This warranty is void if any defects are caused
by abuse, misuse, negligence or unauthorized
repairs.All liability for incidental or
consequential damages is specifically
excluded. Some states do not allow for the
exclusion or limitation of incidental or
consequential damages, so the above
limitation or exclusion may not apply to you.
This warranty gives you specific legal rights
and you may have other rights, which vary
from state to state.
www.simacorp.com
Can’t find your plug?
Call Customer Service
800.345.7462
Conditions: Ship your unit, freight pre-paid,
including reasonable proof of date and place
of purchase and description of problem to:
Sima Products Corporation
Attn: Customer Service
140 Pennsylvania Ave.
Bldg. #5
Oakmont, PA 15139
90-day Limited Warranty
Sima Products Corporation warrants this
product against defects in materials and
workmanship for a period of 90 days from the
date of purchase. During the warranty period,
the product will be repaired or replaced at
Sima’s option. Mail the enclosed product
registration card within ten days of the original
purchase.
Universal Power Adapter
For use with
digital cameras and camcorders.
Model SUP-2
Introduction
Congratulations on your purchase of the Sima SUP-2 Universal Power Adapter. It
can power digital cameras and other portable electronic devices requiring 3.3 / 4.2 / 5.0
/ 6.5 / 8.4 or 9.5V DC power. The SUP-2 can also provide power for other devices. It is
fully regulated using high efficiency switching technology and features overload and
short circuit protection. The SUP-2 comes with seven connectors to fit different digital
cameras and other electronic devices. Additional connectors are available from Sima.
This package Includes:
1 AC adapter
7 Center pin positive connectors
120 VAC
12V DC
1 12V car lighter cord
1 SUP-2 This Manual
or
Operation
1. Set the output voltage switch, as illustrated in Fig. 1, to
the desired output for your device. Choose from the
following settings: 3.3 / 4.2 / 5.0 / 6.5 / 8.4 or 9.5 V.
The SUP-2 comes with seven standard connectors. The
connectors allow you to match the size and polarity of
your device’s DC input jack. If your device requires other
types of connectors, contact Sima customer service at
800-345-7462.
The connectors supplied with the SUP-2 are all set in a
center pin positive alignment ( Fig. A) If your device
requires a center pin negative power source (Fig. B)
do not use this adapter. To determine the required
current and correct polarity for your device, refer to the
manufacturer’s instruction manual or specifications
Fig. A
+
OK
-
Fig. B
-
No
Input
Output
Voltage
Switch
2
Power
light
Output
socket
Fig. 1
+
2. Select the appropriate connector and attach it to the output socket at the end of the
output cord. The connectors are numbered as follows: 1, 2, 4, 5, 13, 14 & 17. To
identify the correct connector for your camera, see the list of digital cameras on the
reverse side of this sheet. If unsure, use the connector that fits the power jack of
your camera. The three-pin connectors are designed to fit into
the socket in only one position. Align the pins as shown at
right in Fig. 2. Do not force.
3. Insert the connector into the power jack on your portable device.
4. Plug either the AC adapter or the car cigarette lighter cord
into the SUP-2’s input power jack located at the top of the
unit. Note: Do not plug the AC adapter or car cord
directly into anything except the SUP-2. Next, plug the
AC adapter (or car cord) into a standard AC wall outlet (or
car lighter). The red power light on the SUP-2 should turn
on. You can now operate your device.
Connector
Output
socket
Fig. 2
IMPORTANT: Your portable device must be rated between 3 - 10V DC and no more
than 2100 mA of current to use the SUP-2. If the exact voltage for your device is not
listed below and is less than 10V, you can try setting the voltage switch to the
nearest voltage – use the lower setting first. If the device does not operate, disconnect
the connector from the device, reset the voltage switch to the next higher setting
and re-connect. Do not continue trying higher settings as they may result in
damage to your device or the adapter.
The SUP-2’s current (mA) must be equal to or greater than the current your portable
device requires. Remember 1A = 1000mA, 0.5A = 500mA. Use the following chart
to determine the output current from the SUP-2:
Output
Max.
Output
Max.
Voltage
Current
Voltage
Current
3.3V
=
2.1A
6.5V
= 1.7A
4.2V
=
2.0A
8.4V
= 1.6A
5.0V
=
1.9 A
9.5V
= 1.5A
Resetting the Adapter
CAUTION:
If the power light turns off, check the power source. If on, the output current may be
beyond the AC adapter’s specifications and the overload protection has been activated.
To reset the adapter:
1. Disconnect the AC adapter from the AC outlet and the device you are powering. Wait 10 seconds.
2. Plug the AC adapter into the AC outlet again. If the indicator remains off, there may be a problem
with the AC adapter. Contact Sima customer service for assistance.
Specifications:
AC adapter input: 120V AC, 60 Hz
AC adapter output: 13.5V DC, 1.2A
SUP-2 input:
Output rating:
DC cord length:
Operation Temp:
Storage temp.:
Dimensions:
12-15V DC,
3.3 / 4.2 / 5 / 6.5 / 8.4 or 9.5V DC
1m
32 to 113 degrees F
-4 to 140 degrees F
4” x 2.1” x 1.4”
Plug #
1
2
4
5
13
14
17
Size (diameter)
4.0 mm x 1.7 mm
4.75 mm x 1.7 mm
Sony L/M
Sony S/C
3.5 mm x 1.35 mm
5.5 mm x 2.1 mm
Sony FC
Safety warnings and Cautions
WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture.
CAUTION: To reduce the risk of electric shock, do not remove cover or back. No user serviceable parts
inside. Refer servicing to qualified personnel.
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for your AC power adapter. Before using
your adapter, read all instructions and cautionary markings on the product.
DANGER: To reduce the risk of fire or electric shock, follow these instructions.
