Cobra AirWave Product information guide

TM
Printed in China Part No. 480-933-P Version A
Waterproof Bluetooth®
Speaker
CWABT310_MANL.indd 1
CWA BT310
Product
Information Guide
2/6/14 11:10 AM
CARE AND MAINTENANCE
PRODUCT FEATURES
REAR VIEW
FRONT VIEW
LED Light
Speaker Mesh
Microphone
(hidden)
Loudspeakers
Rubber Sleeve
SIDE VIEW
TOP VIEW
Volume Down
Volume Up
Audio In Jack
USB Jack
Water-Tight Cover
(Shown Open)
Multi-Function Key
1. Never try to disassemble or service the product by yourself.
Opening the unit will damage the seals that make it waterproof!
2. Keep the Cobra Airwave™ Box and accessories out of
reach from children.
3. Do not expose the Cobra Airwave™ Box to temperatures
above +55° C (+131° F). If the product is operated in extreme
hot or cold temperature, the battery capacity is reduced.
Use it at room temperature for maximum battery capacity.
4. The Cobra Airwave™ Box is waterproof and it can be
cleaned by rinsing off or with a soft cloth and mild detergent.
5. Although the product is IPX7 compliant, it is not designed
to be used for extended periods of time floating in water.
Please make sure the rubber cover over the jack is closed
tightly while around water. Retrieve and dry if the speaker is
dropped in water.
CHARGING
The Cobra Airwave™ Box has a built-in Li-ion battery, so it
can be used without connecting to a power supply.
To charge the battery, follow these steps:
1. Connect the micro USB connector of the supplied USB
cord to the Cobra Airwave™ Box micro-USB input.
2. Plug the USB full-size connector into a computer USB
port, common USB type AC charger (DC 5V, 500mA) or
any USB power source.
• When the device is charging the LED status indicator will
be RED. When fully charged the RED status indicator
LED will go off.
• A full charge will last for up to 10 hours of normal use.
2
CWABT310_MANL.indd 2-3
3
2/6/14 11:10 AM
OPERATION
Turning the Cobra Airwave™ Box On or Off
Multi-Function Key
Press and hold the Multi-Function Key for 2 seconds to
turn On. The blue LED will turn on and blink. "Power On"
will sound from the speaker. Press and hold the MultiButton for 3 seconds to turn Off. The red LED will turn on
then turn off. "Power Off" will sound.
Pairing the Cobra Airwave™ Box with a smartphone
or any Bluetooth® enabled music device
To use the Cobra Airwave™ Box with any Bluetooth®
enabled smartphone or media device, you must first pair
the device to the Cobra Airwave™ Box. Once they have
been paired for the first time, the phone or media device
will automatically re-connect to the Cobra Airwave™ Box
when the power is turned ON and Bluetooth® is enabled
on your device. For additional information, see the
operation manual for your smartphone or media device.
4
CWABT310_MANL.indd 4-5
Pairing with smartphone
1. Turn Bluetooth® on in your settings menu. It will begin
searching for any Bluetooth® device within range.
2. With power off, press and hold the Multi-Function
Key for 5 seconds (keep holding when you hear
"Power On" after 2 seconds) and the blue and red
LEDs will alternately blink. "Pairing" will sound.
3. You will see the Cobra Airwave™ Box on the devices
list on your phone. Select the Cobra Airwave Box
to pair. Once connected, the blue LED light will blink
on the Cobra Airwave™ Box and "Successful" will
sound.
Playing music
To play music through the Cobra Airwave™ Box, first pair
the devices. Music played on the Bluetooth® enabled
smartphone or other Bluetooth® device will be played
through the Cobra Airwave™ Box.
For smartphones and some other Bluetooth® devices
pressing the Multi-Function Key will cause the paired
device to start playing. Pressing the Multi-Function Key
again will pause the audio.
The audio can also be started and paused using the
smartphone controls.
5
2/6/14 11:10 AM
ADJUSTING VOLUME
QUICK REFERENCE GUIDE
To increase or decrease the Cobra Airwave™ Box volume,
press the "+" or "–" buttons.
Volume Down
Mode
Controls
Action
Functions
Press & Hold >2s
Turn Power On/Off
Press & Hold >3s
Pair to Bluetooth®
(from power off)
Press
Play/Pause Music
+
Press
Volume Up
–
Press
Volume Down
Press
Answer Incoming
Call
+
Press
Volume Up
–
Press
Volume Down
Press
End Call
Power
Volume Up
Music
•
™
Volume can be adjusted with Cobra Airwave Box
controls or the paired Bluetooth® device connected
to the Cobra AirWave™ Box.
