American DJ Multi-Saucer Instruction manual

American DJ
MULTI-SAUCER II™
Introduction
Introduction: Thank you for purchasing the MULTI-SAUCER II™ by
®
MULTI-SAUCER II
™
American DJ®. The MULTI-SAUCER II™ is ready to be plugged in right
out of the box and does not require any type of controller to operate.
The MULTI-SAUCER II™ comes with five spinning heads that operate
on an independently rotating base. This unit reproduces multi-colored
beams of light in that creates unique patterns on the floor and walls.
To optimize beam intensity use this fixture with a fog machine or other
type of special effect smoke.
Customer Support: American DJ® provides a toll free customer
support line, to provide set up help and to answer any question should
you encounter problems during your set up or initial operation. You
may also visit us on the web at www.americandj.com for any comments or suggestions. For service related issue please contact American DJ®. Service Hours are Monday through Friday 9:00 a.m. to 5:00
p.m. Pacific Standard Time.
Voice:
(800) 322-6337
Fax:
(323) 582-2610
E-mail:
support@americandj.com
Unpacking: Every MULTI-SAUCER II™ has been thoroughly tested
and has been shipped in perfect operating condition. Carefully check
the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your unit
for damage and be sure all accessories necessary to operate the unit
have arrived intact. In the event damage has been found or parts are
missing, please contact our toll free customer support number for further instructions. Please do not return this unit to your dealer without
first contacting customer support at the number listed below.
Warning! To prevent or reduce the risk of electrical shock or fire, do
not expose this unit to rain or moisture.
Caution! There are no user serviceable parts inside this unit. Do not
User Instructions
American DJ
®
Rev. 04/02
4295 Charter Street
Los Angeles, CA. 90058
www.americandj.com
attempt any repairs yourself, doing so will void your manufactures
warranty. In the unlikely event your unit may require service please
contact your nearest American DJ® dealer.
PLEASE do not discard the shipping carton in the trash. Please
recycle when ever possible.
©American
DJ® - www.americandj.com - MULTI-SAUCER II™ Instruction Manual Page 2
MULTI-SAUCER II™
•
•
•
•
•
•
•
•
Features
Five Moving Heads
Easy Lamp Replacement
Compact High-Tech Case Design
Built-In Hanging Base
Light Weight Case Design
Multi-Colored Beams
5 Multi-Colored Heads with 28 Lenses Each
5 x LL-200 120v/200w or 5 x LL-200/2 220v/200w (220v version)
MULTI-SAUCER II™
Warranty Registration
The MULTI-SAUCER II™ carries a one year (365 days) limited warranty. Please fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must
be freight pre-paid and accompany a return authorization (R.A.) number. The R.A. number must be clearly written on the outside of the
return package. A brief description of the problem as well as the R.A.
number must also be written down on a piece of paper included in
the shipping carton. If the unit is under warranty, you must provide a
copy of your proof of purchase invoice. You may obtain a R.A. number by contacting our customer support team on our toll free customer support number. All packages returned to the service department
not displaying a R.A. number on the outside of the package will be
returned to the shipper.
MULTI-SAUCER II™
Precautions
Safety Issues: This unit may blow a fuse if the maximum allotted load of
15 amps (7 amps for 220v version) is reached. If the fuse needs replacement please refer to the fuse replacement instructions on page 5.
• To reduce the risk of electrical shock or fire, do not expose this
unit rain or moisture
• Do not spill water or other liquids into or on to your unit
• Do not attempt to operate this unit if the power cord has been
frayed or broken
• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and fire in case of an internal short
• This unit is intended for internal use only, use of this product outdoors voids all warranties written or implied.
©American
DJ® - www.americandj.com - MULTI-SAUCER II™ Instruction Manual Page 3
MULTI-SAUCER II™
General Instructions
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and maintenance of this unit. Please keep this manual with the unit, for future
reference.
MULTI-SAUCER II™
Operation
Power Supply: Before plugging your unit in, be sure the source
voltage in your area matches the required voltage for your American
DJ® MULTI-SAUCER II™ before attempting operation.
General Operation: Just plug this light in, and watch it go. This fixture is designed to operate as a stand alone unit. It has been tested
and the lamp has been installed at the factory there is no assembly
necessary. The MULTI-SAUCER II™ is ready to be plugged in, out of
the box. There is no power switch, after plugging the unit in the base
and five outer heads will immediately begin to spin.
MULTI-SAUCER II™
Cleaning
Fixture Cleaning: Due to fog residue, smoke, and dust cleaning the
internal and external lenses should be carried out periodically to optimize light output. Cleaning frequency depends on the environment
in which the fixture operates (I.e. smoke, fog residue, dust, dew).
In heavy use we recommend cleaning on a monthly basis. Periodic
cleaning will ensure longevity, and crisp beam output.
1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2. Use a soft brush to clean out the air vents
3. Clean the external optics with glass cleaner and a soft cloth every
20 days.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the unit
back in.
©American
DJ® - www.americandj.com - MULTI-SAUCER II™ Instruction Manual Page 4
MULTI-SAUCER II™
Fuse & Lamp Replacement
Halogen Lamp Warning! This fixture is fitted with
halogen lamps which are highly susceptible to damage if improperly handled. Never touch the lamps
with your bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture until
the lamps have had ample time to cool. Remember,
lamps are not covered under warranty conditions.
