advertisement
To install your XM-EXT50 please follow the
instructions and illustrations listed below:
Step 1
Remove rubber boot as shown.
Step 2
Insert antenna's connector through the rubber boot as illustrated and into amplifier's connector. Replace rubber boot.
Step 3
Insert the cable's connector into the connector marked
ANT or Antenna on the XM receiver or Plug & Play system.
Warning
DO NOT attempt to cut, splice or otherwise shorten the cable!
Any remaining length should be carefully coiled.
DO NOT kink the cable. Avoid bending cable with a bend radius of less then 1 inch.
DO NOT expose the cable to severe environmental conditions. Care should also be taken to avoid direct and high moisture areas.
DO NOT link more than two extension kits.
Step 1 Step 2 Step 3 Yes No
LINE OUT
DC IN 6V
ANT
Please mount amplifer upright as shown above.
Please refer to the XM-EXT50 user guide included with your receiver to complete your XM system set up.
s* em yst o S adi e R llit ate M S l X al ith e w us For
Specifications
Cable Length 50 feet
Cable Type
Frequency
Amplifier Gain
Return Loss
Connectors
RG-58
2300 to 2400 MHz
10dB +/- 1 dB @ 2300 MHz
-10dB
SMB
I nstallation instructions printed on the inside of this card.
50' EXTENSION KIT
For additional information:
Call 1.800.942.TERK (8375) or visit www.terk.com
For additional information about XM Satellite Radio service visit www.xmradio.com
Made in China
One year limited warranty
The XM name and related logos are trademarks of
XM Satellite Radio inc.
TERK and TERK Technologies are trademarks of
TERK Technologies Corp. Commack, NY
©2004 TERK Technologies Corp.
136P003 tallation options ellite Radio in any onment invir
of XM Sat
• Extends the ins
• Indoor/Outdoor
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project