INSTRUCTIONS AND WARRANTY
MODEL NO. SFP600
SALTON FOOD PROCESSOR
Congratulations on purchasing our Salton Food Processor. Each unit is manufactured to
ensure safety and reliability. Before using this appliance for the first time, please read
the instruction manual carefully and keep it for future reference.
IMPORTANT SAFEGUARDS
When using any electrical appliance, basic safety precautions should always be followed
including the following:
1. Please read the instructions carefully before using any appliance.
2. Always ensure that the voltage on the rating label corresponds to the mains
voltage in your home.
3. Incorrect operation and improper use can damage the appliance and cause injury
to the user.
4. The appliance in intended for household use only. Commercial use invalids the
warranty and the supplier can not be held responsible for injury or damage
caused when using the appliance for any other purpose than that intended.
5. Avoid any contact with moving parts.
6. Close supervision is required when any appliance is used near or by children or
invalids.
7. Check the power cord and plug regularly for any damage. If the cord or the plug
is damaged, it must be replaced by the manufacturer or a qualified person in
order to avoid an electrical hazard.
8. Do not use the appliance if it has been dropped or damaged in any way. In case
of damage, take the unit in for examination and/or repair by an authorised service
agent
9. To reduce the risk of electric shock, do not immerse or expose the motor
assembly, plug or the power cord to water or any other liquid.
10. Never immerse the unit in water or any other liquid for cleaning purposes.
11. Remove the plug from the socket by gripping the plug. Do not pull on the cord to
disconnect the appliance from the mains. Always unplug the unit when not in
use, before cleaning or when adding or removing parts.
12. The use of accessory attachments that are not recommended or supplied by the
manufacturer may result in injuries, fire or electric shock.
13. A short cord is provided to reduce the hazards resulting from becoming
entangled in or tripping over a longer cord.
2
14. Do not let the cord hang over the edge of a table or counter. Ensure that the cord
is not in a position where it can be pulled on inadvertently.
15. Do not allow the cord to touch hot surfaces and do not place on or near a hot gas
or electric burner or in a heated oven.
16. Do not use the appliance on a gas or electric cooking top or over or near an open
flame.
17. Use of an extension cord with this appliance is not recommended. However, if it
is necessary to use an extension lead, ensure that the lead is suited to the power
consumption of the appliance to avoid overheating of the extension cord,
appliance or plug point. Do not place the extension cord in a position where it can
be pulled on by children or animals or tripped over.
18. This appliance is not suitable for outdoor use. Do not use this appliance for
anything other than its intended use.
19. DO NOT carry the appliance by the power cord.
20. Do not leave this appliance unattended during use. Always unplug the unit when
not in use or before cleaning.
21. Always operate the appliance on a smooth, even, stable surface. Do not place
the unit on a hot surface.
22. Ensure that the switch is in the “Off” position after each use.
23. The manufacturer does not accept responsibility for any damage or injury caused
by improper or incorrect use, or for repairs carried out by unauthorised
personnel.
24. In case of technical problems, switch off the machine and do not attempt to repair
it yourself. Return the appliance to an authorised service facility for examination,
adjustment or repair. Always insist on the use of original spare parts. Failure to
comply with the above mentioned pre-cautions and instructions, could affect the
safe operation of this machine.
25. In case of technical problems, switch off the machine and do not attempt to repair
it yourself. Return the appliance to an authorised service facility for examination,
adjustment or repair. Always insist on the use of original spare parts. Failure to
comply with the above mentioned pre-cautions and instructions, could affect the
safe operation of this machine.
26. Do not operate the unit for more than 1 (one) minute continuously. Use the unit
for 1 (one) minutes, then let the unit rest for 8 (eight) minutes before operating
again. After five cycles of use and rest, rest the unit for 30 (thirty) minutes.
3
Should you use the unit for longer than 1 (one) minutes, the unit will cease to
operate. Wait for a period of 30 (thirty) minutes before operating the unit again.
This prevents the unit from overheating.
27. Never fill the bowl or jug over the maximum marks. Do not put any liquids in the
bowl or jug exceeding a temperature of 75˚C.
28. Do not place any of the following into the bowl or jug:
Hard ingredients such as: frozen food, crusts of cheese, ice;
Rubbery ingredients such as: candied peel;
Inedible ingredients such as: bones and fish bones.
29. Do not remove any covers while the processor is in operation. Always wait for the
blades or knives to stop moving before removing the covers.
30. Do not remove any ingredients from the processor before removing the blades or
knives.
SPEED GUIDE:
“0” = Off
“1” to “5” various speeds, “1” being the lowest speed and “5” being the highest speed.
Pulse button: the unit will operate until the control is released
4
PARTS DIAGRAMS
1. Blender jug measuring cup and lid
2. Blender jug cover
3. Blender jug
4. Switch connector
5. Speed control
6. Power unit
7. Switch connector
8. Bowl axis
9. Mixing Bowl
10. Bowl cover
11. Measuring cup
12. Shredding knife
13. Slicing knife
14. Knife support
15. Whisking blade
16. Chopping blade
17. Blade support
18. Scoop
19. Protection cover
20. Juice drill
21. Juice filtration plate
5
OPERATING INSTRUCTIONS
A. MIXING FUNCTIONS:
1. Chopping function:

