Zanussi ZWD 1270 S Operating instructions

INSTRUCTION BOOKLET
WASHER-DRYER
SD 2811 W
ZWD 1270 W
Spin 1270
Dryer
ZWD
S
Instructions
for
ZWD 1470 W use
Important Safety Information
Please read through the information contained in this instructions booklet carefully. It gives important advice on the
safety, assembly, use and maintenance of
the Zanussi-Electrolux Spin Dryer. Retain
the instructions booklet in a safe place
for future reference and, if applicable,
pass it on to the subsequent owner of the
appliance. The manufacturer will not be
liable if the instructions specified below
are not observed. Do not put the Zanussi-Electrolux Spin Dryer to improper use,
i.e. do not use the appliance other than
for the purposes it is meant for. It is
intended for household use and for spinning items of laundry only.
• Before connecting the appliance, check that the
details given on the rating plate correspond to the
requirements of your electrical installation.
• Do not operate the appliance if:
– the mains cable is damaged;
– the appliance shows clear signs of damage.
• Check the appliance for any damag which may
have occured during transport.
• Dispose of the packing in accordance with local
regulations and regard to child safety. Risk of suffocation! .
• Remove the transport locking pads from inside the
drum.
• The spin dryer is intended for use by adults only.
Ensure that children or infirm persons do not play
with the appliance.
• Modifications to the appliance can endanger your
safety and health. It will also invalidate your guarantee. Therefore, repairs to the appliance should
be carried out by an authorised engineer only.
• Never operate the appliance in rooms where
inflammable materials are stored or where gases
have formed.
• Never unplug the appliance by pulling on the
cable , but only by removing the plug directly from
the socket. Always ensure you have switched off
the power supply.
• Ensure that the mains cable is not exposed to
either heat or chemical substances, nor that it is
pulled across sharp edges or surfaces.
• If the mains cable becomes damaged, have it
replaced immediately by an authorised serviceengineer.
• Do not touch or use the appliance with wet hands
or when barefoot and standing on a wet floor.
• Do not expose the appliance to atmospheric
effects, such as sun, rain, etc.
• NEVER add water to the drum, e.g. for „rinsing”
• The basic safety regulations must be strictly observed. In case of doubt, have a qualified engineer
inspect the electrical installation of your house.
Electrical security is only ensured when the appliance has been duly earthed, as described under
the safety regulations for electrical connections.
• If the mains socket does not comply with the plug,
the socket should be replaced by a suitable one.
• Never spin items of laundry which have been
2
•
•
•
•
•
•
•
•
•
cleaned, washed, impregnated or sprayed with
wax, paint, petrol or inflammable liquids. The
vapours can constitute a fire hazard or cause
an explosion. Always wash materials containing
these substances by hand first and let them dry
outside in the fresh air.
Do not stand on the appliance or load heavy
items onto it.
Do not reach into the drum while it is spinning.
Do not store the spin dryer directly next to a hot
stove or heater.
In general, we recommend avoiding the use of
multiple plug sockets, extension cables and
adapters.
Switch off the power supply and pull out the plug
– if the appliance malfunctions during operation;
– before cleaning and maintenance;
– after use.
Operate the spin dryer only in an upright posi- tion
on an even floor and maintain a distance of about
50 cm from the wall or other objects
(Fig. B, Page 4).
During operation, do not lift, carry, hold, move or
tip over the appliance.
Never handle the operating lever and lid with force.
Do not place rolled-up items of clothing (e.g. jeans,
Fig. F) in the spin dryer.
F
• Lift or carry the appliance by the carrying handles
only.
• Before disposal of the spin dryer, cut off the mains
cable. Ensure that the appliance is disposed of
carefully and due regard to the environment.
Always disable the lid catch to prevent children or
animals from becoming trapped.
• The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste.Instead it shall be handed over
to the applicable collection point for the recycling
of electrical and electronicequipment. By ensuring
this product is disposed of correctly, you will help
prevent potential negative consequencesfor the
environment and human health, which could otherwise be caused by inappropriate waste handling
of thisproduct. For more detailed information about
recycling of this product, please contact your local
city office, yourhousehold waste disposal service
or the shop where you purchased the product.
