Air-O-Swiss AOS W490 Technical data

AOS W490
Illustrations (4 – 8)
Gebrauchsanweisung (9 – 14)
de
Instructions for use (15 – 20)
en
Instructions d’utilisation (21 – 26)
a
fr
Istruzioni per l’uso (27 – 32)
a
it
3
1
2
3
4
5
6
7
8
9
4
10
11
12
13
14
15
16
17
18
5
19
20
21
> 1 L HOT WATER
22
23
24
25
26
27
6
28
29
30
31
32
33
34
35
7
36
8
37
38
en
Instructions for use
15
Foreword
Congratulations on choosing the Air Washer W490!
en
Proper use:
The appliance must only be used for the humidification and
cleaning of the air indoors.
The W490 features the following innovations:
• One season of water quality maintenance with the Ionic
Silver Stick
• Automatically switches off if the water level is too low
• Digital Display with Touch-Panel
• Built-in hygrostat
• Automatic display dim function (ADF), Day/Night
• Maintenance reminders
• Cleaning Mode
Did you know that air that is too dry
• dries out mucous membranes and additionally causes
chapped lips and stinging eyes?
• promotes infections and sicknesses of the respiratory
passages?
• leads to a lack of energy, exhaustion and concentration
weakness?
• burdens pets and room plants?
• encourages dust development and the electrostatic
charge of synthetic textiles, carpets and synthetic
flooring?
• damages wooden fixtures, especially hardwood floors?
• puts musical instruments out of tune?
Description of the unit
The Air Washer W490
• washes and humidifies the air without filter mats
• includes an innovative water quality maintenance
system (ISS)
• runs with little noise at two operation modes
• is suitable for room sizes up to 50 m2
• is manufactured with high-quality components with
a long lifespan
In the inside of the Air Washer, special humidifier discs
rotate through a water bath and in doing so clean the
air streaming by of impurities in a natural way – as the
air is washed clean by the rain in nature. Air humidification occurs following the self-regulating principle of cold
evaporation. Therefore the Air Washer creates optimum air
moisture, without additional control units being necessary.
Humidifier discs
The honeycomb structure of the humidifier discs allows
proven release of large amounts of water into the air. The
unit cleans the air with nature as its model. In addition, the
unit also guarantees filtering of pollutants as well as pollen
and animal hair from the air.
Ionic Silver Stick (ISS) (34)
®
The Ionic Silver Stick utilizes the antimicrobial property of
silver and provides one season of optimum water quality
maintenance in all AIR-O-SWISS and BONECO humidifiers.
The ISS begins working as soon as it comes into contact
with water – even if the unit is switched off. The ISS is
intended exclusively for use in humidifiers.
Safety instructions
• Prior to putting the Air Washer into operation, read
the instructions for use thoroughly and retain them
well for later consultation.
• Only use the Air Washer in living areas and within
the technical data specified. Unintended use can be
a danger to health or life.
• Children cannot recognize the danger in handling electric appliances. Therefore always supervise children
who are near the Air Washer (5).
• Those unfamiliar with the instructions for use as well
as children and people under the influence of medicine,
alcohol or drugs may not operate the unit, or only operate it under supervision.
• If the unit is knocked over so that water leaks, the
power plug must be unplugged immediately. The unit
must then be dry for at least 3 hours before the power
plug may be plugged in again.
• Do not add any additives such as essential oils directly
into the water tank or the water base. These additives
will damage your appliance! Appliances that are damaged by additives are excluded from the warranty.
In the instructions for use, special safety instructions are
indicated with the following symbols:
Warning
Risk of injury by electric shock.
Always unplug the power plug before
• servicing and cleaning
• moving the unit
• emptying the water
Caution
Damage to the Air Washer or material
damage, e.g. due to leaking water.
16
Unpacking (1 – 3)
• Remove the Air Washer carefully from the packaging;
the top assembly is only placed on the bottom base
loosely.
• Use the original packaging for storage if you do not use
the Air Washer the whole year.
• All packaging components consist of environmentally
friendly materials and can be disposed of with the
appropriate local waste management.
