Trendnet TL2-G244 24-Port Gigabit Layer 2 Switch Quick Installation Guide

Troubleshooting

1. How do I configure TCP/IP settings on my computer?

Windows 7

1. Go into the Control Panel, click Network and Internet, click Network and Sharing Center, click Change

Adapter Settings and then right-click the Local Area

Connection icon and then click Properties.

2. Click Internet Protocol Version 4(TCP/IPv4) and then click Properties. Then click on Use the following IP

address, and make sure you assign your network adapter an IP address in the subnet of 192.168.10.x.

Windows Vista

1. Go into the Control Panel, click Network and Internet, click Network and Sharing Center, click Manage

Network Connections and then right-click the Local

Area Connection icon and then click Properties.

2. Click Internet Protocol Version 4(TCP/IPv4) and then click Properties. Then click on Use the following IP

address, and make sure you assign your network adapter an IP address in the subnet of 192.168.10.x.

Windows XP / 2000

1. Go into the Control Panel, double-click the Network

Connections icon and then right-click the Local Area

Connection icon and then click Properties.

2. Click Internet Protocol Version (TCP/IP) and then click

Properties. Then click on Use the following IP

address, and make sure you assign your network adapter an IP address in the subnet of 192.168.10.x.

9

2. I typed http://192.168.10.200 in my Internet Browser's Address Bar, but an error message says “The page cannot be displayed.” How can I get into the TL2-G244's web configuration page?

1. Check your hardware settings again by following the instructions in section 2.

2. Make sure the PWR(Power), SYS(System) and Link/ACT lights are lit.

3. Make sure your network adapter’s TCP/IP settings are configured properly (see Q1).

4. Since the Switch's default IP address is 192.168.10.200, make sure that no other network devices are assigned an IP address of 192.168.10.200.

3. If my Switch IP is different than network’s subnet, what should I do?

You should still configure the Switch first. After all the settings are applied, go to the Switch's configuration page, click on Administrator, click IP & Management Mode and change the IP address of the Switch to match your network's IP.

4. What are the default port settings for configuring the Switch through the console port using HyperTerminal?

Bits per Second: 115200; Data bits: 8; Parity: None; Stop bits: 1; Flow control: None.

5. I changed the IP address of the switch, but I forgot it. How do I reset my TL2-G244?

Follow the instructions below:

1. Take a pin or paper clip and press the reset button on the front of the switch

2. Wait 15 seconds then let go.

The default IP address of the switch is 192.168.10.200. The default user name and password is admin.

6. How do I enable Telnet on my Windows 7/Vista computer?

Follow the instructions below:

Windows 7

1. Go to Control panel and click Programs.

2. Click Turn Windows features on or off.

3. Check the box next to Telnet client and then click OK.

4. Please wait while Windows enables Telnet.

Windows Vista

1. Go to Control Panel and click on Classic View.

2. Click on Programs and Features.

3. Click Turn Windows features on or off.

4. Check the box next to Telnet Client and then click OK.

5. Please wait while Windows enables Telnet.

If you still encounter problems or have any questions regarding the TL2-G244 please contact

TRENDnet's Technical Support Department.

10

Copyright ©2010, All Rights Reserved. TRENDnet.