AXIS T8640 Ethernet Over Coax Adaptor User Guide - Use-IP

USER GUIDE
AXIS T8640 Ethernet Over Coax Adaptor
PoE+
ENGLISH
Electromagnetic Compatibility (EMC)
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures: Re-orient or relocate
the receiving antenna. Increase the separation
between the equipment and receiver. Connect
the equipment to an outlet on a different circuit
to the receiver. Consult your dealer or an
experienced radio/TV technician for help.
Shielded (STP) network cables must be used with
this unit to ensure compliance with EMC
standards.
CLASS B USA:
This equipment has been tested using a shielded
network cable (STP) and found to comply with
the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV
technician for help.
CLASS B Europe
This digital equipment fulfills the requirements
for RF emission according to the Class B limit of
EN 55022 when PoE powered.
CLASS A Europe
This digital equipment fulfills the requirements
for RF emission according to the Class A limit of
EN 55022 when DC powered.
EN 55024
This product fulfills the requirements for
immunity according to EN 55024 office and
commercial environments.
Equipment Modifications
This equipment must be installed and used in
strict accordance with the instructions given in
the user documentation. This equipment
contains no user-serviceable components.
Unauthorized equipment changes or
modifications will invalidate all applicable
regulatory certifications and approvals.
Liability
Every care has been taken in the preparation of
this document. Please inform your local Axis
office of any inaccuracies or omissions. Axis
Communications AB cannot be held responsible
for any technical or typographical errors and
reserves the right to make changes to the
product and documentation without prior
notice. Axis Communications AB makes no
warranty of any kind with regard to the material
contained within this document, including, but
not limited to, the implied warranties of
merchantability and fitness for a particular
purpose. Axis Communications AB shall not be
liable nor responsible for incidental or
consequential damages in connection with the
furnishing, performance or use of this material.
RoHS
This product complies with both the
European RoHS directive, 2002/95/EC,
and the Chinese RoHS regulations,
ACPEIP.
WEEE Directive
The European Union has enacted a
Directive 2002/96/EC on Waste
Electrical and Electronic Equipment
(WEEE Directive). This directive is
applicable in the European Union member
states.
The WEEE marking on this product (see right) or
its documentation indicates that the product
must not be disposed of together with
household waste. To prevent possible harm to
human health and/or the environment, the
product must be disposed of in an approved and
environmentally safe recycling process. For
further information on how to dispose of this
product correctly, contact the product supplier,
or the local authority responsible for waste
disposal in your area.
Business users should contact the product
supplier for information on how to dispose of
this product correctly. This product should not
be mixed with other commercial waste. For more
information, visit www.axis.com/techsup/.
Support
Should you require any technical assistance,
please contact your Axis reseller. If your
questions cannot be answered immediately, your
reseller will forward your queries through the
appropriate channels to ensure a rapid response.
If you are connected to the Internet, you can:
• download user documentation and firmware
updates
• find answers to problems in the FAQ database.
Search by product, category, phrases.
• report problems to Axis support by logging in
to your private support area.
AXIS T8640
Page 5
AXIS T8640 Ethernet Over Coax Adaptor
PoE+ User Guide
Package Contents
ENGLISH
Item
Models/variants/notes
Ethernet Over
Coax Adaptor
PoE+
AXIS T8640:
• AXIS T8641 Ethernet Over Coax Base Unit PoE+
• AXIS T8642 Ethernet Over Coax Device Unit PoE+
Optional
accessories
AXIS T8003 PS57 (Power supply)
DIN Rail clip
Wall bracket
Rack mount bracket
Printed Materials
AXIS T8640 User Guide (this document)
Axis Warranty Document
Hardware Overview
LEDs
Device unit
Base unit
LEDs
Network connector
Power
connector
BNC connector
Page 6
AXIS T8640
Hardware Overview - Configuration Examples
Example 1. External power supply needed when used together with
non-PoE switch.
Power supply
Base unit
Ethernet
switch
Device unit
Example 2. External power supply needed when used together with
non-PoE switch.
