Samson ZOOM H4 Review
Sonic Studios™
SD Flash Portable Recorder NON-Review Commentary
MODEL: Samson Zoom
This is a brief non-review/commentary based on initial bench
testing of the H4 with as-shipped firmware version 1.10
This is not a complete review of the Zoom H4 as initial testing was done
to verify analog input noise/frequency performance. Noise/frequency
response measurements were so poor, I stopped more thorough testing
and canceled doing a full review. This deck was NOT going to be suitable
for most recordists requiring adequate audio quality.
I admit to having a bad feeling about the H4 when a few
customers asked about it last year. And one kind taper on newsgroup offered me a loan a few
months back that I passed on because of this feeling, and
having ability to do a quick evaluation/return was
But one musician customer previously using a Sharp MD
was motivated to buy the H4 for having 4-track mix features
felt useful for her purposes, so I agreed to test the unit.
The 'Swiss Army Knife' Recording Deck for
Musicians !
Seems just about everyone, and especially musicians, is
awed by the H4's very low cost and features. H4 has dual
balanced XLR mic/unbalanced 1/4" TS mic/line input, 48 volt
mic phantom power, 16/24bit depth, VBR MP3 and
44.1/48/96K .wav file recording modes, and unique 4
channel recording mixer mode allowing mulitrack session
with inside-the-deck editing. On deck mics, instrument tuner,
metronome, many types of instrument/editing effects. Easy
powering is accomplished using just (2) AA alkaline or
NiCAD/NiMH type cells
H4 is also unique in ability to become USB recording
soundcard output directly into a PC or MAC computer.
Some noted feature shortfalls is limited up-to-2GIG SD card
storage (some reports of 4 GIG cards working OK), and
buried menu REC level control not ganged for stereo 2-track
mode. This means limited 24 bit depth recording time, and
awkward time consuming REC level adjustments during live
Summary: Bottom line in my opinion is unless deck gets a complete redesign, only hope for H4 is restoring flat bandwidth to
>40K cycles AND using external mic pre to overcome switching power supply noise. Redesign is NOT likely at this point as H4
model seems to have been around for going on 2 years with Samson saying everything is fine in their opinion.
NOTES TO THE WISE: Sans needing H4's high frequency bandwidth restoration, using an external preamp seems a necessary upgrade for virtually
ALL low cost flash decks used for at least acoustic recording purposes with moderately low output mics. In perspective, it took Sony 2 1/2
generations of DAT deck refinement for mic preamp to start to get really usable, and the best was 4.5 generation M1 model. More realistic to expect
low costing flash deck refinement in 2 more generations where switching power supply noise is not such an issue, and external mic preamp is not so
needed for acoustic recording with most microphones.
Most owners of H4 experience severe overload clipping distortions while trying using this deck,
even though VU levels seem well below clipping. Testing found the cause to be the REC level
adjustment that ONLY APPEARS to have 0-127 steps for setting record level, or so it seems until my tests.
In reality, out of the 127 steps, ONLY #100 - #127 range works to control actual REC level; a somewhat
limited 10 dB range of adjustment. Setting REC level below #100 will lower VU level indication, but 1st mic/line
INPUT STAGE IS THEN CLIP DISTORTING!!! This was tested true in ALL sensitivity switch settings, but tested only
the dual unbalanced TS inputs.. Findings should hold true for dual XLR inputs as well.
file:///D|/Sonicweb%20Dreamweaver%20Edition_Recent/zoomh4rv.htm[4/3/2010 12:45:06 PM]
this page as
Acrobat PDF
Samson ZOOM H4 Review
It seems odd to me that no one has mentioned this deck's limited ~12 dB ~27 step analog recording
input adjustment range!
In other words, using full 127 step signal adjustment range for level control is ONLY NOT A PROBLEM when using the
deck's mixer function that works on ALREADY RECORDED mix-track FILE levels, and this (4 track mode) does have
full 127 step range without overload distortion liability.
