WCC100
IN-VEHICLE CHARGING CRADLE
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 1
OWNER’S
MANUAL
12/4/2013 10:38:04 AM
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 2
12/4/2013 10:38:04 AM
TABLE OF CONTENTS
INTRODUCTION��������������������������������������������������������������������� 2
Features��������������������������������������������������������������������������������������������2
Trademarks��������������������������������������������������������������������������������������2
IMPORTANT NOTICES���������������������������������������������������������� 2
ICES-001 and NMB-001 Compliance Statement����������������2
FCC Compliance Statement�������������������������������������������������������3
CAUTIONS and WARNINGS������������������������������������������������� 4
MATERIALS INCLUDED IN THIS PACKAGE����������������������� 5
INSTALLATION INSTRUCTIONS����������������������������������������� 6
OPERATING INSTRUCTIONS����������������������������������������������� 8
CHARGING CRADLE STATUS��������������������������������������������11
SPECIFICATIONS�����������������������������������������������������������������11
WARRANTY���������������������������������������������������������������������������12
1
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 3
12/4/2013 10:38:04 AM
INTRODUCTION
Thank you for choosing the Audiovox WCC100 In-Vehicle
Charging Cradle.
The WCC100 In-Vehicle Charging Cradle utilizes
Qi®(pronounced “Chee”) global interface standard for
inductive electrical power transfer. Qi technology makes
it possible to charge a Qi®-compatible mobile device via
electromagnetic induction simply by placing the device
into WCC100 Charging Cradle. There is no need to connect
any cables.
Features
• No mobile device charging cables to connect
• Windshield Suction Mount
• A
utomatic recognition of a Qi®-compatible mobile
device
• Operational status LED indicator
Trademarks
Qi®and are registered trademarks of Wireless Power
Consortium (WPC). All rights reserved.
IMPORTANT NOTICES
Canadian Compliance:
This ISM device complies with Canadian ICES-001
Cet appareil ISM est conforme à la norme NMB-001 du
Canada.
2
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 4
12/4/2013 10:38:05 AM
IMPORTANT NOTICES
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a digital
device, pursuant to Part 18 of the FCC Rules.
The product generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will occur in a particular installation. If the product does cause
harmful interference to radio or television reception, which can be determined
by turning the product on and off, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the product and the receiver.
•
Connect the product into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
FCC Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Radiation Exposure Statement: The equipment complies with FCC radiation limits
set forth for an uncotrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator & your body.
Declaration of Conformity
Trade name: AUDIOVOX
Model No.: WCC100
Responsible Party: AUDIOVOX Electronics Corp.
Address:
150 Marcus Blvd., Hauppauge, NY 11788 U.S.A.
This device complies with Part 18 of the FCC Rules. Operation is subject to the
following two conditions:
1.
This device may not cause harmful interference, and
2.
This device must accept any interference received, including
interference that may cause undesired operation.
3
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 5
12/4/2013 10:38:05 AM
CAUTIONS and WARNINGS
CAUTION: The WCC100 In-Vehicle Charging Cradle is
designed for in car use with an input voltage of 9VDC
to 16VDC via a vehicle power outlet. Do not connect to
higher input voltages. Use only the supplied power supply.
CAUTION: Do not place metal between the mobile device
and the WCC100 In-Vehicle Charging Cradle surface. Metal
between the charging surface and the mobile device will
increase temperature and stop the charging function.
CAUTION: Do not expose the WCC100 In-Vehicle Charging
Cradle to moisture.
CAUTION: Clean the WCC100 In-Vehicle Charging Cradle
using only a dry soft cloth. Do not use alcohol or other
cleaning solutions.
CAUTION: Ensure that the device cover used is not too
thick and does not contain metal parts. Any distance
between mobile device and charging surface will affect
charging efficiency and functionality.
WARNING: Do not mount the WCC100 In-Vehicle
Charging Cradle within the driver’s field of vision.
WARNING: Do not mount the WCC100 In-Vehicle
Charging Cradle in the deployment path of the vehicle’s
air bags.
4
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 6
12/4/2013 10:38:05 AM
MATERIALS INCLUDED IN THIS PACKAGE
Open the box and ensure that the contents listed below
are present. If any of the parts are missing, please contact:
Audiovox Technical Support 1-800-225-6074.
1
2
3
4
Figure 1. Materials Included
1. WCC100 In-Vehicle Charging Cradle P/N 31512250
2. Windshield Suction Mount P/N 31512060
3. CLA Power Cable P/N 31512161
4. Owner’s Manual P/N 31512020
5
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 7
12/4/2013 10:38:05 AM
INSTALLATION INSTRUCTIONS
1. Remove the protective wraps from the windshield
suction mount base (1) of the WCC100 In-Vehicle
Charging Cradle.
2. Locate a smooth level area in the vehicle or position
on the windshield so that it does not obstruct the
driver’s view. Clean the area.
3. Press the windshield suction mount base (1) firmly
against the mounting surface
4. Press the suction lever (2) down to secure the
windshield suction mount to the mounting surface.
NOTE: O
bserve all local laws and regulations pertaining to
the use of windshield mounted devices.
2
1
Figure 2. Windshield Suction Mount Base
6
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 8
12/4/2013 10:38:05 AM
5. Remove the protective wraps from the charging
cradle surface (3) and the brackets (4) of the charging
cradle.