Pairing a new device with the Cobra Airwave™ Box
1.
2.
3.
Use the smartphone or paired devices' Bluetooth® settings menu to unpair the Cobra Airwave™ Box.
Press and hold the Multi-Function Key for 3 seconds to turn off the Cobra Airwave™ Box.
Follow the steps under "Pairing with smartphone" to complete pairing.
Phone
Answer incoming call/hang up
If a call comes through in stand by mode or while playing
music, click on the Multi-Function Key to answer the call.
To hang up, press the Multi-Function Key again.
6
CWABT310_MANL.indd 6-7
7
2/6/14 11:10 AM
FCC & INDUSTRY CANADA STATEMENT
For Products Purchased in USA:
NOTE: This device complies with part 15 of FCC rules: Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received including interference that may cause undesired operation.
CAUTION: Modifications or parts not approved by Cobra Electronics Corporation may violate
FCC Rules and void authority to operate this equipment.
For Products Purchased in Canada:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry
Canada. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil
ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the
user’s authority to operate the equipment.
This equipment is portable device. The output power of this device is less than 20mW. The SAR
test is not required.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
8
CWABT310_MANL.indd 8-9
PRODUCT SERVICE QUESTIONS
For any questions about operating or installing this new Cobra product, or if parts are
missing…PLEASE CALL COBRA FIRST…do not return this product to the store.
For Products Purchased in the U.S.A.
If your product should require factory service, please call Cobra first before sending your
radio. This will ensure the fastest turn-around time on your repair. You may be asked to
send your radio to the Cobra factory. It will be necessary to furnish the following to have
the product serviced and returned.
1)
For warranty repair include a copy of the original sales receipt. If you send the original receipt, it cannot be returned.
2)
Send the entire product.
3)
Enclose a detailed description of the problem along with the name and address of where the product is to be returned.
4)
Pack radio securely to prevent damage in transit. If possible, use the original packing material.
5)
Ship prepaid and insured by way of a traceable carrier such as United Parcel Service (UPS) or Priority Mail to avoid loss in transit to Cobra Factory Service:
Cobra Electronics Corporation
6500 West Cortland Street
Chicago, Illinois 60707 U.S.A.
6) If the radio is under warranty, it will be repaired or exchanged depending on
the model.
Please allow approximately three to four weeks before contacting Cobra for status. If the
product is out of warranty, a letter will automatically be sent informing you of the repair charge
or replacement charge. If you have any questions, please call 773-889-3087 for assistance.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for product service information.
9
2/6/14 11:10 AM
LIMITED ONE-YEAR WARRANTY
For Products Purchased in the U.S.A.
Cobra Electronics Corporation warrants that its products and the component parts thereof, will
be free of defects in workmanship and materials for a period of one year from the date of first
consumer purchase. This warranty may be enforced by the first consumer purchaser, provided
that the product is utilized within the U.S.A.
Cobra will, without charge, repair or replace, at its option, defective products, products or
component parts upon delivery to the Cobra Factory Service department, accompanied by proof
of the date of first consumer purchase, such as a duplicated copy of a sales receipt.
You must pay any initial shipping charges required to ship the product for warranty service, but
the return charges will be at Cobra’s expense,
if the product is repaired or replaced under warranty. This warranty gives you specific legal
rights, and you may also have other rights which may vary from state to state.
Exclusions: This limited warranty does not apply: 1) To any product damaged by accident; 2) In
the event of misuse or abuse of the product or as a result of unauthorized alterations or repairs; 3)
If the serial number has been altered, defaced, or removed; 4) If the owner of the product resides
outside the U.S.A.
All implied warranties, including warranties of merchantability and fitness for a particular purpose
are limited in duration to the length of this warranty. Cobra shall not be liable for any incidental,
consequential or other damages; including, without limitation, damages resulting from loss of use or
cost of installation.
Some states do not allow limitations on how long an implied warranty lasts and/or do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitations
may not apply to you.
For Products Purchased Outside the U.S.A.
Please contact your local dealer for warranty information.
Trademark Acknowledgement
Cobra®, Nothing Comes Close to a Cobra®, and the snake design are registered trademarks of
Cobra Electronics Corporation, USA. Cobra Airwave™ and Cobra Electronics Corporation™ are
trademarks of Cobra Electronics Corporation, USA.
The Bluetooth® word mark is a registered trademark owned by Bluetooth SIG, Inc. and any use
of such marks by Cobra Electronics Corporation is under license.
10
CWABT310_MANL.indd 10-11
©2014 Cobra Electronics Corporation
6500 West Cortland Street, Chicago, IL 60707
www.cobra.com
11
2/6/14 11:10 AM