Positioning (4 – 7)
Check data regarding the power supply on the rating plate.
Place the Air Washer on the floor or on a flat, dry surface
in the room.
• The rating plate is located on the underside of the
bottom base (4).
• Remember to ensure easy accessibility and sufficient
room for servicing and cleaning the Air Washer.
Filling with water (8 – 10)
Only fill the water tank with fresh, cold tap water.
Do not pressurize the water tank, e.g. by filling
it with carbonated mineral water. Do not add essential oils or fragrances to the water; the plastic
material could possibly be discolored or damaged. Close the screw cap completely to prevent
leakage from the water tank.
Putting into operation (11 – 15)
Connect the Air Washer to the mains (signal tone) and press
button A (12). The digital display comes on and shows the
current humidity. The Air Washer is in Normal mode.
The Air Washer
• operates especially quietly in night mode (Point G,
Symbol «L» Low)
• achieves maximum humidity output (Point G,
Symbol «H» High) in normal mode
To switch off, press button A.
Operating W490
A) Switching on/off
Pressing button A switches the appliance on. Pressing it
again switches the appliance off. Button A is also used
to start the Cleaning mode. See section «Cleaning mode»
(20 – 28).
B) Setting humidity level
The appliance is fitted with a hygrostat. This measures the
relative air humidity and automatically switches the appliance off when the desired value is reached. When switching
the unit on, the desired value is preset to 55%.
The desired value can be adjusted in steps of 5% by pressing button B. While selecting the humidity output, the
desired value is blinking. The word DESIRED appears on
the display (F). The setting for the relative humidity ranges
from a minimum of 30% to a maximum of 70% relative
humidity or «CO» continous mode. A relative humidity
of between 40 and 60% is recommended. After a few
seconds, the display automatically changes to show the
current value (CURRENT) (F). Upon reaching the desired
relative humidity, the unit automatically switches off
(display shows DESIRED and CURRENT) (F). If the desired
relative humidity falls, the appliance automatically switches
on again.
Quick display of current relative humidity
When the unit is switched off (mains cable is connected),
the current relative humidity can be shown in the display
by briefly pressing one of the B buttons. This display automatically goes out after a few seconds.
C) Changing the output level
The Air Washer can be operated on two output levels.
Press button C to select between output levels Low «L»
(night-time mode) and High «H» (Normal mode). The chosen
output level is shown in the display by symbol G.
17
en
D) Change Ionic Silver Stick (ISS)
en
The letter D in the display indicates that the Ionic Silver
Stick (ISS) must be changed. The symbol remains visible
until both B buttons are pressed simultaneously and held
down for approx. 5 seconds.
E) Cleaning the appliance
The letter E in the display indicates that the appliance must
be cleaned. The symbol appears as long as the cleaning
mode is activated or both B buttons are pressed simultaneously and held down for approx. 5 seconds.
F) Current/Desired Display
If DESIRED appears on the display, the value in % next to it
signifies the desired relative humidity, i.e. the desired value
is shown. If the display shows CURRENT, then the current
relative humidity is shown.
H)Automatic switch-off
«Tank empty»
The water quantity is easy to see thanks to the transparent
water tank. The display on the appliance also shows when
the unit should be refilled with water. If the water level falls
below the minimum quantity, the appliance automatically
switches off. A red blinking symbol (H) appears on the
display. When water is added, symbol H goes out and the
appliance continues operating.
Warning: When lifting the upper part off the base, the appliance also switches off. In this case, the red blinking F
symbol will also appear on the display. Only when the upper
part is replaced on the base does symbol H go out and the
appliance continues operating.
18
Cleaning the Air Washer (18 – 19)
• Regular cleaning is essential for hygienic, fault-free
operation, despite the Cleaning mode.
• Recommended cleaning intervals depend on air
and water quality as well as operating time.
• The Air Washer can easily be taken apart for
cleaning without tools.
The Air Washer must be emptied completely and
cleaned if the unit filled with water has not been
in operation for longer than a week.
Remove the ISS from the bottom base before
cleaning (20).
Only use CalcOff for decalcification and cleaning
of the product. Damage that is caused by the
use of other cleaning agents is not covered by
the warranty.
