Samsung DJ68-00369L User manual

Vacuum Cleaner
user manual
✻ Before operating this unit, please read the instructions carefully.
✻ For indoor use only.
English
imagine the possibilities
Thank you for purchasing a Samsung product.
To receive a more complete service,
please register your product at
www.samsung.com/register
DJ68-00532J-00.indd
1
2010.1.28
5:7:9 P
safety information
Safety information
WARNING
WARNING
• Before operating the appliance, please read this manual thoroughly and
retain it for your reference.
• Because these following operating instructions cover various models,
the characteristics of your vacuum cleaner may differ slightly from those
described in this manual.
CAUTION/WARNING SYMBOLS USED
Indicates that a danger of death or serious injury exists.
WARNING
Indicates that a risk of personal injury or material damage exists.
caution
OTHER SYMBOLS USED
Represents something you must NOT do.
Represents something you must follow.
Indicates that you must disconnect the power plug from the socket.
02_ safety information
DJ68-00532J-00.indd
2
2010.1.28
5:7:9 P
safety information
Important safeguards
1. Read all instructions carefully. Before switching on, make sure that the voltage
of your electricity supply is the same as that indicated on the rating plate on the
bottom of the cleaner.
2. WARNING : Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. Do not use the vacuum cleaner without a dust bin.
Empty the dust bin before it is full in order to maintain the best efficiency.
4. Slide to the Stop(or Min)position before inserting a plug into the electrical outlet.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts.
Keep the vacuum cleaner away from stoves and other heat sources. Heat can
deform and discolour the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may
damage the cleaner parts. Do not stand on the hose assembly. Do not put
weight on the hose.
Do not block the suction or the exhaust port.
7. Switch the vacuum cleaner off on the body of the machine before unplugging
from the electrical outlet. Disconnect the plug from the electrical outlet before
changing the dust bag or dust container. To avoid damage, please remove the
plug by grasping the plug itself, not by pulling on the cord.
8. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
9. Children should be supervised to ensure that they do not play with the appliance.
10.The plug must be removed from the socket outlet before cleaning or maintaining
the appliance.
11.The use of an extension cord is not recommended.
12.If your vacuum cleaner is not operating correctly, switch off the power supply and
consult an authorized service agent.
13.If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
14.Don’t carry the vacuum cleaner by holding the hose.
Use the handle on the vacuum cleaner set.
15.Unplug the cleaner when not in use. Turn off the power switch before unplugging.
safety information _03
DJ68-00532J-00.indd
3
2010.1.28
5:7:9 P
contents
assembling the cleaner
05
operating the cleaner
06
maintain tools and filter
08
06 ON/OFF Switch
06 Power Cord
07 Power-Control
08
09
10
11
12
13
13
14
Using accessory
Maintain floor tools
Emptying the dust bin
When to clean the dust pack
Cleaning the dust pack
Cleaning the motor protection filter
Cleaning the outlet filter
Change the battery (option)
troubleshooting
15
04_ contents
DJ68-00532J-00.indd
4
2010.1.28
5:7:9 P
assembling the cleaner
OPTION
01 assembling
OPTION
• Features may vary according to model.
• Please do not press the button
of dust bin handle when carrying
machine.
• For storage, park the floor nozzle.
assembling _05
DJ68-00532J-00.indd
5
2010.1.28
5:7:12 P
operating the cleaner
ON/OFF Switch
1) BODY CONTROL
TYPE
caution
2) ON/OFF TYPE
3) HANDLE CONTROL
TYPE
• When removing the plug from the electrical outlet, grasp
the plug, not the cord.
Power Cord
06_ operating
DJ68-00532J-00.indd
6
2010.1.28
5:7:14 P
Power-Control
02 operating
BODY-CONTROL TYPE / ON/OFF TYPE
• HOSE
To reduce suction for cleaning draperies,
small rugs, and other light fabrics, pull
the tap air until the hole is open.
• BODY (BODY-CONTROL TYPE ONLY)
MIN = For delicate surface e.g. net
curtains.
MAX = For hard floors and heavily soiled
carpets.
HANDLE CONTROL TYPE
• HOSE
Vacuum cleaner MODE (MIN/MID,MAX)
sender
Press the MODE button repeatedly
to select the correct mode.
(ON) MIN → MID → MAX
Handle Control
The cleaner is controlled by
using infrared signals.
operating _07
DJ68-00532J-00.indd
7
2010.1.28
5:7:16 P
maintain tools and filter
Using accessory
Pipe (Option)
• Adjust the length of the telescopic pipe by
sliding the length control button located in the
center of the telescopic pipe back and forth.
• To check for blockages, separate the
telescopic pipe and adjust to shorten. This
allows for easier removal of waste clogging the
tube.
Accessory
• Dusting brush for furniture. shelves, books,
etc.
• Crevice tool for radiators, crevices, corners,
between cushions.
08_ maintain
DJ68-00532J-00.indd
8
2010.1.28
5:7:17 P
Maintain floor tools
2-Step Brush (Option)
• Adjust the inlet lever according to the floor
surface.
