advertisement
Smoke Resistant Box
MODEL
AH-69601
OWNER’S MANUAL
2
TO THE OWNER
Before operating this Projector, read this manual thoroughly and operate the projector properly.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE EXCEPT FILTER REPLACEMENT. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
THIS SYMBOL INDICATES THAT DANGER-
OUS VOLTAGE CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT WITHIN
THIS UNIT.
THIS SYMBOL INDICATES THAT THERE
ARE IMPORTANT OPERATING AND MAIN-
TENANCE INSTRUCTIONS IN THE OWN-
ER'S MANUAL WITH THIS UNIT.
WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
Provide appropriate space on the top, sides and rear of the Projector and Smoke Resistant Box for allowing air circulation and cooling the Projector. Minimum clearance must be maintained. If the Projector is to be built into a compartment or similarly enclosed, the minimum distances must be maintained. Do not cover the ventilation slot on the Projector and Smoke Resistant Box. Heat buildup can reduce the service life of your projector and Smoke Resistant Box, and can also be dangerous.
READ AND KEEP THIS OWNER'S MANUAL FOR LATER USE.
Federal Communication Commission Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes or modifications should be made, you could be required to stop operation of the equipment.
CAUTION
This is a Class A equipment. This equipment can cause interference in residential areas; in this case, the operator can be asked to take adequate countermeasures.
The CE Mark is a Directive conformity mark of the European Community (EC).
FEATURES
TABLE OF CONTENTS
FEATURES ················································································································ 3
PART NAMES ············································································································ 4
INSTALLATION ········································································································· 5
OPERATION ·············································································································· 7
FILTER REPLACEMENT···································································································· 8
FILTER TIME CHECK AND RESET··················································································· 10
APPENDIX ·················································································································11
MAINTENANCE ················································································································· 11
TROUBLESHOOTING········································································································ 11
DIMENSIONS····················································································································· 12
SPECIFICATIONS ·············································································································· 12
FEATURES
• The Smoke Resistant Box protects the projector from dust and cigarette smoke by adopting a highly efficient filter.
• Provide two powerful silent rotary fans, and cool down the Projector efficiently.
• It has been designed for easy mounting.
3
PART NAMES
PART NAMES
MOUNTING SCREWS
(provided on each corner)
(Screws are provided in the holes)
FILTER COVER
(AIR INTAKE VENTS)
FRONT
INDICATORS
FILTER
REAR
CONNECTOR
4
INSTALLATION
INSTALLATION
Please ensure that there is sufficient clearance around the unit at the time of installation, as shown in the figure on the right.
WARNING: DO NOT COVER INTAKE
VENTS.
If the Air Intake is covered, there will be insufficient cooling which may result in failure or fire.
At least 20'' (50cm)
At least
30''
(75cm)
At least
40''
(100cm)
AIR INTAKE VENTS
FRONT
CAUTION:UNPLUG THE PROJECTOR FROM THE AC OUTLET WHEN INSTALLING THE
SMOKE RESISTANT BOX.
ATTACHING THE SMOKE RESISTANT BOX WHILE THE PROJECTOR IS CONNECTED TO
ELECTRICITY MAY DAMAGE THE BOX OR CAUSE IT TO MALFUNCTION.
1
Take out the Smoke Resistant Box from the packaging and place it on a flat surface with the projector.
2
Take off the connector cover from the Projector.
RETAIN THE CONNECTOR COVER.
WHEN THE SMOKE RESISTANT BOX IS NOT
BEING USED, REATTACH THE CONNECTOR
COVER TO THE PROJECTOR TO PROTECT
THE CONNECTOR.
CONNECTOR COVER
5
INSTALLATION
3
Align the connector of the Projector with the connector pins of the Smoke Resistant Box.
CAUTION:TAKE CARE NOT TO TOUCH
THE CONNECTOR OR APPLY SHOCK
THAT MAY DAMAGE THE CONNECTOR.
PINS
4
Hold the Smoke Resistant Box parallel to the
Projector and push it slowly towards the Projector.
5
Hold the Smoke Resistant Box with one hand and use a Phillips-head screwdriver to tighten the four fixed screws to fix the box in place.