Cleaning mode (20 – 28)
Cleaning mode enables simple cleaning and decalcification
of the humidifier discs and the water tank.
Humidification does not take place when the appliance is in
Cleaning mode. The fan remains deactivated and only the
humidifier discs rotate.
Before switching the appliance to Cleaning mode, the water
base must be filled with hot water and the decalcification
agent CalcOff (21). Pressing and holding button A for 5
seconds switches the appliance to Cleaning mode (22).
Cleaning mode is shown in the display by flashing symbol
E (23). The value «1h» flashes in the display. Button B can be
used to change the cleaning period from 1 to 9 hours, depending on the level of soiling (23). After 3 seconds without
further input, the set value is taken as the «desired value»
and flashing display F changes back to «CURRENT». The
cleaning period is now permanently displayed and switches to minutes when the time remaining falls below the
1 hour mark. The cleaning period can be changed at any
time by pressing button B. At the end of the cleaning period,
the display shows the value «0h» and cleaning symbol E
flashes faster (24). Pressing button A ends the Cleaning
mode and switches off the appliance (24). The water base
must now be emptied of the CalcOff and rinsed (25–27)
(see section «Cleaning the water tank and bottom base»).
The next time the appliance is switched on, it will operate
in normal mode.
Do not clean the soiled disc package in the dishwasher!
Cleaning the water tank and water base –
every 2 weeks (29 – 34)
• Remove deposits from the water base with a plastic
or wooden brush and a diluted commercial dish detergent.
• Put the Air Washer back together after cleaning in the
opposite order.
Cleaning the housing –
once or twice annually (35)
• First clean the housing with a damp cleaning rag and
wipe it dry; if necessary, use plastic cleaning agent.
• Wipe out the inside of the housing top assembly with
a damp cleaning rag.
Troubleshooting
Technical data
Problem
Possible cause
Was tun
No function
Power cord not plugged in
Plug the power cord into the socket.
Dragging noise
Disc package not inserted in the bottom base
correctly
Insert the disc package correctly
No humidification/
Fan does not work
Disc package not inserted in the bottom base
correctly
Insert the disc package correctly
No water in the bottom base
Refill water tank
Cleaning mode activated
Switch off unit and switch on again
Storage
Repairs (36 – 38)
Empty water tank. Clean Air Washer as described and
allow it to dry completely. Remove screw cap from the
water tank completely and store separately to preserve
the seal. Store Air Washer preferably in the original
packaging in a dry location that is not too hot.
All further repairs may only be carried out from professionals or the service department. This also applies
to a faulty power cord. Through improper repairs, considerable danger for the operator can result and warranty
claims lapse.
Disposal
Warranty
Pass the outdated Air Washer onto your specialized retailer
for professional disposal. You can find out about further
disposal possibilities from your municipality.
Spare parts and accessories
You can purchase spare parts from specialized
retailers and replace them on the Air Washer
yourself. Only original parts from the manufacturer can be used.
Warranty stipulations are determined by our national
representation.
• Contact your dealer with confidence if there is a
problem with the Air Washer despite strict quality
control.
• It is absolutely necessary to present proof of purchase for warranty validity.
Electrical voltage
230 V / 50 Hz
Power consumption
18 W
Humidity output up to
300 g/h
Suitable for room sizes up to 50 m2 / 125 m3
Water capacity
7 Liter
Dimensions (mm)
336 x 323 x 407
Weight (empty)
6.0 kg
Operating noise
< 25dB (A)
Accessories
Ionic Silver Stick (ISS) A7017
CalcOff A7417
Legal information
The unit is CE compliant and adheres to the following guidelines:
• 2006/95/EG for electric safety
• 2004/108/EG for electromagnetic compatibility
• 2002/95/EG for the restriction of the use of certain
hazardous substances in electrical and electronic
equipment
• 2002/96/EG concerning waste electrical and
electronic equipment
Subject to technical modifications. The instructions for use
are protected by copyright.
19
en
en
20
AIR-O-SWISS is a registered trademark of PLASTON Group, Switzerland
37402-00
www.airoswiss.com