03 maintain
Carpet Cleaning
• Remove waste matter
completely if the inlet is
blocked.
Floor Cleaning
Pet Brush (Option)
For improved pick-up of pet hair and fibre on carpets.
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to
matters tangled around the drum. In this case, clean the drum with care.
Blanket brush (Option)
Clogs on turbine keep brush from turning, thus need to be unclogged
as follows. For picking up pet hair and fibre on upholstery and bed
linen.
Remove waste matter completely when inlet is blocked.
Turn the lock button to ‘UNLOCK’, and remove waste
matter.
Turbine
Brush
To reassemble, align the cover to the front of the main
body and close. After closing the cover, ensure that the
lock button is turned to the ‘LOCK’ position.
WARNING
Use for bedclothes only. Be cautious not to damage brush during
unclogging.
maintain _09
DJ68-00532J-00.indd
9
2010.1.28
5:7:53 P
maintain tools and filter
Emptying the dust bin
1. Once dust reaches the 2. Take the dust bin out
3. Separate the dust bin
dust full mark, or sution
by pressing the button.
cover.
is noticeably reduced
during cleaning, empty
the dust bin.
4. Throw away dust into
the bin.
-
5. Close the dust bin
cover.
6. Before use, push the
dust bin into the main
body of the vacuum
cleaner until you hear
the “click” sound.
Empty into a plastic bag
(recommended for asthma/
allergy sufferers)
You may rinse the dust bin with cold water.
10_ maintain
DJ68-00532J-00.indd
10
2010.1.28
5:8:0 P
When to clean the dust pack
If suction is noticeably reduced during cleaning, please check the dust pack as
indicated below.
Turn the
vacuum power
to ‘MAX’.
HANDLE CONTROL TYPE
03 maintain
-
BODY CONTROL TYPE
If suction is noticeably reduced with the inlet floating 10cm
above flat floor, clean it.
When suction is noticeably reduced continuously, please cleaning the Dust Pack as
shown in the following illustration.
maintain _11
DJ68-00532J-00.indd
11
2010.1.28
5:8:1 P
Cleaning the dust pack
1. Remove the dust bin and dust pack as
shown.
2. Remove the sponge and filter from the dust pack.
3. Wash the sponge and the filter of the dust pack with
water.
4. Let the sponge and filter dry in the shade for more
than 12 hours.
5. Put the sponge and filter into the dust pack.
6. Put the assembled dust pack into the main
body.
Make sure the filter is completely dry
before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
12_ maintain
DJ68-00532J-00.indd
12
2010.1.28
5:8:3 P
maintain tools and filter
Cleaning the motor protection filter
03 maintain
Take out both the dust bin and the dust
pack.
Remove the motor protection filter from the
vacuum cleaner.
Shake and tap the dust from it and put back in
machine.
Cleaning the outlet filter
option - micro filter
Press the fixed frame part at
the back of the main body to
remove.
Remove and replace the blocked
outlet filter.
Replacement filters are available at your local
Samsung distributor.
OPTION
maintain _13
DJ68-00532J-00.indd
13
2010.1.28
5:8:5 P
maintain tools and filter
Change the battery (option)
1. When the vacuum cleaner dows not work, replace
the batteries. If the problem persists, please contact
our authorized dealer.
2. Use 2 batteries of size AA.
WARNING
1. Never disassemble or recharge the batteries.
2. Never heat up the batteries or throw them into fire.
3. Do not reverse (+), (-) poles
4. Dispose of the batteries property.
BATTERY TYPE : AA
Size
14_ maintain
DJ68-00532J-00.indd
14
2010.1.28
5:8:6 P
troubleshooting
PROBLEM
SOLUTION
• Check cable, pulg and socket.
• Leave to cool.
Suction force is gradually
decreasing.
• Check for blockage and remove.
Cord does not rewind fully.
• Pull the cord out 2-3m and push down the cord
rewind button.
Vacuum cleaner dows not pick
up dirt.
• Check hose and replace if required.
Low or decreasing suction
• Please check filter and, if required, clean as
illustrated in the instructions. if filters are out of
condition change them to new ones.
Body overheating
• Please check filters, If required clean as
illustrated in the instruction.
Static electicity discharge
• Please decrease power suction.
04 troubleshooting
Motor dows not start.
If you have any questions or comments relating to Samsung products, please contact the
SAMSUNG customer care center.
country
customer care center
web site
australia
1300 362 603
www.samsung.com/au
hong kong
3698-4698
www.samsung.com/hk
www.samsung.com/hk_en
malaysia
1800-88-9999
www.samsung.com/my
singapore
1800-SAMSUNG(7267864)
www.samsung.com/sg
troubleshooting _15
DJ68-00532J-00.indd
15
2010.1.28
5:8:6 P
Code No. DJ68-00532J REV(0.0)
DJ68-00532J-00.indd
16
2010.1.28
5:8:6 P