Radio Shack Wireless Indoor/Outdoor Thermometer User`s guide

63-1088
large display wireless
indoor/outdoor thermometer
7KDQN\RXIRUSXUFKDVLQJ\RXU/DUJH'LVSOD\:LUHOHVV
,QGRRU2XWGRRU7KHUPRPHWHUIURP5DGLR6KDFN<RXFDQ
PRXQWLWRQDZDOORUSODFHLWRQDÁDWVXUIDFHXVLQJWKH
LQFOXGHGVWDQG<RXUWKHUPRPHWHUFDQFROOHFWDQGGLVSOD\
LQGRRUDQGRXWGRRUWHPSHUDWXUHVIURPXSWRWKUHH
VHQVRUV
The main unit requires two AA alkaline batteries and
the remote sensor requires two AAA alkaline batteries
for power. None are supplied; all are available at
RadioShack or online at www.radioshack com.
1. Remove the battery compartment covers from the
main unit and remote sensor, respectively. If you
are using more
than one sensor,
select a different
RESET
channel for each
sensor by switching
CHANNEL 1 2 3.
2. Place the
appropriate
batteries in each
compartment,
following the
polarity symbols
(+ and -) marked
inside.
NOTE
For best results,
always install
batteries in the
UHPRWHVHQVRUÀUVWDQGWKHQLQWKHPDLQXQLW
3. Reset each unit and replace the battery
compartment covers.
wall mounting
RQÁDWVXUIDFHV
Place the main unit indoors and the remote sensor outdoors.
3ODFHWKHPRQÁDWVXUIDFHVXVLQJWKHLUUHVSHFWLYHVWDQGV
(included).
Keyhole
Slot
Stand
6HOHFW\RXUWHPSHUDWXUHXQLWVZLWKWKHÝ&Ý)VZLWFKLQWKH
battery compartment.
2. Place your remote sensor near
your main unit.
3. Press SEARCH on your main unit
to search the signal from the
sensor. The reception icon blinks
on your main unit for about four
minutes.
7KHUHG/('ÁDVKHVZKHQHYHUWKH
SEARCH °C/°F
sensor transmits an RF signal to the
receiver.
battery notes
main unit and stand
user’s guide
• Replace batteries when the battery icon appears or the
GLVSOD\GLPV
‡ 'LVSRVHRIROGEDWWHULHVSURPSWO\DQGSURSHUO\
‡ 'RQRWEXUQRUEXU\EDWWHULHV
‡ 8VHRQO\IUHVKEDWWHULHVRIWKHUHTXLUHGVL]HDQG
UHFRPPHQGHGW\SH
‡ 'RQRWPL[EDWWHULHVRIGLIIHUHQWVL]HVRUFKHPLVWULHV
‡ ,I\RXGRQRWSODQWRXVH\RXUWKHUPRPHWHUV\VWHPIRUD
PRQWKRUPRUHUHPRYHWKHEDWWHULHV%DWWHULHVFDQOHDN
FKHPLFDOVWKDWFDQGDPDJHHOHFWURQLFSDUWV
thermo-sensor
This product is warranted by RadioShack against manufacturing defects in material and workmanship
under normal use for one (1) year from the date of purchase from RadioShack company-owned stores
and authorized RadioShack franchisees and dealers. For complete warranty details and exclusions,
check with your local RadioShack store.
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
04/04
Please read this user’s guide before
installing, setting up and using your new product.
www.radioshack.com
©2005. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
63-1088
02A05
Printed in China
• Keep the main unit and remote sensor dry. If they get
wet, wipe them dry immediately.
• Use and store the main unit only in room
temperature environments.
• Handle the main unit and remote sensor carefully. Do
not drop them.
• Keep the main unit and remote sensor away from
dust and dirt, and wipe them with a damp cloth
occasionally to keep them looking new.
• Never immerse the product in water. This can cause
electrical shock and damage the product.
• Do not subject the main unit to extreme force, shock,
RUÁXFWXDWLRQVLQWHPSHUDWXUHRUKXPLGLW\
• Do not tamper with the internal components.