Power supply
Device unit
Base unit
Device unit
Base unit
Ethernet
switch
Example 3. PoE powered solution (optional power supply
needed when used together with low quality cables)
Power supply (optional)
PoE
switch
Device unit
Base unit
Example 4. PoE devices higher than class 4 require additional
midspan.
Midspan
PoE
switch
Base unit
Device unit
AXIS T8640
Page 7
LED Indicators
LED
Behavior/color
Coax
link
Off
No power
On
Connection established
PoE over
coax
Flash
Units not detected on coax
Orange/red
Data rate < 100%. The coax connection has
reached power and range limit. Reduce cable
distance or connect an AXIS T8003 PS57 supply
to the Device unit.
Off
No network connection
On
Ethernet link established
Flash
Network activity on port
Red
10BASE-T connection. Units must be connected
to 100BASE-T (full-duplex) compatible
equipment for effective operation.
Off
Units not detected
On
PoE over Coax enabled
Red (1 flash)
Low voltage. Check power supply type/polarity.
Red (2 flashes)
Short circuit. Check for cable faults and remove
legacy video equipment.
Red (3 flashes)
Max PoE On
power
available
Flash
for
camera
(Watts)
Power disconnected due to overload.
Max PoE power that can be reliably delivered
from 5 to 25 watts.
Less than 5 watts of PoE available.
Orange (flashing)
Approaching power limit
Red (flashing)
Power limit reached. See note below.
ENGLISH
Ethernet
link
Indication
Page 8
AXIS T8640
Note:
• Available power is specific to the cable length, type, and power source used, and
is calculated automatically on connection. For example, to ensure reliable
power delivery to a PoE IP camera whose maximum power requirement is 12
watts, check that the 15 watt LED is lit.
• If installing a PTZ camera, or any equipment whose power requirement can
change, check these LEDs while the equipment is drawing peak power, such as
when the PTZ camera is moving.
• For maximum PoE over coax power, connect an AXIS T8003 PS57 power supply
to the Base unit. If more power is required than the cable can carry, the power
supply can be connected to the Device unit.
AXIS T8640
Page 9
Technical Specifications
Specifications
Model
AXIS T8640:
• AXIS T8641 Ethernet Over Coax Base Unit PoE+
• AXIS T8642 Ethernet Over Coax Device Unit PoE+
Data rate
Coaxial cable: 100Mbps Full Duplex
Ethernet cable: 100Base-TX Full Duplex
Connectors
Coaxial: BNC 75 Ohm
Ethernet: Shielded RJ-45, EIA 568A and 568B
Network cables
• Coaxial: Any 75 Ohm coaxial (other impedances supported),
to 500 m /1600 ft. at full rate
• Ethernet: Shielded category 5 (or higher); (patch or crossover, auto-detected)
Output power
AXIS T8641: PoE over Coax with safe auto-detection and
autocutout
AXIS T8642: PoE (IEEE 802.3af/at) enabled to detected devices
up to 25.5 W
Input power
• AXIS T8641: PoE (IEEE 802.3at Class 4 powered device) or
DC power supply
• AXIS T8642: PoE over Coax or DC power supply
• DC Power supply: AXIS T8003 PS57 or 44 - 56V DC Class 2
isolated supply (max 0.7 amps)
• Device power: 1.5 W
Installation/
management
Plug-and-play installation; automatically detects PoE and
High PoE-enabled devices and supplies in-line power
Local LED management display
Compliance
IEEE 802.3at, IEEE 802.3af, RoHS, WEEE, CE
Mounting
Wall, rack, DIN Rail
Environment
Indoor
ENGLISH
Item
Page 10