Place the protection cover onto the blender switch connector.

Place the mixing bowl on the bowl axis and turn clock-wise to lock it in place.

Place the blade support on the axis in the middle of the bowl and press downwards
until it locks into place. Place the chopping blade onto the blade support, holding the
plastic section of the blade.

Place food into the bowl. Ensure that the pieces of food are not too large, and cut
pieces of food that are too large. The ideal size is 2cm x 2cm x 2cm.

Place the bowl cover onto the unit and turn in a clock-wise direction until the cover
locks into place.

Use the speed control on the front of the unit to chop the food to the desired size.
Once chopped, ensure that the speed control is on “0” before opening the bowl cover.
2. WHISKING FUNCTION:

Follow the same procedure as for the chopping function, using the whisking blade
instead of the chopping blade.
3. SLICING AND SHREDDING FUNCTION:

Place the mixing bowl on the power unit and turn clock-wise to lock it in place.

Slide the slicing or shredding knife into the knife support. Place the knife support into
the mixing bowl, onto the axis of the mixing bowl

Place the bowl cover onto the unit and turn in a clock-wise direction until the cover
locks into place.

Turn the speed control to the desired speed, and insert food into the chute at the top
of the bowl cover. Insert the measuring cup into the chute and slowly press
downwards to push the food through the blade.

Once the food has been sliced or shredded, turn the speed control to “0” before
opening the bowl cover.
4. JUICING FUNCTION:

Place the mixing bowl on the power unit and turn clock-wise to lock it in place.

Attach the juice filtration plate and juice drill to the mixing bowl by inserting the juice
filtration plate onto the axis of the mixing bowl.

Cut the fruit to be juiced into halves. Turn the speed control to “1” and place one half
of the fruit onto the juice drill and press down slowly. For more effective juicing,
slowly turn the fruit in the opposite direction to the juice drill.

Once the fruit has been juiced, turn the speed control to “0”. Remove the juice
filtration plate from the bowl and pour out the juice.
B. BLENDER FUNCTIONS:

Place the mixing bowl on the power unit and turn clock-wise to lock it in place. Place
the bowl cover on the bowl and turn it until it locks into place.

Place the ingredients into the blender jug and place the blender jug cover onto the
unit, pressing down until it is tight.

Place the blender jug on the body, turning it in a clockwise direction until it locks.

Turn the speed control to the desired speed. Liquids can be added to the blender
using the small lid in the centre of the blender jug cover.

Once the ingredients have been mixed as required, turn the speed control to “0”.
Remove the juice filtration plate from the bowl and pour out the juice.
CLEANING AND MAINTENANCE

This appliance is for household use only and is not user-serviceable.

Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.

Always remember to unplug the unit from the electrical outlet when not in use
and before cleaning. Ensure that the speed control is set to “0”.