Contents
Page
Important Safety Information
Contents
Description of Parts
Illustrations
Operating Instructions
Maintenance and Care
Something not Working
Service and Spare Parts
Terms and Conditions of Guarantee
2
3
3
4
5
6
6
7
8
Description of Parts
1 = Lid
4= Carrying Handle
7 = Outer Casing
2 = Operating Lever
5= Plug
8 = Outlet Spout
3 = Cable Storage
Fixture
6= Mains Cable
9 = Foot
10 = Rating Plate
3
1
2
4
7
5
8
9
6
10
3
Illustrations
A
B
I
ON
OFF
0
50 cm
20"
C
5020"
cm
D
ca. 3 cm
1"
E
4
Operating Instructions
Congratulations on your new
purchase
We recommed that you read these instructions carefully in order to quickly become familiar with your
new appliance.
A good appliance, which is used properly, will
serve you for many years.
Unpacking the appliance
Dispose of packing materials in accordance with
local regulations and with due regard to safety. Risk
of suffocation!.
Check the spin dryer for any transport damages,
which must be reported to the retailer or delivery
company responsible within 7 days.
Preparation for Use
1. Put the operating lever in the “OFF” (0)
position.
A
2. Open the lid.
3. Remove the transport safeguard from inside
the spin drum.
4. We recommend that the spin drum be wiped with
a wet cloth using a solution of water and mild
washing up liquid. Before using
B
for the first time.
5. Place the spin dryer on a level floor at a
distance of about 50 cm away from the
wall or other objects. Never balance out
irregularities in the floor surface by laying
wood, paper or similar materials under the
appliance.
3. Place each article of laundry singly in the
spin drum. Distribute the washing evenly
in the drum and press down firmly, so as to
avoid leaving empty spaces (and thus avoiding
excessive vibration of the machine during
operation).
4. Press the loaded washing down, so that
D
there is a gap of at least 3 cm between the
washing and the top edge of the drum.
Lastly, cover the washing with a cloth, the ends
of which should be tucked well down inside the
drum, so as to avoid items of washing being
catapulted out during operation.
5. Close the lid.
5
Spin Drying Times
• For normal washing: 3-5 minutes.
The residual moisture amounts to:
approx: 65% in machines with a spin speed of
1400 rpm;
approx: 40% in machines with a spin speed of
2800 rpm;
• For washing which requires no ironing:
15-30 seconds max.
Switch off the appliance
When water ceases to flow out of the outlet spout,
or when the spin process is to be terminated, turn
the operating lever back to the left to the “OFF” (0)
position.
When the drum has come to a standstill, open the
lid. A special safety device prevents the lid being
opened before the drum has stopped spinning.
Never force the lid open
Remove the laundry from the drum.
Switch off the power supply. Pull out the plug.
C
A
The spin dryer is now in operation and water flows
out of the outlet spout.
Gently tilt the spin dryer forward, so that any
remaining water can flow out of the outlet spout.
Loading the machine
E
1. Place a sufficiently large container for excess
water under the outlet spout.
2. Plug the appliance in to a mains socket
(please observe the Points of Safety).
Switch on the appliance
Turn the operating lever to the right as far as it
will go to the “ON” (I) position.
E
Maintenance and Care
• Always switch off the power supply pull out the
plug before cleaning the appliance!
• After use, wipe the spindrum dry with a cloth.
• If dirty washing has been spun, it is necessary
to rinse the drum out with clear water in order to
avoid soiling the next load of washing.
• Clean the exterior of the spin dryer with a damp
cloth and wipe it dry.
• Use a solution of water and mild washing up
liquid only to clean the appliance.
• Do not use abrasive cleaning agents.
• Never use petrol or other solvent liquids.
• The spin dryer requires no other maintenance.
If unexpected difficulties arise
• Before contacting your local Service Force
Centre, check whether the fault is due to one of
the following minor causes.
The motor does not function:
• Has the fuse blown?
• Is there damage to the mains cable, plug or
socket? Turn off the power supply. Pull out the
plug before checking!
• Never open the motor yourself!
Water does not flow out:
• Switch off the power supply. Pull out the plug!
Check whether the outlet spout is blocked by a
piece of washing.
• Press the spin drum from the inside against the
outer casing with your hand and remove the
piece of washing.
The spin dryer does not pick up spin
speed:
• Please note that the spin dryer normally
overcomes a certain amount of unbalance itself
when picking up spin speed. The motor and spin
drum are suspended flexibly for that reason.
