information also refer to your mainboard’s manual).
7. Connect the internal USB3.0 cable of the docking station to the respective available USB3.0 connector on the mainboard (for further information also refer to your mainboard’s manual).
8. Plug the power connector on the docking station’s back side to a matching power connector of your PSU.
Before its first use, the hard drive must be partitioned and formatted:
To format the hard drive, right click with the mouse on
My Computer
and then select
Manage
.
In Windows 7, select
Start
, right click on
Computer
and select
Manage
.
Select
Disk Management
drives you can format.
. Here you will find a list of the hard disks and
Right click on the desired hard drive and select the disk must still be first initialized.
Partition
. It is possible that
We recommend using the NTFS file system for Windows PCs. You can then reformat the hard disk.
Caution:
Ensure that you have selected the correct disk to format; any data on the selected hard disk will be lost during partitioning and formatting!
www.sharkoon.com
1264_mn_02