WayteQ GPS Navigation
X620
User Manual
Version 1.0
Precaution and Notice
•
The PND is used only as a navigation aid. It is not for precise measurement of direction, distance, location or
topography.
•
The user must follow all traffic signs and local regulations along the roads.
GPS satellite signals cannot pass through solid materials (except glass). When you are inside a tunnel or building,
GPS position is not available.
•
A minimum of 4 GPS satellite signals are needed to determine current location.
Signal reception can be affected
by situations such as bad weather or dense overhead obstacles (e.g. tall buildings).
•
Other wireless devices in the vehicle might interfere with the reception of satellite signals and cause the reception
to be unstable.
•
When you get out of the car, do not leave your PND on the dashboard or subject to direct sunlight. The
overheating of the battery may cause malfunctions and/or dangerous conditions.
•
For your own safety, do not operate the controls of the PND while driving. Do not mount where the driver’s field of
vision is blocked.
Basic Introduction
1.1 Overview
A.
Power
B. Memory Card slot
C.
Mini USB
D. Light Sensor
E.
Reset
F. Battery
G.
Speaker
Once the card is installed, it cannot be removed during the operation of the device.
If you need to remove the card, switch the unit off first, push the card in and it will eject from the slot.
1.2 Charging by Car Charger
Caution: To protect your device against suddenness, please connect the car charger only after the car engine has been
started.
1.3 USB Cable
The USB cable is provided for system upgrades and battery charging .
This USB cable will work on the PC either with
Microsoft Active Sync® or as a mess storage media. You can select the mode in the “Setting-USB” menu.
1.4 Install the Car Cradle and Bracket
Take off the protection film on the bottom of the suction. Then put the bracket onto a suitable location of your windscreen
or side window and make sure the suction or windscreen is clean without water or any dirty things . Never place the stand
where the driver's field of vision is blocked.
Install the device bracket into the car cradle, after adjust of the angle and direction of the PND, rotate the screw to lock
onto windscreen.
1.5 AC-DC Charger optional
Main Functions Introduction
1. Starting Up and Power Off
Long press the “Power” button to power the equipment on and you can see the main interface as below :
Long press the “Power” button again to enter into the below interface :
Tap the “Power off” button to turn the unit off.
Tap the “Sleep” button to enter a suspend state and the system stops operation.
Tap the “Cancel” button to turn back to the screen.
2. GPS Navigation
Double tap the “GPS” icon to start navigation program.
3. Media
Tap the icon "Media" on the main menu and enter into the below interface :
3.1 Music
Tap the icon “Music” on the media menu and enter into the following interface .
A.
Return to the Media menu
B. Select desired music file
C.
Volume control
D. Stop
E. Next
F. Pause / Play
G.
H.
I.
Previous
Speed Bar
Equalizer
J. Play mode
Double tap icon “
Tap the icon “
delete , tap the icon “
” to choose music file .
“ for single selection , tap the icon “
”
“ to select all , tap the icon “
“
for single
to delete all .
3.2 Photo
Tap the "Photo" icon on the media menu and tap the icon “
the following interface .
“ to select photo files , double tap the photo file to see
A.
Return to the Media menu
B. Select photo file
C.
Slide mode
D. Rotate
E. Zoom in
F. Zoom out
G. Next
H.
Previous
3.3 E-book
Tap the "EBook" icon on the media menu , then tap the "
enter into the following interface .
A.
Return to the Media menu
B. Bookmark list
C.
Bookmark
D. Theme and font
E.
Down
F. Up
" icon to choose Ebook files , double tap the file and
G.
Select EBook files
3.4 Video
Tap the icon "Video" on the media menu , then tap the “
“ icon to choose video files , and double tap the file
and enter into following interface .
A.
Return to the Media menu
B. Volume
C.
Select video file
D. Stop
E. Next
F. Pause/play
G.
Previous
H.
Speed bar
Tips:
Tap NEXT button to recycle the movie.
Double tap the screen, it will display in full screen, double tap the screen again, it will return to original playing size.
3.5 Flash
Tap the icon “ Flash ” on the media menu and enter into the following interface .
A.
Volume
B. Return to the Media menu
C.
Select flash file
D. Stop
E.
Play / Pause
F. Speed Bar
4. Games
Tap the icon "Games" on the main menu and double tap the game to run it .
5. Tools
Tap the icon "Tools" on the main menu and double tap the tool program to run it .
6. GPS Info
Tap the "GPS Info" icon and the unit will show the detail information of GPS satellites.
7. Setting
Tap the icon "Setting" on the main menu and enter into the following interface .
Tips : after make any changes of setting , tap "
" to save the change .
7.1 Volume
Tap the icon “Music” on the media menu and enter into the following interface .
Choose “ Music “ files to be background sound when unit is power on .
7.2 Backlight
Tap the "Backlight" icon and enter into the following interface .
Tap “Left-side” or “Right-side” button to select the duration of automatically powering off the backlight.
7.3 Language
Tap the "Language" icon and choose the language .
7.4 Date and Time
Tap the icon "Date Time" and enter into the following interface to set date , time and time zone .
7.5 Calibration
Tap the " Calibration " icon and enter into the following interface .
Tap the icon "OK" to adjust the touch screen.
7.6 Factory Reset
Tap the " Factory Reset " icon and enter into the following interface . Tap the icon “ OK “ to load factory default setting .
7.7 System Info
Tap the "Sys Info" icon and enter into the following display interface .
7.8 USB
Tap the icon “USB” to set the USB working mode .
7.9 Nav Path
Tap the "Nav Path" icon and enter into the following display interface .
When you have several Navigation maps in the device, if you choose the "Navigation" icon , you can set up one of
Navigation maps ( navigation program files ) , and select the Auto Run Navigation , next time when tapping the “GPS” icon
on the main menu, the device will run the selected Navigation software automatically .
This document is for guidance only and does not form part of any contract, and may be subject to change
without notice
Technical Specification
•
96.5 * 75.6 * 13.5 mm (reference)
•
SiRF Atlas IV dual core, ARM11 CPU 500MHz Processor
•
WinCE 6.0 system
•
SDRAM : 64MB
•
Flash Memory : 2GB
•
External Memory :
•
SiRF GPS up to 40 channels
•
USB2.0 high speed , support Active Sync. Or Mass Storage Modes
•
3.5 inch , 320 * 240, 65,536 possible colors, Digital TFT LCD with 4-wire resistive touch panel , 200 lumen
•
Embedded Antenna
•
Light Sensor
•
Removable Li Battery , 820mAh ( compatible Nokia BL-5C )
•
External TMC receiver support
•
Animation Menu Style
•
Audio Player : MP3* ( optional )、OGG、WMA、FLAC、AAC、WAV ( PCM, ADPCM )
•
Video Player : AVI ( XVID/DivX3.11 )、FLV、WMV、ASF、3GP、MP4* ( optional )
•
Photo Viewer : JPG, GIF, BMP, PNG
•
E-book : TXT
•
Flash Player : SWF
•
Games : Othello,Russia block
•
Tools : Calculator, Unit Converter, GPS Info
Micro SD card support up to 8GB
This specification is for reference only and does not form part of any contract, and may be subject to
change without notice .