- No category
ECHO LINEAR PENDANT ASSEMBLY INSTRUCTIONS FOR YOUR IMPORTANT SAFETY INSTRUCTIONS:
Add to my manuals
1 Pages
advertisement
ASSEMBLY INSTRUCTIONS FOR YOUR
ECHO LINEAR PENDANT
IMPORTANT SAFETY INSTRUCTIONS:
* These instructions are provided for your safety. It is very important that they are read completely before beginning the installation of
your fi xture.
* WE STRONGLY RECOMMEND INSTALLATION BY A LICENSED ELECTRICIAN.
* Turn off power at switch before replacing bulb, making sure fi xture has had suffi cient time to cool down.
(L)
OUTLET BOX
(M)
(N)
(C)
(A)
(F)
(G)
(H)
(H)
(H)
(B)
(D)
(J)
(K)
(E)
(M)
(I)
(L)
ASSEMBLY INSTRUCTIONS:
1. SHUT OFF THE MAIN ELECTRICAL SUPPLY AT
FUSE BOX/ CIRCUIT BREAKER.
2. Remove all parts from carton. Remove mounting
plate (B) from canopy (D) by removing canopy
screws (E). Set canopy screws (E) aside.
3. Lift the mounting plate (B) to the ceiling outlet box.
Once aligned, use a pencil to mark the locations of
mounting holes (M) on the outside edges of the
mounting plate.
4. Set the mounting plate aside and drill small holes at
the marked locations. Holes should be sized so
anchors (L) fi t securely inside.
5. Push anchors (L) into the holes. Attach mounting
plate (B) to ceiling outlet box using screws (C).
Thread screws (N) through holes (M) and into wall
anchors (L) to secure mounting plate to the ceiling.
6. Measure desired drop for fi xture to hang and add/
remove extension tubes (H) as needed. Guide wiring
through extension tubes before threading tubes
together.
**TO ADD/REMOVE EXTENSIONS: (Un)Thread the
threaded nipple of one extension into/out of the
threaded opening of the next extension. Make sure
electrical cord is pulled tight when threading
extensions together to prevent damage to the wiring.
7. Thread lowest extension tube (H) onto threaded tube
(I). Place quick link (F) through loop (G) to attach
extensions to canopy. Repeat steps for remaining sets
of extensions.
8. Lift canopy (D) to mounting plate (B) and make
proper electrical connections. A licensed electrician
is recommended.
9. Attach ground wire from fi xture (green or silver in color) to ground wire from outlet box. Fasten wires together with wire nut (A)
and tightly wrap connection with electrical tape.
10. Attach hot wire from fi xture (black in color or smooth side of wire) to hot wire from outlet box. Fasten wires together with wire nut
(A) and tightly wrap connection with electrical tape.
11. Attach neutral wire from fi xture (white in color or ribbed side of wire) to neutral wire from outlet box. Fasten wires together with
wire nut (A) and tightly wrap connection with electrical tape.
12. Carefully push wire connections back into ceiling outlet box. Place canopy (D) over mounting plate (B). Thread canopy screws (E)
into holes in canopy (F) and mounting plate (B) to secure fi xture to ceiling.
13. Place shade (M) over the socket. Slide split washer (L) between shade washer (J) and shade washer (K). Secure position of shade
(M) by turning shade washer (J) clockwise until it rests fi rmly against split washer (L). Repeat step for remaining shades.
14. Install four 60W MAX Type B, medium base bulbs into the sockets.
15. Reconnect main electrical supply from the fuse box/ circuit breaker and test the fi xture.
***To clean, use soft cloth only. Do not use any chemical or abrasive cleaners.***
S2156
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement