Rosen DS-HD0710-H11 Installation guide

Installation Guide
NOTICE OF INTENDED INSTALLATION AND USE
E
THE ROSEN MULTI-MEDIA NAVIGATION SYSTEMS CONTAIN AN INTERNAL VIDEO PLAYER, WHICH IS
NOT INTENDED FOR VIEWING BY THE DRIVER. THE VIDEO PLAYER IS DISABLED WHEN THE
VEHICLE IS IN MOTION THROUGH A CONNECTION TO THE PARKING BRAKE. THE INSTALLER OF
THIS PRODUCT MUST INSURE THE VIDEO DISABLE CONNECTION IS WORKING PROPERLY PRIOR TO
DELIVERY OF THE VEHICLE. IMPROPER INSTALLATION COULD DISTRACT THE DRIVER OR
INTERFERE WITH SAFE OPERATION OF THE VEHICLE, WHICH COULD RESULT IN SERIOUS INJURY
OR DEATH, AND COULD ALSO VIOLATE STATE AND/OR FEDERAL LAW.
DS-HD0710 Honda CR-V
ROSEN ENTERTAINMENT SYSTEMS DISCLAIMS ANY LIABILITY FOR ANY BODILY INJURY OR
PROPERTY DAMAGE THAT MAY RESULT FROM ANY IMPROPER OR UNINTENDED INSTALLATION
AND/OR USE.
BEFORE YOU START THE INSTALLATION, READ THIS GUIDE!
Rosen Multi-Media systems are the easiest-to-install OEM Radio replacement systems available today.
However, we strongly recommend reading this guide before starting the installation!
For additional technical tips, please visit
www.Rosendealercentral.com
1 - Make sure you have the tools you will need
These common items are needed to complete this installation:
· Digital multi-meter (DMM)
· #2 Phillips screwdriver
· Panel removing tools
· 1/4” drive sockets are often needed for dashboard and trim disassembly
· Torx or Allen-drive wrenches if they are used on any panels you will be removing
· A DVD or CD in good condition for testing the system
Standard installation parts you may need include wire, wire ties, wire crimp connectors or solder, electrical
insulating tape, and foam tape. Installation of aftermarket automotive electronics also often requires access to
special parts. It is a good idea to have a source for these common installation parts.
Rosen Entertainment Systems
Multi-Media Navigation System Installation Guide
Copyright 2008 all rights reserved
DS-HD0714 Rev A
Installation Guide Honda CR-V
2 - Inspect the vehicle and plan your work
CHECK THE BATTERY
Test the battery voltage to make sure it’s fully charged and inspect battery terminals for tightness and any corrosion. This
only takes seconds and can save hours of troubleshooting later.
New Vehicles RARELY have a fully charged battery. This can cause many system malfunctions.
3 – Turn the Vehicle OFF or Disconnect the Battery
TURN THE VEHICLE OFF BEFORE STARTING
Be sure to turn the vehicle OFF before starting, and keep the vehicle OFF until the installation is fully completed BEFORE
the vehicle is turned on.
Note: Failure to follow these instructions may cause the AIRBAG FAULT SENSOR to become enabled. Fault
Sensors which have been enabled will require the Dealer Service Department to reset them. Dealerships often
charge a significant fee to reset the Fault Sensor.
Keep the Vehicle OFF while the Radio is disconnected to avoid a potential Airbag Sensor Fault
4 – Remove the Interior Trim Components
You will need to remove the interior trim components prior to removing the factory radio. The following steps will help
guide you through this process.
Note: When removing the Interior Trim Components, use caution to prevent damage to the components. If you are
unsure about the removal process, consult the OEM Service Manual for additional instructions.
Note: Once the Interior Trim Components have been removed, be sure to inspect the clips for any damage.
Damaged part must be replaced before re-installation.
Step 1: Remove the Lower A/C
Trim Components
Step 2: Lower A/C Trim
Component Removed
Step 3: Remove the Upper Vent
Trim Component
Step 4: Unplug the Electrical
Connection
Use Caution. See the OEM Service Manual for additional information on the removal process
Rosen Entertainment Systems
Installation Guide
Copyright 2008 all rights reserved
DP-HD0714 Rev A
Page 2
Installation Guide Honda CR-V
5 - Remove the Factory Radio
You will need to remove the Factory Radio and prepare the Rosen Multi-Media unit for installation. The following steps
will help guide you through this process.