TS Input REC Level #102
TS Input REC Level #127
Signals needed for producing 0 dB FULL SCALE VU Maximum
+6.9 dBu
1.717 Vrms
-3.2 dBu
.536 Vrms
-18 dBu
.098 Vrms
-28 dBu
.031 Vrms
-26 dB
.037 Vrms
-35 dBu
.013 Vrms
Chart shows maximum 1/4"
TS unbalanced signal input
with deck set in fully useful
#102 - and - #127 (~ 11 dB
range) REC level adj. setting.
Notice M/H settings change
the input sensitivity by ~ 10
dB, but L/H is ~25 dB range!
NOTE: On/Off deck power cycle defaults REC level to #100 adjustment setting on both channels in
STEREO mode. Obviously, this deck forgets some user input and recording quality settings like infamous
Sony MD decks.
TIP: When using external preamplifier with H4, ALWAYS upon turning on for recording
manually set each channel recording level to #115. This will allow about +/- 5.5 dB (~11 dB total) #100 #127 adjustment range, and when set to #115, my PA-3SX preamp's clip light is EXACTLY the same for
deck input near-clip condition.
Findings like the above is exactly why it's so important to bench test new decks for function.
Advanced 'Oxy nickel' Alkaline Batteries seem to last no more than 3-4 hours before flashing low battery
shows, which is OK, but likely less time on regular lower costing Alkaline.
Longest battery runtime likely with NiMH 2500+ ma rechargable cells, and definitely with Energizer L91
photo lithium type cells.
All noise tests, unless noted, used the H4's dual 1/4" unbalanced TS inputs, these loaded to ground with 1000 ohm resistor
Initially found the H4's preamp full of high frequency
switching noise (see spectrum at left), and the Line/phones
output was severely bandwidth limited as noted in the post
so tested noise/bandwidth ONLY with external preamp.
I reasoned if H4 is going to be usable at all for mic
recording, it had to be in the lowest sensitivity 'line level'
setting using the unbalanced dual TS input. As the graph
previously posted shows, with external PA-3SX preamp the
H4 is acceptably quiet enough for serious consideration.
However, the limited high frequency bandwidth (which was
measured several times because I couldn't believe it to be
that bad) was the showstopper removing any hope of
serious use as a recorder.
Doubtful the "M/H" input settings have more available
bandwidth. This is moot because noise is way excessive on
all input settings on this deck.
Using this deck with AC adapter to reduce noise to
acceptable level is a possibility, but makes this deck useless
file:///D|/Sonicweb%20Dreamweaver%20Edition_Recent/zoomh4rv.htm[4/3/2010 12:45:06 PM]
Samson ZOOM H4 Review
for the purposes of versatile portable recording, so not a "fix'
option unless only interest is AC powered computerconnected recording where lower noise is claimed 'not-aproblem.'
WORST NEWS is this deck DOES NOT HAVE smooth frequency response. Two reductions of 6000 cycles
and another roll-off at 15000 cycles (see below). Highest quality 96K sample rate shows another serious
reduction knee at 35000 cycles. There is little excuse for the declining high frequency that looks like the
mediocre audio performance of a prosumer camcorder.
Less troublesome is the LINE and Headphones output
frequency rolls off even more severe, sounding to me more
like an AM radio with <5000 cycles bandwidth!
Also consider all noise, including switching noise, at output
of audio circuits is ALWAYS reduced by rolling off the high
frequency audio bandwidth response like was found. So I
feel the limited bandwidth is a 'noise fix' done with firmware
same as the 'mic modeling' feature operating with the
internal mics?
If the bandwidth is being limited (at the three 'knee'
frequencies noted) to reduce the noise with 'modeling'
process firmware, then possibility to remove this when in
'LINE' level mode so external preamp gives H4 a chance of
decent quality recording not yet possible in the (defective?)
unit tested.
