AP-105 Mounting Kit
Installation Guide
Introduction
The AP-105 Wall Mounting kit provides two options, with built-in security features, for mounting your
AP-105 to a wall. Use the Box Mount Bracket to install the AP over wall box and use the Wall Mount
Bracket to install the AP directly on a wall.
z
1x plastic Box Mount Bracket
z
1x plastic Wall Mount Bracket
Box Mount Bracket
Wall Mount Bracket
AP105_008
The kit includes the following:
Required Tools
z
A screwdriver that matches the screws used for mounting your brackets.
z
An M5 (Metric) or 3/16" (Standard) hex key.
Installation
1. Before securing your mount a double-gang box or directly to the wall, route the ethernet cable
through the openings show in Figure 1.
Figure 1 Cable Routing
Wall Mount Bracket
Box Mount Bracket
0510651-01 | November 2009
Cable Route
to ENET Port
AP105_010
Cable from
Gang Box
1
2. Install your mounting bracket.
For the Wall Mount Bracket (Figure 2):
a. If you are installing your Wall Mount Bracket, install the appropriate wall anchors. Screws and wall
anchors are not included.
b. Align the screw holes in the mount with the holes or anchors on the wall.
c. Insert the screws and tighten them to secure your Wall Mount Bracket.
AP105_012
Figure 2 Wall Mount Bracket Installation
For the Box Mount Bracket:
NOTE
If you plan to permanently connect a serial console cable to the AP installed over a gang-box, you must use the
Wall Mount Bracket instead of the Box Mount Bracket. This provides the necessary space behind the AP to run
both cables.
a. Align the screw holes in the mount with the those in the gang box, as shown in Figure 3.
b. Insert the screws and tighten them to secure your Box Mount Bracket.
The box mount bracket can also be installed over a double-gang wall box. Use the same steps as above
to install it over a double-gang wall box, however the installation requires a third screw. For more
details, see Figure 4.
AP105_011
Figure 3 Box Mount Bracket Installation (Single-gang Box)
2
AP-105 Mounting Kit | Installation Guide
AP105_011
Figure 4 Box Mount Bracket Installation (Double-gang Box)
3. Connect the ethernet cable to the ethernet port (ENET) on the back of the AP.
4. Secure the AP to the mounting bracket by aligning the mounting holes on the back the AP with the
mounting post on the bracket.
5. Push the AP against the posts and downward until the posts engage the slots at the top of the mounting
holes. See Figure 5 and Figure 6 for more details.
AP105_015
Figure 5 Completing the Installation (Wall Mount Bracket)
AP105_014
Figure 6 Completing the Installation (Box Mount Bracket)
AP-105 Mounting Kit | Installation Guide
3
AP in Box Mount Bracket
AP in Wall Mount Bracket
AP105_009
Figure 7 Completed Installation
6. To remove the AP from the mounting bracket, begin by inserting an M5 or 3/16" hex key into the hole
shown in Figure 8.
7. Use the hex key to depress the tab on the AP and push the AP up, releasing the AP from the
mounting post on the bracket.
AP105_013
Figure 8 Removing the AP
4
November 2009 | 0510651-01
Open as PDF
Similar pages