Note: Be sure to inspect all brackets and clips to ensure they were not damaged during the removal process. If any
brackets or clips were damaged, replace them prior to installation of the Rosen unit.
Step 1: Remove the Mounting
Screws
Step 2: Unplug the Electrical
Connections
Step 3: Remove the Factory
Brackets and Clips
Step 4: Reinstall the Factory
Brackets and Clips on
the Rosen Unit
Use Caution. See the OEM Service Manual for additional information on the removal process
6 – Locate the GPS Antenna, Optional XM Antenna and iPod Interface
You will need to mount the GPS and Optional XM Antennas on the exterior of the vehicle. And mount the iPod Interface
Connector in the vehicle. The following steps will help guide you through this process.
Note: Please route the GPS harness away from other power harnesses in the vehicle. This will help to ensure
optimum performance of the GPS system.
Note: Please locate the iPod interface module in an area which can be serviced in the future. The iPod cable is
intended to be a serviceable item, which plugs into the iPod/XM Interface Module.
Step 1: Mount the GPS and XM
antenna in a location on
the exterior of the Vehicle
Step 2: Connect the Optional XM
Tuner as shown below.
Mount the tuner inside the
vehicle
Step 3: Mount the iPod/XM
Interface module where it
can be serviced in the
future
Step 4: Locate the iPod interface
connector for use by the
end-consumer
It is the installer’s responsibility to ensure that the safety equipment in the vehicle is NOT
adversely affected by installation of this system. Ensure that the routing of the harnesses does
NOT obstruct airbags, SRS or other safety devices.
Rosen Entertainment Systems
Installation Guide
Copyright 2008 all rights reserved
DP-HD0714 Rev A
Page 3
Installation Guide Honda CR-V
7 – Connect and Install the Rosen Unit
You will need to make the Electrical Connections and install the Rosen Unit. The following steps will help guide you
through this process.
Note: Connect BRAKE WIRE (blue w/ white) to Emergency brake switch wire (ground when E-brake is
engaged). This insures video is disabled while vehicle is in motion.
Note: Use caution when locating the wire harnesses to be sure they will not be damaged when the Rosen unit is
installed.
Note: For vehicles with Dual Diversity Antenna, connect the White Antenna lead only, and protect the second
antenna lead from damage. For improved Radio performance, use an aftermarket dual diversity antenna adaptor.
Step 1: Remove transport
screws
Step 2: Connect the GPS,
Steering Wheel Control
and Power Connections
Step 3: Connect the iPod and
optional XM, Camera and
Backing Sensors
Step 4: Prepare the Vehicle side
connection harnesses
Insure that the video disable connection is connected as intended and working as designed!!!
Be sure to fully engage all connectors and prevent them from causing vibrating noises
8 – Re-Install Interior Trim Components
You will need to re-install the interior trim components. The following steps will help guide you through this process.
Note: When Installing the Interior Trim Components, use caution to prevent damage to the components. If you are
unsure about the removal process, consult the OEM Service Manual for additional instructions.
Step 1: Attach the Electrical
Connection and install the
Vent Trim
Step 2: Install the Lower Trim
Components
Step 3: Install the Upper Trim
Component
Step 4: Verify unit operation
Use Caution. See the OEM Service Manual for additional information on the installation process
Rosen Entertainment Systems
Installation Guide
Copyright 2008 all rights reserved
DP-HD0714 Rev A
Page 4
Installation Guide Honda CR-V
9 – Touch Screen Calibration and Installer Settings
The system was calibrated at the factory, however re-calibrate the system if the touch screen positions do not appear to
align with the buttons or icons.
Calibrate the Primary Touch Screen –
Note: There are TWO Calibrations for the Touch Screen in the Rosen unit. To Calibrate the Primary Touch Screen
Operation of the unit (Radio, DVD, BT etc) follow these steps:
Step 1: Select Main from any
Screen
Step 2: Select SETUP on the Main
Screen
Step 3: Select CONTROL SETUP
on the Setup Screen
Step 4: Select TOUCH SCREEN
and follow the onscreen instructions
Navigation Touch Screen Calibration –
Note: The Navigation Calibration Screen is only available for a short time, after the vehicle is switched ON… To
access the Navigation Calibration Screen, Select NAV as soon as the System Self Test has Finished.