• Do not mix new and old batteries or batteries of
different types.
• Do not use rechargeable batteries with this product.
• Remove the batteries if storing this product for a
long period of time.
• Do not scratch the display.
• Insert batteries and select the channel before mounting the
sensor.
• LLL or HHH appears when the temperature is out of range. See
6SHFLÀFDWLRQVIRUUDQJHLQIRUPDWLRQ
• If the temperature on your sensor does not match the one on your
main unit, press SEARCH to retrieve the signal again. Place the
sensor out of direct sunlight and moisture.
• Do not place the sensor more than 100 feet
(30.5 meters) from the main unit.
• Position the sensor facing the main unit, minimizing obstructions
such as doors, walls, and furniture.
• Place the sensor away from metallic or electronic objects.
• Position the sensor close to the main unit during cold winter
months, as below-freezing temperatures may affect battery
performance and signal transmission.
• If you still do not receive a signal, check the batteries,
obstructions, and remote unit location.
• Signals from household devices, such as doorbells, electronic
garage doors, and home security systems, may cause temporary
reception failure. This is normal and does not affect general
product performance. The reception will resume once the
interference ends.
• The display in outdoor thermometers remains operational to -4°F
(-20°C) with adequate power. If the unit’s performance fails due to
low temperature, the unit will resume proper functioning as the
temperature rises to within the normal temperature range.
Indoor Temperature Range ..........................23°F—122°F (-5°C—50°C)
Outdoor Temperature Range ..................... -4°F—140°F (-20°C—60°C)
Temperature Resolution ....................................................0.2°F (0.1°C)
Remote Sensor
Radio Frequency.................................................................. 433 MHz
Range ............................................... 100 feet (with no obstructions)
Transmission......................................................... Every 40 seconds
Channel Numbers....................................................................... 1—3
NOTE:6SHFLÀFDWLRQVDUHW\SLFDOLQGLYLGXDOXQLWVPLJKWYDU\
6SHFLÀFDWLRQVDUHVXEMHFWWRFKDQJHDQGLPSURYHPHQWZLWKRXW
QRWLFH,QGLYLGXDOXQLWVPD\YDU\$FWXDOSURGXFWPD\YDU\IURPWKH
LPDJHVIRXQGKHUH
1. Select an indoor wall for your main unit and an outdoor
wall for your remote sensor.
2. Remove the stands from the main unit and remote sensor,
respectively.
2. Drill a hole in the wall.
3. Thread a screw (not supplied) into the hole, letting it
extend about 3/16” from the wall.
4. Fit the head of the screw into the appropriate keyhole slot.
Your main unit displays current, minimum, and maximum
temperatures collected by the remote
CHANNEL
sensor and main unit. Outdoor data
is collected and displayed every 40
seconds and indoor data is collected
and displayed every 10 seconds.
• Press MEMORY to toggle between
MEMORY
current, maximum (MAX) and
minimum (MIN) temperatures.
• To clear the records, press and hold
MEMORY for 2 seconds. A beep will
VRXQGWRFRQÀUPWKDWWKHPHPRU\
has been cleared.
• To auto-scan between sensors, press
and hold CHANNEL for 2 seconds.
Press CHANNEL or MEMORY to end
auto-scan. Press CHANNEL to select
DVSHFLÀFFKDQQHO
temperature trend
This product tracks temperature changes. The trend line
shows the direction of the temperature change.
Trend
Description
rising
steady
falling
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult your local RadioShack store or an experienced radio/TV technician for help.
If you cannot eliminate the interference, the FCC requires that you stop using your product. Changes
RUPRGLÀFDWLRQVQRWH[SUHVVO\DSSURYHGE\5DGLR6KDFNPD\FDXVHLQWHUIHUHQFHDQGYRLGWKHXVHU·V
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
Product
large display wireless
indoor/outdoor thermometer
Model
63-1088
Responsible Party
RadioShack
300 RadioShack Circle
Fort Worth, TX 76102
Phone
817-415-3200