Caution: Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ® technician. Replace with anything other than the specified part can damage
your unit and will void your manufactures warranty.
Warning: If after you have replaced the lamp or fuse and you con-
MULTI-SAUCER II™
Warranty
ONE YEAR LIMITED WARRANTY
A. American DJ® hereby warrants, to the original purchaser, American DJ® products to be
free of manufacturing defects in material and workmanship for a period of one year (365
days) from the date of purchase. This warranty shall be valid only if the product is purchased within the United States of America, including possessions and territories. It is the
owner’s responsibility to establish the date and place of purchase by acceptable evidence,
at the time service is sought.
B. For warranty service, send the product only to the American DJ® factory. All shipping
charges must be pre-paid. If the requested repairs or service (including parts replacement)
are within the terms of this warranty, American DJ® will pay return shipping charges only
to a designated point within the United States. If the entire instrument is sent, it must be
shipped in its original package. No accessories should be shipped with the product. If any
accessories are shipped with the product, American DJ® shall have no liability whatsoever
for loss of or damage to any such accessories, nor for the safe return thereof.
Fuse Replacement: Disconnect the unit’s main power supply. Use
C. This warranty is void if the serial number has been altered or removed; if the product is
modified in any manner which American DJ® concludes, after inspection, affects the reliability of the product; if the product has been repaired or serviced by anyone other than
the American DJ® factory unless prior written authorization was issued to purchaser by
American DJ®; if the product is damaged because not properly maintained as set forth in
the instruction manual.
a number 2 Phillips screw driver in to the fuse holder housing (located
on the bottom of the unit). Turn the screwdriver in a counter-clockwise direction to remove the fuse holder. Remove the old fuse and
discard it, replace the fuse with the same type. Insert the fuse holder
back into it’s housing and turn in a clockwise direction to secure the
holder in place.
D. This is not a service contract, and this warranty does not include maintenance, cleaning
or periodic check-up. During the period specified above, American DJ® will replace defective parts at its expense, and will absorb all expenses for warranty service and repair labor
by reason of defects in material or workmanship. The sole responsibility of American DJ®
under this warranty shall be limited to the repair of the product, or replacement thereof,
including parts, at the sole discretion of American DJ®. All products covered by this warranty were manufactured after January 1, 1990, and bear identifying marks to that effect.
tinue to blow either one, STOP using the unit. Contact customer support for further instructions, you may have to return the unit for servicing. Continuing to use the unit may cause serious damage.
Lamp Replacement: Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a remove tray that is retained by
a single thumb screws. Again, please remember to always replace
with the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the two thumb screws that secure the lamp socket
assembly cover to the outside of the spinning heads.
3. Once the thumb screws have been removed, remove the
assembly cover plate to expose the lamps.
4. Remove and replace the lamp with an exact match.
5. Reassemble in reverse order.
©American
DJ® - www.americandj.com - MULTI-SAUCER II™ Instruction Manual Page 5
E. American DJ® reserves the right to make changes in design and/or improvements upon
its products without any obligation to include these changes in any products theretofore
manufactured.
F. No warranty, whether expressed or implied, is given or made with respect to any accessory supplied with products described above. Except to the extent prohibited by applicable
law, all implied warranties made by American DJ® in connection with this product, including warranties of merchantability or fitness, are limited in duration to the warranty period
set forth above. And no warranties, whether expressed or implied, including warranties of
merchantability or fitness, shall apply to this product after said period has expired. The
consumer’s and or Dealer’s sole remedy shall be such repair or replacement as is expressly
provided above; and under no circumstances shall American DJ® be liable for any loss or
damage, direct or consequential, arising out of the use of, or inability to use, this product.
G. This warranty is the only written warranty applicable to American DJ® Products and
supersedes all prior warranties and written descriptions of warranty terms and conditions
heretofore published.
H. Lamps are not covered under this or any other warranty either written or implied.
©American
DJ® - www.americandj.com - MULTI-SAUCER II™ Instruction Manual Page 6
MULTI-SAUCER II™
Specifications
Model: MULTI-SAUCER II™
Voltage*:
Lamps:
Fuse:
Dimensions:
Colors:
Working Position:
Weight:
Warranty:
120v~60Hz or 220v~50/60Hz
5 x LL-200 120v/200w or
5 x LL-200/2 220v/200w
15 Amp GMA (7 Amp 220v)
16” H x 16.5” W x 16.5” D
Multi-Colored Glass Lenses
Any Safe Position Modes
21 Lbs.
1 Year (365 Days)
* Voltage is preset at the factory and is not user selectable.
Please Note: Specifications and improvements in the design
of this unit and this manual are subject to change without any
prior written notice.
©American
©American
DJ® - www.americandj.com - MULTI-SAUCER II™ Instruction Manual Page 7
DJ®
A Division of the American DJ® Group of Companies
American DJ® World Headquarters:
4295 Charter Street Los Angeles, CA 90058 USA
Tel: 323-582-2650 / Fax: 323-582-2610
Web: www.americandj.com / E-mail: info@americandj.com