6. Mount the charging cradle to the windshield suction
mount by sliding the clip (5) into the slot (6) on the
rear of the wireless charging cradle. Move the wireless
charging cradle upward to secure it to the windshield
suction mount.
7. Adjust the charging cradle position for a comfortable
viewing angle.
8. Connect the power cable to the charging stand (7)
then route the wire carefully to the vehicle power
outlet. Insure that the wire does not interfere with
any vehicle controls or safety devices such as airbags.
3
5
6
4
7
8
Figure 3. Attaching the Charging Cradle to the
Windshield Suction Mount
9. To adjust the charging cradle brackets and to release
the mobile device from the charging cradle surface,
press the release button (8).
7
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 9
12/4/2013 10:38:06 AM
OPERATING INSTRUCTIONS
NOTE: Before charging your mobile device please read
the mobile device manual thoroughly for charging
parameters.
1. Open the brackets of the WCC 100 by pressing
the release button (1), located on the backside of the
charger.
1
Figure 4. Docking Brackets Open
2. Place your Qi-compatible mobile device upon the
charger.
Figure 5. Placing Device on Charging Surface
8
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 10
12/4/2013 10:38:06 AM
3. Fasten the mobile phone by pressing the brackets
towards the phone.
Figure 6. Device Locked onto the Charging Surface
In the unlikely case, charging does not start automatically,
retry from beginning.
The integrated detection sensor will identify the
Qi®-compatible mobile device when it is placed on
the charging surface of the charging cradle. The charging
process will start automatically.
NOTE: Phone cases may interfere with charging. Do not
use any phone case that contains metal or metal particles
as it can cause the charger to not operate correctly. If you
place your Qi®-compatible mobile device into the charger
and it does not automatically start charging remove your
phone carry/protective case and insert the phone into the
charger to confirm operation.
9
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 11
12/4/2013 10:38:06 AM
The status of the WCC100 In-Vehicle Charging Cradle is
displayed by the integrated LED (1). Refer to Charging
Cradle Status Chart on page 11.
1
Figure 7. Charging Cradle
10
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 12
12/4/2013 10:38:06 AM
CHARGING STATUS
WCC100 In-Vehicle Charging Cradle Status Chart
Power OFF
LED OFF
Power ON
LED Flashes Green Three Times
Qi®- Device
Detected
LED Flashes Green Two Times
Charging
LED Lights Green
Charge Complete Check Phone Charging Status.
Device Error
LED Flashes Yellow Three Times
Charging Cradle
Error
LED Flashes Yellow Continuously
SPECIFICATIONS
Power Converter Specifications
Input: DC 9~16V
Charging Power: up to 5 Watt
Temperature range:- 20º to 50ºC
Power Cable length: 150 cm
Height 104mm
Depth 114mm
Width 72mm
Weight typ. 185g
NOTE: For best experience it is recomended that only Qi®
certified charging accessories are used.
NOTE: Specifications subject to change without notice.
11
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 13
12/4/2013 10:38:06 AM
12 MONTH LIMITED WARRANTY
AUDIOVOX Electronics Corporation (the Company) warrants
to the original retail purchaser of this product that should this
product or any part thereof, under normal use and conditions, be
proven defective in material or workmanship within 12 months
from the date of original purchase, such defect(s) will be repaired
or replaced with new or reconditioned product, (at the Company's
option) without charge for parts or repair labor.
To obtain repair or replacement within the terms of this Warranty,
the product is to be delivered with proof of warranty coverage
(e.g. dated bill of sale), authorization number, specification
of defect(s), transportation prepaid, to an approved warranty
station. This warranty is not transferable.
This Warranty does not cover damage to the vehicle's electrical
system or costs incurred for the installation, removal or
reinstallation of the product. This Warranty does not cover
batteries nor apply to any product or part thereof which, in the
opinion of the Company, has suffered or been damaged through
alteration, improper installation, mishandling, misuse, abuse,
neglect, accident, or by removal or defacement of the factory
serial number/bar code label(s).
This Warranty is in lieu of all other express warranties or liabilities.
ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED
12
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 14
12/4/2013 10:38:07 AM
WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE
DURATION OF THIS WRITTEN WARRANTY. ANY ACTION
FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY
IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT
WITHIN A PERIOD OF 24 MONTHS FROM DATE OF ORIGINAL
PURCHASE. IN NO CASE SHALL THE COMPANY
BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES
FOR BREACH OF THIS OR ANY OTHER WARRANTY.
No person or representative is authorized to assume for the
Company any liability other than expressed herein in connection
with the sale of this product.
The company does not warrant that this product cannot be
compromised or circumvented. THE EXTENT OF THE COMPANY'S
LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR
OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL
THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE
PAID BY PURCHASER FOR THE PRODUCT WITHOUT COST OF
INSTALLATION.
Some states do not allow limitations on how long an implied
warranty lasts or the exclusion or limitation of incidental or
consequential damage so the above limitations or exclusions may
not apply to you. This Warranty gives you specific legal rights and
you may also have other rights which vary from state to state.
Audiovox Electronics Corporation, 150 Marcus Blvd., Hauppauge, New York 11788
1-800-645-4994128-7939A
13
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 15
12/4/2013 10:38:07 AM
www.audiovoxproducts.com
128-9237B
2013 AUDIOVOX,150 Marcus Blvd. Hauppauge, NY 11788
P/N:7625000003C
128-9237B WCC100 In-Vehicle Charging Cradle 12 03 13.indd 16
31512020
12/4/2013 10:38:07 AM