Step 1: Start the Rosen Unit, and
wait for the Self Test to
completed
Step 2: Select NAV after the Self
Test has completed
Step 3: Touch the Screen quickly,
before it “Times Out.” If
needed, repeat Step 1.
Step 4: Follow the On-Screen
instruction to adjust the
calibration.
Touch the Screen to
Calibrate
Installer Settings Screen –
The Installer can enable and disable several option features of the Rosen Unit. To access the Installer Settings
screen, follow the steps below.
Step 1: Select Main from any
Screen
Step 2: Select the AUX Icon
Step 3: Touch the UPPER RIGHT
CORNER of the Screen
Enter “7253” and “OK”
Step 4: Enable or Disable the
desired functions
Note: The following settings can be changed from this screen:
1.
2.
3.
4.
5.
Enable the Power Antenna
Enable/Disable the Video Disable tied to the Parking Brake (Use for testing only)
Adjust the limit settings on the display backlight
Enable/Disable XM Radio Interface
Reset the Factory Settings
Rosen Entertainment Systems
Installation Guide
Copyright 2008 all rights reserved
DP-HD0714 Rev A
Page 5
Installation Guide Honda CR-V
10 – Pre-Delivery Test
You will need to fully test the system to ensure it is working and connected to the vehicle properly. The following steps will
guide you through this process.
Step 1: Initial Test
a. Reconnect the vehicle battery if needed
b. Start the vehicle (ensure that it is safe to do so)
c. Perform the following steps on the Multi-Media Systems to ensure proper operation:
• Turn the unit ON
• Select all available sources
o Select the Radio and test several stations
o Select the DVD and test playback of a disc
o Select the iPod and test music playback
o Select the XM tuner if equipped, and wait for XM Preview to start
• Test the Steering Wheel Controls
o If the vehicle is equipped, test all steering wheel controls
• Test the Backup Sensors
o If installed, test the sensors by placing a stationary object behind the vehicle (never test
the sensors by backing the vehicle into an object)
o Repeat this for each of the sensors
• Test the Navigation
o Select the Navigation and wait for the satellites to be located
o Confirm the location reported is your current location
• Eject the test disc
• Turn the vehicle off and wait for the unit to turn off
d. If the system does not function properly, reset the system by pressing and holding the reset
button located near the eject button
Step 3: Pre-Delivery Preparation
a. Start the vehicle (ensure that it is safe to do so)
b. Perform the following steps
• Calibrate the Navigation Touch Screen, if not already performed
• Calibrate the Primary Touch Screen, if not already performed
• Retest the Radio and general audio performance of the system
• Remove the protective films and clean the unit as needed
c. Place the Owner’s Information package in the glove compartment
Service and Optional Parts List
Part Number
Description
Part Number
Description
DP-HD0711
DP-HD0714
DP-1001
DP-1003
DP-1004
DP-1023
DP-1020
DP-1022
DP-1025
DP-1035
DP-1036
Quick Reference Guide
Installation Guide
Manual, Owner’s
Manual, Navigation
Remote Control
Pin, Stylus
Card, SD without maps
Antenna, GPS
Tuner, XMD1000 Kit
Camera, Cylinder W/Mount
Camera, License Plate
DP-HD0712
DP-HD0713
DP-1008
DP-1009
DP-1010
DP-1011
DP-1013
DP-1014
DP-1015
DP-1007
Harness, Main Interconnect
Harness, Steering Wheel Cntls
Harness, AUX Out
Harness, AUX IN
Harness, Sensors/Camera
Harness, Dolby 5.1/Amp
Harness, iPod/Interface Box
Harness, XM Radio Interface
Harness, iPod Replacement
Harness, USB Adaptor
Rosen Entertainment Systems
Installation Guide
Copyright 2008 all rights reserved
DP-HD0714 Rev A
Page 6
Installation Guide Honda CR-V
Wiring diagram
Rosen Entertainment Systems
Installation Guide
Copyright 2008 all rights reserved
DP-HD0714 Rev A
Page 7
Installation Guide Honda CR-V
www.RosenEntertainment.com
Rosen Entertainment Systems
Installation Guide
Copyright 2008 all rights reserved
DP-HD0714 Rev A
Page 8