It is much easier to clean the accessories directly after they have been used.
Wash them in warm, soapy water, rinse and dry well.

The body of the appliance and the stand should be cleaned with a damp cloth.
Do not let water enter the appliance or the stand.

Do not use bleach or other abrasive substance or solvents to clean your
appliance as it can be damaging to the finish.
7

Do not immerse the mixer in water or any other liquid, or hold it under a running
tap to clean.

To remove stubborn spots/marks, wipe the surfaces with a cloth slightly
dampened in soapy water or mild non-abrasive cleaner. Rinse and dry a clean,
dry, soft cloth.
STORING THE APPLIANCE

Unplug the unit from the wall outlet and clean all the parts as instructed above.
Ensure that all parts are dry before storing.

Store the appliance in its box or in a clean, dry place.

Never store the appliance while it is still wet or dirty.

Never wrap the power cord around the appliance.
SERVICING THE APPLIANCE
There are no user serviceable parts in this appliance. If the unit is not operating
correctly, please check the following:

You have followed the instructions correctly

That the unit has been wired correctly and that the wall socket is switched
on.

That the mains power supply is ON.

That the plug is firmly in the mains socket.
If the appliance still does not work after checking the above:
- Consult the retailer for possible repair or replacement. If the retailer fails to resolve the
problem and you need to return the appliance, make sure that:

The unit is packed carefully back into its original packaging.

Proof of purchase is attached.

A reason is provided for why it is being returned.
If the supply cord is damaged, it must be replaced by the manufacturer or an authorised
service agent, in order to avoid any hazard. If service becomes necessary within the
warranty period, the appliance should be returned to an approved Amalgamated
Appliance (Pty) Ltd service centre. Servicing outside the warranty period is still available,
but will, however, be chargeable.
8
CHANGING THE PLUG
The unit is supplied with a 2 pin VDE plug.
If you wish to change the plug to a 3 pin, round pin plug, please connect as follows:
Green/Yellow = Earth
Blue
= Neutral
Brown
= Live
9
PLEASE AFFIX YOUR PROOF OF PURCHASE/RECEIPT HERE
IN THE EVENT OF A CLAIM UNDER WARRANTY THIS RECEIPT MUST BE
PRODUCED.
WARRANTY
1.
2.
Tedelex Trading (Pty) Limited (“Tedelex”) warrants to the original purchaser of this product
(“the customer”) that this product will be free of defects in quality and workmanship which
under normal personal, family or household use and purpose may manifest within a period of 1
(one) year from the date of purchase (“warranty period”).
Where the customer has purchased a product and it breaks, is defective or does not work
properly for the intended purpose, the customer must notify the supplier from whom the
customer bought the product (“the supplier”) thereof within the warranty period. Any claim in
terms of this warranty must be supported by a proof of purchase. If proof of purchase is not
3.
available, then repair, and/or service charges may be payable by the customer to the supplier.
The faulty product must be taken to the supplier's service centre to exercise the warranty.
4.
The supplier will refund, repair or exchange the product in terms of this warranty subject to
legislative requirements. This warranty shall be valid only where the customer has not broken
the product himself, or used the product for something that it is not supposed to be used for.
The warranty does not include and will not be construed to cover products damaged as a result
of disaster, misuse, tamper, abuse or any unauthorised modification or repair of the product.
5.
This warranty will extend only to the product provided at the date of the purchase and not to
any expendables attached or installed by the customer.
6.
If the customer requests that the supplier repairs the product and the product breaks or fails to
work properly within 3 (three) months of the repair and not as a result of misuse, tampering or
modification by or on behalf of the customer, then the supplier may replace the product or pay
a refund to the customer.
7.
The customer may be responsible for certain costs where products returned are not in the
original packaging, or if the packaging is damaged. This will be deducted from any refund paid
to the customer.
TEDELEX TRADING (PTY) LTD (JOHANNESBURG)
JOHANNESBURG
CAPE TOWN
DURBAN
TEL NO. (011) 490-9000
TEL NO. (021) 552-5161
TEL NO. (031) 792-6000
www.amap.co.za
10