Manual for Digital Thermometer DT-150
Remove Battery Protection Seal before using.
Press button to turn “ON”. The temperature sensor is located at the pointed end of the probe.
The thermometer display shows “- -“ if:
•
The sensor is reading temperatures higher or lower than the specified range.
•
The sensor has been damaged, perhaps by overheating.
•
The battery voltage is low.
Directions
•
Insert probe.
•
When measuring liquid, the sensor tip should be immersed 1” or more to obtain the quickest response time and most accurate reading.
•
Not recommended for ambient use.
•
Do not submerge thermometer in water; wipe with damp cloth only.
Replace the battery by removing the housing lid. Replacement batteries are LR44, 357 or A-76.
Features
•
F° / C° Switch
•
Data Hold
•
Water Resistant
•
Drop Resistant
•
On/Off Switch
•
Protective Sheath with Pocket Clip
•
3 minute Auto Power Off
•
¼” Digits
•
Accuracy +/- 2°F / 1°C
•
Range : -40° - +300° F / -40° - +150° C
•
Battery included