Aruba AP-377 Access Point Installation Guide

OC515010H

SPECIFICATIONS

Parameter

Model Number

Frequency

Gain

Polarization

VSWR

E-Plane 3 dB Beamwidth

H-Plane 3 dB Beamwidth

RF Connector

Power

Weight

Radome

Operational Temperature

Storage Temperature

Mounting

Performance

0C515010H

5150-5875 MHz

10 dBi

Linear, Horizontal

2.0:1

Omnidirectional

9.5°

Model Specific

10 Watts

0.18 Kg

Polycarbonate, UV, White

-30°C to +70°C

-40°C to +85°C

Connector Fixed or Mast

Mount Kit, Upright and

Inverted Orientation

Warranty and Liability

Laird Technologies warrants to the original purchaser that antenna products will remain free from defects in materials and workmanship for a period of twelve

(12) months from the purchase date. If any such defect is discovered with in the warranty period, Laird Technologies will at its sole option, repair or replace the

Product free of charge upon its return to the factory. This warranty applies only if the Product is used in a normal fashion, and is void if the Product is abused, disassembled, tampered with, used unreasonably, or fails as a result of normal wear. Furthermore, this warranty applies only to defects, which occur where the proper Product is selected as recommended by Laird Technologies and is used in the fashion recommended by Laird Technologies for the defective Product. THIS

WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, AND

IS LIMITED TO A PERIOD OF TWELVE(12) MONTHS FROM THE DATE OF ORIGINAL

PURCHASE. LAIRD IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES

OF ANY KIND. ANY WARRANTY EXTENDED HEREIN SHALL BE LIMITED TO THE

PRICE PAID TO LAIRD FOR THE DEFECTIVE PRODUCT. WHERE STATE OR LOCAL

LAW GOVERNS THE PERIOD OF WARRANTY, SUCH PERIOD SHALL CONTROL

Americas: +1.847 839.6907

[email protected]

Europe: +1.32.80.7866.12

[email protected]

Asia: +1.65.6.243.8022

[email protected]

www.lairdtech.com

SAFETY

Important Note : Please read all instructions carefully before attempting to install and use this product.

APPLICATION

The Laird Technologies’ 0C515010H is a 5150-5875 MHz omnidirectional, collinear, horizontally polarized array especially designed to compliment interior or exterior mounted wireless network systems. An integrated RF connector is imbedded in the antenna base cap for direct AP mounting. Special venting permits either upright or inverted orientation in outdoor locations.

LOCATION

For best results, mount the antenna and the associated AP unit near ceiling level or above exterior obstructions in a location near the center of the coverage area. A line-of-sight path between the antenna and active locations generally works best. Although 5.5 GHz signals penetrate cubical dividers, partitions, and interior walls with little attenuation, reinforced block walls, metal surfaces, and steel shelving may attenuate signals or cause multipath, a condition where reflected signals interfere with the primary signal path. Avoid mounting next to a column or vertical support that could create a “shadow zone” of reduced coverage to one portion of the room.

MOUNTING

The antenna mounts directly to a connector on the unit itself or It may also be pipe-mounted and fed with an inline RF connector when alternative positioning is required.

165-00007_AA