PHILLIPS-HEAD
SCREWDRIVER
6
Check that the Smoke Resistant Box is fixed in place with the four screws and no wide gap exists between the projector body and the box.
THERE SHOULD BE NO WIDE GAP THERE SHOULD BE NO WIDE GAP
6
OPERATION
OPERATION
When the Projector is turned on, the POWER indicator lights in green.
* When the POWER indicator does not light and the WARNING FILTER indicator flashes, the filter is not attached to the Smoke Resistant Box. In this case, the READY indicator on the Projector does not light and the Projector can not be turned on.
ORANGE
GREEN RED
INDICATORS
INDICATORS OPERATION
WARNING FILTER . . . . Normally this does not light. Should the filter become clogged with dust particles indicator flashes orenge. When the filter needs to be replaced, indicator lights in orange. The filter should then be replaced immediately. When the filter is not attached, the indicator will flash.
WARNING . . . . . . . . . . Normally this does not light. When the box's fan is operating abnormally, indicator flashes red. When this occurs, turn off power immediately and request a maintenance check. Do not leave the Smoke Resistant Box operational while the indicator is flashing as it may become a fire and/or accident hazard.
When the Smoke Resistant Box is used for the first time, the initial set-up should be performed in the following procedures. The Smoke Resistant Box cannot be operated or handled properly without this initial set-up.
1
First, properly attach the Smoke Resistant Box to the Projector.
2
Turn on the Projector and display some images.
Check that each indicator on the Smoke Resistant
Box lights normally.
Go to next page
ON OFF OFF
7
OPERATION
3
Select [SPECIAL] in the Projector's menu. Then select [Filter].
4
Select [Option box] and then select [Reset] and then [ Yes].
A message [Please wait---] will appear.
When this message disappears initial set-up is complete. Close the menu.
8
FILTER REPLACEMENT
When replacing the filter, replace with a specified filter. A replacement filter can be ordered through your dealer. When ordering the filter, give the following information to the dealer.
• Replacement Filter type No. : AH-69641(POA-FIL-140)
• Smoke Resistant Box type No. : AH-69601
CAUTION:WHEN REPLACING THE FILTER, TURN OFF THE PROJECTOR.
1
Press the PUSH button on the filter cover.
PUSH BUTTON
2
Open the filter cover and take out the used filter.
USED FILTER
FILTER COVER
3
Install the new filter.
CAUTION:USE ONLY REPLACEMENT
FILTERS RECOMMENDED BY THE
MANUFACTURER. THE USE OF OTHER
FILTERS MAY CAUSE THE BOX TO
MALFUNCTION OR ACCIDENT MAY
RESULT.
CAUTION:TAKE CARE NOT TO DAMA-
GE THE FILTER DETECTION SWITCH
LOCATED INSIDE THE BOX WHEN IN-
SERTING THE FILTER.
FILTER DETECTION
SWITCH
NEW FILTER
4
Check that the filter is not tilted or warped and then close the filter cover. This will lock it into place.
OPERATION
5
Reset the filter time.
Refer to "FILTER TIME CHECK AND RESET"
9
OPERATION
FILTER TIME CHECK AND RESET
•
•
The filter operation time can be checked in the projector menu.
Open [INFORMATION] in the menu and check
[Option filter time] for the hour counter.
※ "Option filter time" menu will not exist when Smoke
Resistant Box is not attached on the projector.
Reset the filter time according to the following procedures:(Only reset the filter time when changing the filter.
The Smoke Resistant Box cannot be operated properly if it is reset other than filter change.)
1
Check that the Smoke Resistant Box is properly attached to the projector.
2
Turn on the projector and display the screen.
Check all indicators on the Smoke Resistant Box light normally.
3
Select [SPECIAL] in the projector's menu. Then select [Filter].
4
Select [Option box] and then select [Reset] and then
[Yes].
ON OFF OFF
10
5
A message [Please wait--] will appear. When it disappears Filter Time reset is completed. Close the menu.
APPENDIX
MAINTENANCE
•
•
•
•
•
IF THE SMOKE RESISTANT BOX IS NOT USED LONG PERIOD OF THE TIME.