• However, if the unbalance is too great (brought
about by incorrect loading of the spin dryer),
the machine cannot pick up spin speed.
The spin dryer “jumps”:
1. Switch off the spin dryer immediately!
2. When the drum has come to a standstill, repack
the washing evenly.
3. Reload the spin dryer in accordance with the
Model
Filling amount (Kg)
6
SD
2811W
3,0
Spin speed
(r.p.m.)
2800
Height (cm)
56
SERVICE AND SPARE PARTS
In the event of your appliance requiring service, or
if you wish to purchase spare parts, please contact
your local Service Force Centre by telephoning:08705 929929
Your telephone call will be automatically routed to
the Service Force Centre covering your post code
area.
For the address of your local Service Force Centre
and further information about Service Force, please
visit the website at www.serviceforce.co.uk
Before calling out an engineer, please ensure you
have read the details under the heading “Something
Not Working.”
When you contact the Service Force Centre you will
need to give the following details:
CUSTOMER CARE DEPARTMENT
For general enquiries concerning your Electrolux
appliance or for further information on Electrolux
products, please contact our Customer Care Department by letter or telephone at the address below or
visit our website at www.Zanussi-Electrolux.co.uk
Customer Care Department
Zanussi-Electrolux
55-77 High Street
Slough
Berkshire
SL1 1DZ
08705 950950 (*)
* calls to this number may be recorded for training
purposes.
1.
2.
3.
4.
Your name, address and post code
Your telephone number
Clear and concise details of the fault
The model and serial number of the appliance
(found on the rating plate)
5. The purchase date Please note that a valid
purchase receipt or guarantee documentation is
required for in-guarantee service calls.
7
GUARANTEE CONDITIONS
Standard guarantee conditions
We, Zanussi-Electrolux, undertake that if within
12 months of the date of the purchase this ZanussiElectrolux appliance or anypart thereof is proved to
be defective by reason only of faulty workmanship
or materials, we will, at our optionrepair or replace
the same FREE OF CHARGE for labour, materials or
carriage on condition that:
The appliance has been correctly installed and used
only on the electricity supply stated on the rating
plate.
The appliance has been used for normal domestic purposes only, and in accordance with the
manufacturer’sinstructions.
The appliance has not been serviced, maintained,
repaired, taken apart or tampered with by any
person notauthorised by us.
All service work under this guarantee must be
undertaken by an Zanussi-Electrolux Service Force
Centre. Any applianceor defective part replaced
shall become the Company’s property.
This guarantee is in addition to your statutory and
other legal rights.
Home visits are made between 8.30am and
5.30pm Monday to Friday. Visits may be available
outside thesehours in which case a premium will be
charged.
Exclusions
This guarantee does not cover:
Damage or calls resulting from transportation, improper use or neglect, the replacement of any light
bulbs orremovable parts of glass or plastic.
European Guarantee
If you should move to another country within Europe
then your guarantee moves with you to your new
homesubject to the following qualifications:
The guarantee starts from the date you first
purchased your product.
The guarantee is for the same period and to the
same extent for labour and parts as exists in the
new countryof use for this brand or range of
products.
This guarantee relates to you and cannot be transferred to another user.
Your new home is within the European Community
(EC) or European Free Trade Area.
The product is installed and used in accordance
with our instructions and is only used domestically,
i.e. anormal household.
The product is installed taking into account regulations in your new country.
Before you move please contact your nearest Customer Care centre, listed below, to give them details
of yournew home. They will then ensure that the
local Service Organisation is aware of your move
and able to lookafter you and your appliances.
France
Germany
Italy
Sweden
UK
Senlis
Nürnberg
Pordenone
Stockholm
Slough
+33 (0)3 44 62 20 13
+49 (0)800 234 7378
+39 (0)800 117511
+46 (0)20 78 77 50
+44 (0)1753 219898
Costs incurred for calls to put right an appliance
which is improperly installed or calls to appliances
outside theEuropean Community (EC) or European
Free Trade Area.
Appliances found to be in use within a commercial environment, plus those which are subject to
rentalagreements.
GA 04.05 BR.
Teile-Nr. 188 117
Products of Electrolux manufacture which are not
marketed by Electrolux.