Lil` Buttie Ranger™ Telephone Test Set

COMMUNICATIONS test & measurement Solutions
Lil’ Buttie Ranger™
Telephone Test Set
Key Features
• Provides DSL-safe operation
• Views and stores digits as dial-out is in progress
• Identifies inbound and outbound lines
• Senses under- and over-voltage conditions
• Detects and displays caller ID and call waiting caller ID
• Alphanumeric LCD with icon flags
• Hands-free operation even with hard hat on
• Eliminates popping and clicking when attaching to a line
Applications
•POTS installation and service in the
presence of DSL
•Temporary communication handset
•Telephone and data line installation
and service
The Lil’ Buttie Ranger™ Telephone Test Set is an advanced, DSL-safe telephone
test set for use by data­com, telecom, and cable installers and repair technicians.
The compact test set is small enough to wear on a belt or fit in a pocket and
features a shape that is comfortable to hold. The LCD display shows on-hook
voltage, off-hook current, and polarity as well as caller ID, call waiting caller ID,
number dialed, setup, scrolling list of stored numbers, battery condition, and
other information.
Advanced features of the Ranger include DigiView™ DTMF decode, for showing
and capturing digits as dial-out is in progress; Auto Dial Line Identification
(ADLI), for inbound and outbound line identification with caller ID testing;
Trafixguard™, for sensing digital lines and identifying under- and over-voltage
conditions; Insta-Talk™, an amplified speaker with simultaneous intercom
capa­
bility for talking while testing; and Wink Detector, for display of line
reversals.
website : www.jdsu.com/know
Lil’ Buttie™ Ranger Telephone Test Set
Specifications
General
Interfaces
Telephone system
Modular telco
Headset 2.5 mm cell-phone type
Ringer Equivalence
In Bell mode
0.0 (no ringer load)
Pulse Dialing
Pulse rate
10 pps ±0%
Make/break ratio
40% to 60% ±2%
Interdigit interval
820 ms
Resistance during break
120 kΩ
Tone Dialing
DTMF output (into 600Ω)
Tone-frequency error
±1.5%
Tone level
– High group
–6 ±2 dB
– Low group
–8 ±2 dB
High vs low difference: 2 ±1 dBm
Flash Duration
600 ms ±50 ms or 100 ms ±10 ms, set at factory
Pause Duration
Tone3 s
Pulse3.4 s
Memory
Battery backed-up memory stores eight programmed
phone numbers (24 numbers ea) and associated names
(16 characters), plus last-number redial.
Memory retention with battery
>2 yrs
Return Loss 14 dB at 600 Ω
Line-Current Range
5 to 120 mA
Apparent Line Resistance 275 at 20 mA
Monitor Mode Impedance >230 kΩ
Measurement
Voltage
0 to 128 V DC ±5%
Current
10 to 140 mA ±5%
User Controls
– One left-side-mounted TALK/BELL/MON slide switch for
operating mode
– One right-side-mounted microphone mute push button
(tap to lock or hold down)
– Six front-mounted push buttons for various options
– One standard, front-mounted, 12-key phone keypad
Indicator
One front-mounted, 2-line x 16-character reflective,
gray-mode, super-twisted liquid-crystal display (LCD) panel
Connectors
To telephone network RJ12 (6-wire RJ11) female
To headset
2.5 mm cell phone headset jack
Power
From a 9 V DC alkaline battery, typical, included:
Bell mode (timed out)
20 μA
Talk mode
CWCID
Off
4 mA
CWCID on
12 mA
Monitor mode
27 mA
Battery Life
For a typical 9 V DC, 540 mA-hr alkaline battery (included)
Operating
20 hrs (min), 112 hrs (max)
Standby
1 yr
Typical
25 to 40 hrs
Lil’ Buttie Ranger Telephone Test Set
for Australia LB255AUS
– For 100 ms hook flash, 37/63 make/break ratio,
Australia caller ID settings (outside North America)
– Includes 1.22 m (4 ft) RJ11 to angled bed-of-nails cord
set (LB35), headset with boom microphone (LB40B),
and 9-volt battery.
Lil’ Buttie Ranger Telephone Test Set for United Kingdom
LB255UK
– For 100 ms hook flash, 37/63 make/break ratio,
UK caller ID settings
– Includes 1.22 m (4 ft) RJ11 to angled bed-of-nails
cord set (LB35), headset with boom microphone (LB40B),
and 9-volt battery.
Environmental
RJ11 to piercing pin clips, 1.22 m (4 ft)
with strain relief
RJ11 to angled bed-of-nails clips, 1.22 m (4 ft)
with strain relief
RJ11 to alligator clips, 1.22 m (4 ft)
with strain relief
Headset with boom microphone,
mini over-the-ear
Headset with cushioned earpiece,
full over-the-head
Modular adapter, 4-position
Modular adapter, 6-position
Modular adapter, 8-position
Belt clip, two-piece swivel
Belt clip, rugged hook-type on battery door
Protective rubber boot
Maximum altitude Temperature
– Operating
– Storage Humidity tolerance
Enclosure 3048 m (10,000 ft) operating
0 to 50° C (32 to 122° F)
–20 to 60° C (–4 to +140° F)
10 to 90%, non-condensing
High-strength ABS plastic
Physical
Length (w/o lanyard)
Width
Height
Weight (with cable set)
18.4 cm (7.25 in)
6.4 cm (2.50 in)
4.3 cm (1.68 in)
<284 gm (10 oz)
Ordering Information
Lil’ Buttie Ranger Telephone Test Set LB255
– Includes 1.22 m (4 ft) RJ11 to angled bed-of-nails
cord set (LB35), headset with boom microphone (LB40B),
and 9-volt battery.
Lil’ Buttie Ranger Telephone Test Set LB255-BT
with protective boot
– Includes protective boot (LB81), 1.22 m (4 ft) RJ11 to
angled bed-of-nails cord set (LB35), headset with boom
microphone (LB40B), and 9-volt battery.
Lil’ Buttie Ranger Telephone Test Set LB260-BT
with hook-type belt clip and protective boot
– Includes rugged hook-type belt clip (LB75), protective boot (LB81), 1.22 m (4 ft) RJ11 to angled bed-of-nails cord set (LB35), headset with boom microphone (LB40B) and 9-volt battery.
Accessories
LB20B
LB35
LB10B
LB40B
LB45B
LB64
LB66
LB68
LB60B
LB85B
LB81
Warranty
JDSU guarantees that its products will be free of all defects
in material and workmanship. This warranty extends for
the period of 12 months for test instruments and 3 months
for cables from date of manufacture or purchase (proof of
purchase required).
All products deemed defective under this warranty will be
repaired or replaced at the discretion of JDSU. No further
warranties either implied or expressed will apply, nor will
JDSU assume responsibility for operation of this device.
Test & Measurement Regional Sales
NORTH AMERICA
LATIN AMERICA
ASIA PACIFIC
TEL: 1 866 228 3762
FAX: +1 301 353 9216
TEL: +1 954 688 5660
FAX: +1 954 345 4668
TEL: +852 2892 0990
FAX: +852 2892 0770
EMEA
TEL: +49 7121 86 2222
FAX: +49 7121 86 1222
WEBSITE: www.jdsu.com/know
Product specifications and descriptions in this document subject to change without notice. © 2012 JDS Uniphase Corporation 30149351 001 0212 LBRANGER.DS.NET.TM.AE
February 2012
Open as PDF
Similar pages