Remove the Smoke Resistant Box from the Projector and store in safe place.
CARE AND CLEANING OF THE CABINET.
Remove stains on the cabinet with a soft cloth. If the stain is particularly stubborn, use a cloth soaked in a heavily diluted mild detergent, and finish with a dry cloth.
CARE FOR THE CABINET.
Do not apply volatile solvents such as insecticide to the cabinet or bring the casing into contact with rubber, adhesive tape or vinyl products for a long time. This may result in degradation and paint scratches.
DO NOT USE BENZENE OR THINNER.
If benzene or thinner is used, cabinet may be damaged. When using a chemical cloth, please follow the instructions carefully.
CLEANING AIR INTAKE VENTS.
When using under dusty or smoky conditions, the performance may be impaired.
Remove dust frequently using a vacuum cleaner, etc.
TROUBLESHOOTING
NO POWER.
WARNING FILTER
INDICATOR ILLUMI-
NATES ORANGE.
• Check that the Projector is connected to a power source.
• Check that the POWER indicator is illuminated green.
• When the WARNING indicator flashes red, the built-in rotary fan has malfunctioned and halted operation. Please consult with your dealer agent.
• Check if the orange WARNING FILTER indicator is flashing. The filter may have come loose.
• When the WARNING FILTER indicator flashes or lights in orange, the filter should be replaced with a new filter immediately.
11
APPENDIX
DIMENSIONS
18.1''
(461mm)
6.5''
(165mm)
TOP
8.5''
(216mm)
FRONT
SPECIFICATIONS
SMOKE RESISTANT BOX
TYPE
AIR CAPACITY
INDICATORS
OPERATING CONDITIONS
DIMENSIONS
NET WEIGHT
Projector smoke proof and dustproof box
3
Approximately 2.0m /min
POWER, WARNING FILTER, WARNING
41 to 95 (5 to 35 ) (indoors)
6.5''x8.5"x18.1" (165mm x 216mm x 461mm)
Approximately 7.5lbs (3.4Kg)
ACCESSORIE
Owner's Manual 1 Smoke Resistant Box
RIGHT SIDE
12
Printed in Japan
A-key to better communications
U.S.A.
EIKI International, Inc.
30251 Esperanza
Rancho Santa Margarita
CA 92688-2132
U.S.A.
Tel : 800-242-3454 (949)-457-0200
Fax : 800-457-3454 (949)-457-7878
E-Mail : [email protected]
Deutschland & Österreich
EIKI Deutschland GmbH
Am Frauwald 12
65510 Idstein
Deutschland
Tel : 06126-9371-0
Fax : 06126-9371-14
E-Mail : [email protected]
Canada
EIKI CANADA - Eiki International, Inc.
P.O. Box 156, 310 First St. - Unit 2,
Midland, ON, L4R 4K8, Canada
Tel : 800-563-3454 (705)-527-4084
Fax : 800-567-4069 (705)-527-4087
E-Mail : [email protected]
Eastern Europe
Umelecká 15
170 00 Praha 7
Czech Republic
Tel : +42 02 20570024
+42 02 20571413
Fax : +42 02 20571411
E-Mail : [email protected]
Japan & Worldwide
EIKI Industrial Company Limited.
4-12 Banzai-Cho, Kita-Ku, Osaka,
530-0028 Japan
Tel : +81-6-6311-9479
Fax : +81-6-6311-8486
E-Mail : [email protected]
WorldWide Website http://www.eiki.com
© 2004 Eiki International, Inc.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
Frequently Answers and Questions
What are the minimum clearances required for installation?
What should I do if the WARNING FILTER indicator flashes orange?
What should I do if the WARNING indicator flashes red?
How do I reset the filter time?
What type of replacement filter should I use?
advertisement
Table of contents
- 3 FEATURES
- 4 PART NAMES
- 5 INSTALLATION
- 7 OPERATION
- 8 FILTER REPLACEMENT
- 10 FILTER TIME CHECK AND RESET
- 11 APPENDIX
- 11 MAINTENANCE
- 11 TROUBLESHOOTING
- 12 DIMENSIONS
- 12 SPECIFICATIONS