Of course, if full bandwidth flat to 45k cycles is established
like it should have, high frequency noise in the graph is
going to rise, and if not already noticing, the low frequency
noise in the H4 is quite high.
More BAD NEWS is H4 DOES NOT naturally work well as external computer soundcard recording function. Reason is horrendous noise (see
above USB I/O connected spectrum), at least while running on USB power directly. Research indicates Zoom engineers know this, and there's
evidence that connecting H4 up to the AC adapter reduces this noise, allowing more useful, less noisy external soundcard function?
file:///D|/Sonicweb%20Dreamweaver%20Edition_Recent/zoomh4rv.htm[4/3/2010 12:45:06 PM]
Samson ZOOM H4 Review
Suggestions for SD memory cards likely to work reliably in the Samson Zoom H4 flash recorder:
NOTE: Tested OK for all audio recording purposes. This type
SD flash have minimum +9 MB/SEC SEQUENTIAL write
speed, and available in *2 GIG size. Recommended for
consistent reliability and excellent unlimited lifetime warranty.
Kingston Elite Pro 2GB SD
Kingston brand is highly regarded for quality + excellent
unlimited lifetime warranty. +50x rated. Available in *2
Transcend 2GB SD
most memory
products, most
consistent performance is
with purchasing name
brand showing suitable
specifications for your
application, AND
verified reports from
satisfied users of
same deck
model/firmware who
are ALSO recording
at the exact same
file rates you intend
to use.
ACCELERATED super speed flash memory
technology for audio recording purposes.
Advanced flash with acceleration write
modes using data burst techniques might be
speedier for writing/reading non-continuous written
camera files. Non-continuous burst protocol modes
sometimes disrupt reliable continuous mode audio
recording and certainly offer NO advantages for
audio recording.
AVOID newer SDHC cards that DO NOT
WORK in H4 deck
TIP: ALWAYS freshly format the flash card INSIDE the deck whenever removed from the deck for purpose
of transferring files with a separate card reader. Do NOT computer format H4 flash as deck adds specific H4 required
file folders to the card.
Also a very good idea to freshly format the card even if left always inside the deck. Do this every time all
needed files have been safely transferred and all remaining files are to be deleted. Reformatting flash card erases ALL
stored files and allows most reliable new file creation by the deck.
3/18/2007 posted commentary of Samson Zoom H4 deck is finished unless new version of H4 model is released.
What's on Sonic Studios Web Site? (Click underlined text, and navigation photos)
Patented Stereo-Surround Microphone
file:///D|/Sonicweb%20Dreamweaver%20Edition_Recent/zoomh4rv.htm[4/3/2010 12:45:06 PM]
Home Page
Passive DSM™ Mic Powering/Bass Filters
Samson ZOOM H4 Review
Eyegear/Headband/HRTF Baffle
mountable matched omni mics
Stops wind blast noise; transparent
acoustic design; records real wind
for MD, DAT, CF, HD, and Video Field/Event/Studio Recording
Battery Powered-Portable Mic Preamplifiers
High-definition, low noise, very wide
bandwidth preamp designs to fit any
field/event/studio application using DSM™
stereo-surround mics.
Stereo-Surround Omni
Mic Baffle for Stand,
Fishpole, Studio Boom,
and Ceiling
MONO ONLY 'Lombardo'
Lapel Mic for interview,
Narration, Lecture, and
clip-on acoustic instrument
DSM™ Magazine Reviews
Recording Tips
FAQ Index Page
Pro Customers +
A Few Other Links
Sample DSM™
Recordings Page
Credits Page
About Sonic Studios
© Copyright 2007 Sonic Studios All rights reserved.
file:///D|/Sonicweb%20Dreamweaver%20Edition_Recent/zoomh4rv.htm[4/3/2010 12:45:06 PM]
USA Toll Free: 1-877-347-6642
Telephone #:
Mail Ordering Options
PLEASE .................. ALWAYS INCLUDE
an appropriate SUBJECT
LINE in all e-mail