Anybus | AB7009 | Installation Guide | 405-2574-ABC-LON-RTU slave Installation Leaflet 1_0

Pocket Guide
LonWorks to Modbus RTU
Gateway
LED
No.
1.
Description
Color
Function
Service
Green
Flashing Green:
This node has an application but is not
yet installed in a network (unconfigured).
Rev 1.0
DOC. ABC-LON-RTU SLAVE
Off:
This node is configured and installed in a
network.
Solid Green:
This node is unconfigured and
applicationless. Indicates errors detected
by the Neuron Self-Test routine.
2.
Wink
Red
Off:
Normal state
Flashes Red:
A wink command is received on the
LonWorks network.
3.
Not used
-
-
4.
Module Status
Green/Red
Solid Green:
The module has been initiated correct
and is working ok.
Flashes Red:
Software error. Restart the module.
Solid Red:
A hardware error has occurred.
5.
Modbus activity
Green/Red
Solid Red:
at start and if no Modbus messages have
been received for more than 5 sec.
Solid Green:
after receiving correct Modbus message
and correct start-up
6.
Config error
Green/Red
Solid Green:
Normal state
Flashes Red:
No configuration saved in the gteway
HMS Industrial Networks
Germany
Japan
Sweden
U.S.A
+49 - 721 - 96472 - 0
+81 - 45 - 478 - 5340
+46 - 35 - 17 29 20
+1 - 773 - 404 - 2271
[email protected]
[email protected]
[email protected]
[email protected]
Installation and Startup Summary
This installation instruction requires that the LW-tool Modbus
configuration program is installed on the computer aimed for
the configuration of the Gateway. (LW-tool Modbus is available
on the Gateway LMS Resource CD or the website of HMS,
www.hms-networks.com)
1.
2.
3.
4.
5.
6.
7.
8.
Snap the Gateway on to the DIN-rail
Connect the LonWorks cable
Connect the serial RS232/422/485 cable
Connect a PC using the Configuration cable
Connect the power cable to the Gateway
Start the LW-tool Modbus program on the computer
Apply 24VDC power to the Gateway
Configure the Gateway with LW-tool, see separate
instructions for LW-tool Modbus configuration program
Pin
Description
1
+24V DC
2
GND
Pin
Description
1
+5V
ü
2
RS232 Rx
ü
3
RS232 Tx
ü
4
Not connected
5
Ground
6
RS422 Rx +
ü
7
RS422 RX -
ü
8
RS485 +/RS422 Tx+
ü
ü
9
RS485 -/RS422 Tx-
ü
ü
Pin
Description
1
Shield
2
-
3
-
4
Net B
5
Net A
RS232
ü
RS422
RS485
ü
ü
ü
ü