Belkin Delphi RoadyXT User manual

Belkin Tech Support
US: 310-898-1100, ext. 2263
800-223-5546, ext. 2263
Europe: 00 800 223 55 460
Australia: 1800 235 546
New Zealand: 0800 235 546
Belkin Corporation
501 West Walnut Street
Los Angeles, CA 90220, USA
310-898-1100
310-898-1111 fax
Belkin Ltd.
Express Business Park, Shipton Way
Rushden, NN10 6GL, United Kingdom
+44 (0) 1933 35 2000
+44 (0) 1933 31 2000 fax
Belkin B.V.
Boeing Avenue 333
1119 PH Schiphol-Rijk, The Netherlands
+31 (0) 20 654 7300
+31 (0) 20 654 7349 fax
Belkin Ltd.
7 Bowen Crescent, West Gosford
NSW 2250, Australia
+61 (0) 2 4372 8600
+61 (0) 2 4372 8603 fax
© 2006 Belkin Corporation. All rights reserved. All trade names are registered trademarks
of respective manufacturers listed. The XM logo and RoadyXT are either trademarks or
registered trademarks of XM Satellite Radio.
F8E724
P75059
Mobility Kit for Xpress™
and RoadyXT®
User Manual
Introduction
Congratulations and thank you for purchasing the Mobility Kit for Xpress and
RoadyXT from Belkin. Now you can turn your Delphi RoadyXT or Audiovox Xpress
into a truly portable XM receiver and keep the music playing anytime on the go.
Please be sure to read all the instructions in this User Manual so that you can get the
most from your Belkin product.
What’s in the box?
Your Mobility Kit for Xpress and RoadyXT includes these components:
• Belkin TunePower for XM (Rechargeable Battery Pack) (1)
• XM Antenna Headphones (1)
• Belt Clip (2)
• XM 5V Home Power Adapter (5)
• TunePower Sleeve and Spacer for Delphi RoadyXT (3)
1
• TunePower Sleeve and Spacer for Audiovox® Xpress (4)
2
3
4
1
5
How to Attach the TunePower to your XM Receiver
There are two sleeve sizes and matching spacers included: Delphi RoadyXT
and Audiovox Xpress. Select the appropriate sleeve and spacer for your XM
Plug-n-Play receiver.
Attach the spacer for your XM receiver
to the TunePower battery housing. (Fig. 1)
������
Fig. 1
�
Slide the battery housing through the
opening in the sleeve as shown in the
diagram. (Fig. 2) Make sure the flange
around the edge of the battery pack
securely snaps into the sleeve. (Fig. 3)
Fig. 2
�
�����
Fig. 3
2
How to Attach the TunePower to your XM Receiver
Attach the form-fitted sleeve to the
XM Plug-n-Play receiver by sliding the
receiver into the sleeve bottom first.
Make sure that the dock connector on
the bottom of the receiver is on the same
side as the TunePower’s cable and dock
connector, and then slide the receiver into
the TunePower sleeve. The receiver will be
held tightly and will not fall out when it is
inserted correctly. (Fig. 4)
Connect the TunePower XM to the XM
Plug-n-Play receiver by plugging the
TunePower’s dock connector into the
bottom of the XM receiver through the
opening in the TunePower sleeve. (Fig. 5)
�
Fig. 4
�
�����
�
Fig. 5
3
How to Attach the TunePower to your XM Receiver
Attach the belt clip. The belt clip can
be attached to allow the Mobility Kit
for Xpress and RoadyXT to be carried
on your belt with the display facing up
or down. It can also be attached to an
XM-radio-mounting solution, such as the
Belkin TuneDok® for XM (sold separately).
To remove the clip, firmly push against
the tabs as shown in the diagram.
�����
Fig. 6
Connect the XM Antenna Headphones to
the port on the side of the TunePower XM.
(Fig. 7) The XM Antenna Headphones are
adjustable for a custom fit and feature a
built-in volume control.
Fig. 7
4
How to Remove the Belkin TunePower XM from your XM Receiver
For Xpress Receivers:
�������������������������������������������������
�������������������������������������������������
������������������������������������������������
������������������������������������������������
For RoadyXT Receivers:
����������������
������������������������
���������������������
����������������
������������������������
���������������������
5
Operating the Belkin TunePower XM
The Belkin TunePower for Delphi RoadyXT and Audiovox Xpress will provide four to
five hours of playtime*
*Performance may vary based on the XM Plug-n-Play receiver with which it is used.
To check the remaining battery power level, press the button on the top end of the
TunePower and let go. The button will light up to indicate the battery status:
Green: The battery is fully charged.
Amber: The battery is partially charged. As the battery charge gets lower, the color
transitions from green to amber.
Red: Less than 10 minutes of charge remain. Time to recharge!
6
Charging the Belkin TunePower
To charge the Belkin TunePower, connect the small end of the included AC wall
charger into the DC-power-in jack on the side of the TunePower. Connect the AC wall
charger into any US wall power outlet.
The LED charge indicator will illuminate green when the Belkin TunePower is
charging its batteries. This indicator will turn off when the battery has been charged
to approximately 90 percent.
The TunePower will charge its batteries completely in approximately four hours.
The Mobility Kit for Xpress and RoadyXT is fully operational while the TunePower
is charging.
Note: The Belkin TunePower XM will supply power to the XM Plug-n-Play receiver
whenever its dock connector is connected. When not in use, it is recommended to
disconnect the Belkin TunePower XM from the XM Plug-n-Play receiver or make sure
that the XM Plug-n-Play receiver is turned off to conserve power.
7
FCC Statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that which the
receiver is connected.
• Consult the dealer or a radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference that may cause undesired
operation of the device.
Canada-Industry Canada (IC)
The wireless radio of this device complies with RSS 139 & RSS 210 Industry Canada. This
Class B digital apparatus complies with Canadian ICES-003.
8
Belkin Corporation Limited 3-Year Product Warranty
What this warranty covers.
Belkin Corporation warrants to the original purchaser of this Belkin product that the
product shall be free of defects in design, assembly, material, or workmanship.
What the period of coverage is.
Belkin Corporation warrants the Belkin product for three years.
What will we do to correct problems?
Product Warranty.
Belkin will repair or replace, at its option, any defective product free of charge (except for
shipping charges for the product).
What is not covered by this warranty?
All above warranties are null and void if the Belkin product is not provided to Belkin
Corporation for inspection upon Belkin’s request at the sole expense of the purchaser, or
if Belkin Corporation determines that the Belkin product has been improperly installed,
altered in any way, or tampered with. The Belkin Product Warranty does not protect
against acts of God (other than lightning) such as flood, earthquake, war, vandalism, theft,
normal-use wear and tear, erosion, depletion, obsolescence, abuse, damage due to
low voltage disturbances (i.e. brownouts or sags), non-authorized program, or system
equipment modification or alteration.
How to get service.
To get service for your Belkin product you must take the following steps:
1. Contact Belkin Corporation at 501 W. Walnut St., Compton CA 90220, Attn: Customer
Service, or call (800)-223-5546, within 15 days of the Occurrence. Be prepared to provide
the following information:
a. The part number of the Belkin product.
b. Where you purchased the product.
c When you purchased the product.
d. Copy of original receipt.
2. Your Belkin Customer Service Representative will then instruct you on how to forward
your receipt and Belkin product and how to proceed with your claim.
9
Belkin Corporation Limited 3-Year Product Warranty
Belkin Corporation reserves the right to review the damaged Belkin product. All costs of
shipping the Belkin product to Belkin Corporation for inspection shall be borne solely by
the purchaser. If Belkin determines, in its sole discretion, that it is impractical to ship the
damaged equipment to Belkin Corporation, Belkin may designate, in its sole discretion, an
equipment repair facility to inspect and estimate the cost to repair such equipment. The
cost, if any, of shipping the equipment to and from such repair facility and of such estimate
shall be borne solely by the purchaser. Damaged equipment must remain available for
inspection until the claim is finalized. Whenever claims are settled, Belkin Corporation
reserves the right to be subrogated under any existing insurance policies the purchaser
may have.
How state law relates to the warranty.
THIS WARRANTY CONTAINS THE SOLE WARRANTY OF BELKIN CORPORATION, THERE
ARE NO OTHER WARRANTIES, EXPRESSED OR, EXCEPT AS REQUIRED BY LAW, IMPLIED,
INCLUDING THE IMPLIED WARRANTY OR CONDITION OF QUALITY, MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, AND SUCH IMPLIED WARRANTIES, IF ANY, ARE
LIMITED IN DURATION TO THE TERM OF THIS WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so the above
limitations may not apply to you.
IN NO EVENT SHALL BELKIN CORPORATION BE LIABLE FOR INCIDENTAL, SPECIAL, DIRECT,
INDIRECT, CONSEQUENTIAL OR MULTIPLE DAMAGES SUCH AS, BUT NOT LIMITED TO, LOST
BUSINESS OR PROFITS ARISING OUT OF THE SALE OR USE OF ANY BELKIN PRODUCT, EVEN
IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
This warranty gives you specific legal rights, and you may also have other rights, which may
vary from state to state. Some states do not allow the exclusion or limitation of incidental,
consequential, or other damages, so the above limitations may not apply to you.
10