C50 Audio Preamplifier Connection Diagram 3

2A
C50 Audio Preamplifier Connection Diagram 3
Note:Refer to the C50 Owner’s Manual page 9 for additional connection information.
A/V Control Center
Connection Legend:
Data Cable*- Digital Signal Cable Sensor/Keypad Cable - RS232 Cable Power Control Cable* -
Ground Wire Audio Signal Cable - AC Power Cords Video Signal Cable - Loudspeaker Cable RF Signal Cable - * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
Power Amplifier (Left Channel) - Main Room
(Partial View)
Connect to
AC Outlet
Connect to
AC Outlet
Power Amplifier (Right Channel) - Main Room
(Partial View)
Connect to
AC Outlet
Connect to
AC Outlet
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
Part No. 04124900
2B
C50 Rear Panel Connections
MAIN OUTPUTS
send signals to a
Power Amplifier
BALanced OUTPUTS 1 and 2 send
signals to Power Amplifiers and
are switched On/Off with the Front
Panel Output 1 and 2 Push-Buttons
or Remote Control Push-Buttons
PROCESSOR FROM
and TO allows an external signal processor
to be connected
MAIN OUTPUTS
BALANCED send
signals to a Power
Amplifier
RECORD OUT sends
signals to the input of
a recording device
BALanced INPUTS 1
and 2 accept high level
program source signals
GND terminals
accept a ground
wire from a
turntable
SRVR, AUX, DVD, CD2,
CD and TUNER INPUTS
accept high level program
source signals
PHONO MC accepts
the low level signals
from a Moving Coil
Phono Cartridge
PHONO MM accepts
signals from a Moving Magnet Phono
Cartridge
DIGITAL AUDIO INPUTS
1 and 2 for components
with a Digital Optical Output sending a digital audio
signal
OUTPUTS 1 and 2 send signals to
Power Amplifiers and are switched
On/Off with the Front Panel Output
1 and 2 Push-Buttons or Remote
Control Push-Buttons
RS232C connector
for connection to a
computer or other
control device
DIGITAL AUDIO INPUTS
3 and 4 for components
with a Digital Coaxial Output sending a digital audio
signal
Connect the C50 power
cord to a live AC outlet.
Refer to information on
the back panel of your
C50 to determine the
correct voltage for your
unit
PASS-THRU Power
Control Input receives
turn On/Off signals
from an Audio/Video
Control Center
POWER CONTROL
MAIN Output sends
turn On/Off signals to
a McIntosh Component when the C50 is
switched On/Off
POWER CONTROL
TRIGger outputs 1
and 2 send turn On/
Off signals to assignable components
POWER CONTROL OUTPUT 1 and 2 send Turn On/Off
signals to a Power Amplifier(s)
when activated
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
DATA INput receives
data from an external
control device
IR INput for
signals from a
compatible IR
Room Sensor
USB D/A DIGITAL
AUDIO INPUT
with control signal
for connection to a
computer
DATA PORTS send
signals to Source
Components to allow
control with the C50
Remote Control
Open as PDF
Similar pages