advertisement
®
30" Freestanding Gas Range
PRODUCT MODEL NUMBERS
FGP305K
OVERALL DIMENSIONS
Gas supply: Use 3/4" rigid pipe gas supply line to the range location. A smaller size pipe on long runs may result in insufficient gas supply. With
L.P. gas, piping or tubing size can be 1/2" minimum. If local codes permit, it is recommended that new flexible metal tubing, design-certified by AGA or CSA, 1/2-inch or
3/4-inch I.D., be used for connecting the range to the rigid gas supply line. A 1/2" male pipe thread is needed for connection to pressure regulator female pipe threads. An individual manual shutoff valve must be located in the same room, but external to the range.
Electrical: A 120-volt, 60-Hz, AC-only,
10-ampere, electrical supply fused on both sides of the line. A separate circuit is recommended. A time-delay fuse or circuit breaker is recommended.
26-3/4" depth with handle
24-1/4"
36" cooktop height
46-1/4" overall height for tall backguard models
29-7/8" width
CABINET OPENING DIMENSIONS
18" min.
clearance upper cabinet to countertop
This shaded area recommended for electrical outlet.
13" max. upper cabinet depth
30" min. cabinet opening width
30-1/8" opening width
2" min. countertop space to side wall or other combustible material
24"
For minimum clearance to top of cooktop, see Note.***
10"
This shaded area recommended for installation of gas pipe.
Do Not seal the range to the side cabinets.
If cabinet depth is greater than 24", oven frame must extend beyond cabinet fronts by 1/2" min.
Contact a qualified floor covering installer to check that the floor covering can withstand at least
200°F.
Use an insulated pad or 1/4" plywood under range if installing range over carpeting.
3"
5"
2"
5"
8"
*** Note: 24" min. when bottom of wood or metal cabinet is protected by not less than 1/4" flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015"stainless steel,
0.024" aluminum or 0.020" copper.
30" min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 98014964
02-25-04
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project