American Standard 2386.014 Indoor Furnishings User Manual
Add to my manualsAmerican Standard Colony 2388.012 is a vitreous china round front toilet with a low-consumption (6.0 Lpf/1.6 gpf) and a round front siphon action jetted bowl. It features a fully glazed 2" trapway, American Standard Aquameter™ Water Control, color-matched trip lever, sanitary bar on bowl, 2 bolt caps, and is 100% factory flush tested. The toilet meets or exceeds the following specifications: ASME A112.19.2M for Vitreous China Fixtures includes Flush Performance, Ball Pass Diameter, Trap Seal Depth, and all Dimensions.
advertisement
COLONY™
ROUND FRONT TOILET
VITREOUS CHINA
COLONY™ ROUND FRONT TOILET
❑ 2388.012
• Vitreous china
• Low-consumption (6.0 Lpf/1.6 gpf)
• Round front siphon action jetted bowl
• Fully glazed 2" trapway
• American Standard Aquameter™ Water Control
• Color-matched trip lever
• Sanitary bar on bowl
• 2 bolt caps
• 100% factory flush tested
❑ 3338.012 Bowl
❑ 4392.016 Tank
Nominal Dimensions:
711 x 508 x 743mm
(28" x 20" x 29-1/4")
Fixture only, seat and supply by others
Alternate Tank Configurations Available:
❑ 4392.500 Tank complete with Aquaguard Liner
❑ 4392.800 Tank complete with trip lever located
on right side
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.2M for Vitreous China Fixtures -
includes Flush Performance, Ball Pass Diameter,
Trap Seal Depth and all Dimensions
FINISHED WALL
711mm
(28)
19mm ± 6mm
(3/4 ± 1/4)
229mm
(9)
419mm
(16-1/2)
C/L OF SEAT POST HOLES
140mm (5-1/2 CENTERS)
159mm
(6-1/4)
305mm
(12)
16mm
(5/8)
308mm
(12-1/8)
C/L OF OUTLET
381mm
(15)
SUPPLY
AS
REQ'D
*
203mm
(8)
FINISHED
FLOOR
152mm
(6)
508mm
(20)
C/L
365mm
(14-3/8)
235mm
(9-1/4)
743mm
(29-1/4)
To Be Specified:
❏ Color: ❏ White ❏ Bone ❏ Linen
❏ Seat: American Standard #5322.011 “Rise and
Shine” solid plastic closed front seat with cover.
❏ Seat: American Standard #5308.014 “Laurel”
molded closed front seat with cover.
❏ Alternate Seat:
❏ Supply with stop:
NOTES:
THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION
OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET.
* DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED.
SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
K96
© 2008 AS America Inc.
Revised 2/08
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project