AXIS T8640
Item
Specifications
Approvals
FCC part 15, Class B with FTP cabling
EN 55022 Class B (Emissions, PoE powered)
EN 55022 Class A (Emissions, DC powered)
EN 55024 (Immunity)
Operating
conditions
-10 °C to 50 °C (14 °F to 122 °F)
Humidity max. 95% RH (non-condensing)
Storage
-40 °C to 74 °C (-40 °F to 165 °F)
Dimension
(HxWxD)
104 x 54 x 24 mm (4.1” x 2.1” x 0.9)
Weight
140 g (0.3 lbs)
Optional
accessories
AXIS T8003 PS57 Power supply, DIN Rail Clip, Wall Mount
Bracket, Rack Mount Bracket
AXIS T8640
Page 11
Examples of Power Source for:
Low power PoE Network cameras (PoE IEEE 802.3af Class 1, or 2; < 6
watts)
AXIS M11 Network Camera Series
AXIS 221 Network Camera
AXIS M30 Network Camera Series
AXIS M32 Network Camera Series
AXIS M31-R/VE Network Camera Series
AXIS P33 Network Cameras (indoor models)
AXIS 212 PTZ/-V Network Camera
Using an 802.3af PoE switch
Using AXIS T8003 PS57
150m (492 ft.) of CCS RG-59
350m (1148 ft.) of CC RG-59
400m (1312 ft.) of CC RG-6
500m (1640 ft.) of CC RG-11
280m (919 ft.) of CCS RG-59
350m (1148 ft.) of CC RG-59
400m (1312 ft.) of CC RG-6
500m (1640 ft.) of CC RG-11
Note: CC = Copper-Cored Cable (most common for correctly installed
analog video) CCS = 22AWG Copper-Coated Steel (shows worst-case performance if cable type is not known)
ENGLISH
•
•
•
•
•
•
•
Page 12
AXIS T8640
Examples of Power Source for:
Medium power PoE Network cameras (PoE IEEE 802.3af Class 1, 2 or 3;
<10 watts)
•
•
•
•
•
•
AXIS M1054 Network Camera
AXIS P13 Network Cameras (indoor models)
AXIS Q16 Network Cameras (indoor models)
AXIS Q1755 Network Camera
AXIS Q19 Network Camera Series
AXIS P33-VE Network Cameras
Using an 802.3af PoE switch
Using AXIS T8003 PS57
CCS RG-59 not supported
350m (1148 ft.) of CC RG-59
400m (1312 ft.) of CC RG-6
500m (1640 ft.) of CC RG-11
200m (656 ft.) of CCS RG-59
350m (1148 ft.) of CC RG-59
400m (1312 ft.) of CC RG-6
500m (1640 ft.) of CC RG-11
Examples of Power Source for:
Full power PoE or PoE+ Network cameras (PoE IEEE 802.3af Class 3; >10
watts) or IEEE 802.3at.
•
•
•
•
•
AXIS P13-E Network Cameras
AXIS Q16-E Network Cameras
AXIS Q1755-E Network Camera
AXIS P55 Network Camera Series
AXIS Q60 Network Cameras (indoor models)
Using an 802.3af PoE switch
Using AXIS T8003 PS57
Not supported
80m (262 ft.) of CCS RG-59
350m (1148 ft.) of CC RG-59
400m (1312 ft.) of CC RG-6
500m (1640 ft.) of CC RG-11
AXIS T8640
Page 13
Examples of Power Source for:
Custom High PoE Network cameras that use AXIS T8124 High PoE 60 W
Midspan 1-port such as the AXIS Q60-E Network Cameras.
Using an 802.3af PoE switch
Using AXIS T8003 PS57
Note:
• The actual range depends on several factors such as cable quality, cable
thickness, connectors and camera power consumption.
• Range figures assume short (<5 m or 16 ft.) Cat-5e cables between equipment.
• CC - Copper-Cored Cable (most common for correctly installed analog video)
CCS - 22AWG Copper-Coated Steel (shows worst-case performance if cable
type is not known)
ENGLISH
PoE to the camera is not supported. The AXIS T8642 Device can be powered over
the coaxial cable, but an AXIS T8124 60 W midspan must be used to power the
camera locally.
User Guide
AXIS T8640 Ethernet Over Coax Adaptor
PoE+
© Axis Communications AB, 2012
Ver.1.0
Printed: June 2012
Part No. 46660