micro g2 - London Satellite Shop

Now with
• Measure on two LNB´s at the same time (920-2150MHz)
• Spectrum-analyzer with zoom function
• EasyFind satellite identification for faster installations
• Super bright 3” LCD display
• Very sensitive, easy to maximize weak and strong signals
• Digital BER, QPSK and S/N-ratio
• Readout NIT -gives Satellite ID and TV/Radio-channel info
• DiSEqC according to level 1.0, 1.1 and 1.2
• LNB voltage 13/18V, 22KHz tone switch
• Stores up to 99 memory positions
• RS232 for PC-connection (up/download)
• Built in, rechargeable battery
• Nice & small, only 1,5Kg complete with carrying case
• Made in Sweden
The SATLOOK MICRO G2 is a swedish
made SAT-TV instrument.
The unit is made for exact alignment and adjustment of satellite-dishes.
The new ”EasyFind”-function makes it very easy to find and maximize a
specific satellite (chosed from a list). In this mode the meter will use its
full capacity to search only for unique parameters of that satellite. This
will help the installer to make very fast and accurate installations. The
”Easyfind”- mode also recall the last selection used when powered up.
Technical specification
Input frequency:
Sat-TV min level in:
About 35 dBuV (noise).
Sat-TV max level in:
About 100 dBuV.
Input/output impedance:
75 Ohm, F-connectors.
Measuring method (analog):
Spectrum analyzer
Signal presentation on LCD -display in
form of thermometer scales.
Pitch-tone, highest tone on loudspeaker.
It is intended for professional use when high accuracy and precise information are needed.
It´s easily operated without a lot of unnecessary buttons and knobs. The
basic functions are easy to get a hold on and takes only minutes to learn.
The instrument is provided with a 3” LCD which either shows Sat-signal
strength or Digital information.
The SATLOOK MICRO G2 is unique as it can measure satellite signal from
two LNBs at the same time. Signalstrength is presented graphical on the
LCD-display in form of thermometer-scales. It can present pitchtones (the
higher tone the better signal) on a loudspeaker.
This second generation of the MICRO, G2, can also present the Satellite
spectrum, freq: 950-2150 MHz in different steps of resolution.
Further more the SATLOOK MICRO G2 show Digital information like BER
(bit error rate), constellation-diagram (QPSK) and S/N (signal/noise ratio).
The NIT function can identify the various TV-satellites by reading out the
NIT in the Bitstream (NIT = Network Information Table). The NIT also contains info about the transponders TV and Radio-channels.
SATLOOK MICRO G2 can store up to 99 positions of Satellite transponder
information. The instrument can easily scan through the memory positions
and identify the various Satellite transponders.
The polarisation of the LNB is switchable 13V/18V and the Hi-Lo band with
22 kHz-tone. The DiSEqC-function controls all DiSEqC-accessories (like
switches, LNB´s and actuators).
The power of the instrument is supplied by a built in and rechargeable battery. Even though the instrument has a lot of functions it is still very light
and flexible.
Measuring method (Digital):
BER (bit error rate)
S/N (signal/noise-ratio)
Constellation (QPSK)
Thermometer scales showing max.
Maxhold function.
BER, S/N and QPSK showing max.
Yes, by reading out the NIT in the
bitstream. Info about the TV and Radio
Up to 99 transponders can be stored
with name.
Memory locks on:
FEC, Symbol-rate Frecuency, 13/18v,
Memory search:
The instrument scans the memory
positions and presents the matching
On LCD 3”
Yes, RS232-output
Power out:
Yes, 13-18V.
22 kHz tone:
Yes, on/off.
Yes, all 1.0 and 1.1. Also Toneburst on/off.
DiSEqC actuator:
Built in positioner for DiSEqC 1.2, SatScan and SatSelect.
Rechargable 12v, 3.5amp/hour.
About 1 hour on a fully charged Battery.
1.5kg incl.battery & carrying case.
Nylon carrying-case.
Power-supply of 230V13.5V,1.7A
Sjöviksbacken 14
SE-117 43 Stockholm, Sweden
Phone: +46 (0)8 775 00 01
Fax: +46 (0)8 775 00 06
Open as PDF
Similar pages