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. Your adapter is ETL listed to
UL standards and meets all applicable FCC standards.
WARNING: Changes or modifications to this unit not expressly approved by Sima may cause interference
and void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:1. Re-orient or relocate the receiving antenna. 2. Increase the separation between the
equipment and receiver. 3. Consult Sima customer service at 800-345-7462 if the problem still exists.
CAUTIONS: ·The adapter must attach to the power supply source with a built-in over-current protective
device (Max. 15A), such as a 15A fuse and branch circuit.· Make sure the adapter is disconnected from the AC
outlet and device before adjusting the voltage setting.·Do not use the adapter to power a device that exceeds
the maximum power rating.·
Note: The SUP-2’s voltage must be the same as the voltage your portable device requires.·The SUP-2’s
current (mA) must be equal to or greater than the current your portable device requires.
Digital Camera/Camcorder SUP-2 Connector Plug Chart
Brand
AGFA
Model #
ePHOTO CL-30, CL-34, CL-50, 307, 780, 780C, 1280, 1680
Voltage
6.5V
Plug #
1
CANON
CANON
IXUS, IXUS V,V2, V3, 100, 110, 230, 300, 330
A10, A20, A30, A40
4.2V
4.2V
13
1
CASIO
QV-10A, QV-11, QV-70, QV-100, QV-120, QV-200, QV-300, QV-700,
QV770, QV-780, QV-2000UX, QV-2300UX, QV-2400UX, QV-2800UX,
QV-2900UX, QV-3000EX, QV-3000Plus, QV-3500EX, QV-4000E,
QV-5000SX, QV-5500SX, QV-7000SX, QV-8000SX
PC 550, PC 600, PC 650, PC 700, PC 750Z, PC800Z, PC850Z, PC2100Z,
PC3000Z, PC3100Z
Finepix 50i,1300, 1400Z, 2300, 2400Z, 2700Z, 2800Z, 2900, 3800, 4800Z,
4900Z, 6800Z, 6900Z, DX-10, F401, F402, F601, M603, MX-500, MX-600Z,
MX-700, MX-1200, MX-1400, MX-1500, MX-1700Z, MX-2700, MX-2900Z,
S1 Pro, S2 Pro, S304, S602
6.5V
1
6.5V
2
5V
1
HP
PhotoSmart 120, 315, 318, 320, 612, 620, 720, 850
6.5V
1
KODAK
DC40, DC50, DC120, DC200, DC200 plus, DC210, DC210 plus, DC215,
DC220, DC240, DC240i, DC260, DC265, DC280, DC290, DC3200z,
DC3400z, DC5000z
DC4800, LS443
Finecam S3, S3L, S4, S5
Dimage 5, 7, 7Hi, 7i, 3D 1500, EX1500, 2300, 2330z, E201, RD3000,
S304, S404
6.5V
5V
5V
2
1
1
6.5V
2
NIKON
NIKON
Coolpix 100, 300, 600,700, 750, 800, 900, 950, 990, 2000
CoolPix 775, 880, 885, 995, 4300, 4500, 5000, 5700
6.5V
8.4V
2
2
OLYMPUS
OLYMPUS
OLYMPUS
C-100, C-120, C-200Z, C-211, C-300Z, C-320L, C-700UZ, C-720UZ,
C-730UZ, C-960Z, C-990Z, C-2000Z, C-2020Z, C-2030, C-2040Z,
C-2100Z, C-2500L, C-3000Z, C-3020Z. C-3030Z, C-3040Z, C-4000Z,
C-4040Z, C-5050Z, D-200L, D-220L, D-320L,D-340L, D-340R, D-360L,
D-370L, D-400Z, D-450L, D-450Z, D-460Z, D-500L, D550Z, D-600L,
D-620L, E-10, E-20, E-20P, E-100 RS
C-1, C-1Z, C-2, C-40Z, C-220Z, D-40Z, D-100, D-150Z, D-230
C-50Z
6.5V
3.3V
4.2V
2
1
1
PANASONIC
PANASONIC
PANASONIC
PENTAX
PREMIER
DMC-F7
DMC-FZ1
DMC-LC5, DMC-LC40
Optio 330RS, 430RS
DC620, 820, 1310, 1311, 1500, 2000
5V
8.4V
8.4V
4.2V
6.5V
1
2
2
1
2
RICOH
Caplio PR1, Caplio PR10, Caplio PR120, RDC-2, RDC-2E, RDC-300,
RDC-300Z, RDC-4200, RDC-4300, RDC-5000, RDC-5300, RDC-6000,
RDC-7, RDC-i500, RDC-i700
VPC-MZ1, VPC-AZ1
CP-150 Image Bank (Digital Photo Storage Unit)
5V
3.3V
6.5V
1
1
1
8.4V
4
4.2V
4.2V
5V
5
17
1
EPSON
FUJIFILM
KODAK
KYOCERA
MINOLTA
SANYO
SIMA
SONY
SONY
SONY
TOSHIBA
CD200, CD250, CD300, CD400, CD450, CD1000, F707, F717, FD85,
FD87, FD90, FD92, FD95, FD97, FD100, FD200, S50, S70, S75, S85
P1, P2, P3, P5, P9, P20, P30, P31, P50, P51, P71
Cybershot DSC P8, P10, P32, P52, P72, P92, V-1
PDR-M1, M3, M4, M5, M11, M21, M25, M60, M61, M65, M70, M71, M81
Remarks: For more information about connector plugs for the SUP-2,
see our website at www.simacorp.com
Sima Products Corporation 140 Pennsylvania Ave. Bldg #5
Oakmont, PA 15139 USA
800-345-7462 www.simacorp.com
Made in Taiwan
© 2003 Sima Products Corporation
PN21697