Hygain ATB-65 BASE MOUNT KIT, 2 PIPE Product Manual

 Hy-gain ATB-65 Base Mount Assembly
3 Ground mast
= Not supplied
Mounting Plate assembly
haa
ОПУ =
Grounding
holes
Assemble the Mast plate using the four u-bolts supplied. The plate has bends on each side
for strength. The bends should be on the ground mast side. Holes are provided on the plate
for ground attachment, make sure these hole are at the bottom. Attach the u-bolts using the
5/16 nuts and split washers. The upper u-bolt on each set should be used to hold the antenna.
The lower u-bolt on each set should be used on the ground mast side and should have a saddle
on each. Slide the abs insulators onto the bottom of the antenna. Leave enough of the antenna
sticking out the bottom insulator so that a 10-24 bolt may be used to attach the coax lead to the
main mast, Slide the mast plate onto the antenna an level the bottom of the antenna with the
pottom of the mast plate. Make sure the top insulator does not interfere with the wire anchor that
is Just above it. Remember that the wire anchor will be slid down later to tighten the wires.
Qty P/N
172734
750-9198
475500
555/47
564792
2136900
610-20051
654-03755
705-0440S-K
ГО ГО — + Со Со Ю № —
Description
Mast Plate
U-bolt saddles
insulator 2”
5/16 Hex nut
5/16 split washer
U-bolt 5/16
50-239 connector
4-40x3/8 SS Screws
4-40SS KEP nuts
hy-gains LIMITED WARRANTY
hy-gain Warrants to the original owner of this product, if manufactured by Zy-gain and
purchased from an authorized dealer or directly from Zy-gain to be free from defects in
material and workmanship for a period of 12 months for rotator products and 24 months
for antenna products from date of purchase provided the following terms of this warranty
are satisfied.
1.
The purchaser must retain the dated proof-of-purchase (bill of sale, canceled check,
credit card or money order receipt, etc.) describing the product to establish the
validity of the warranty claim and submit the original or machine reproduction of
such proof-of-purchase to hy-gain at the time of warranty service. hy-gain shall have
the discretion to deny warranty without dated proot-of-purchase. Any evidence of
alteration, erasure, or forgery shall be cause to void any and all warranty terms
immediately.
hy-gain agrees to repair or replace at hy-gain's option without charge to the original
owner any defective product under warranty, provided the product is returned postage
prepaid to hy-gain.
Under no circumstances is hy-gain liable for consequential damages to person or
property by the use of any hy-gain products.
Out-of-warranty Service: hy-gain will repair any out-of-warranty product provided
the unit 1s shipped prepaid. All repaired units will be shipped COD to the owner.
Repair charges will be added to the COD fee unless other arrangements are made.
This warranty is given in lieu of any other warranty expressed or implied.
hy-gain reserves the right to make changes or improvements in design or manufacture
without incurring any obligation to install such changes upon any of the products
previously manufactured.
All hy-gain products to be serviced in-warranty or out-of-warranty should be
addressed to hy-gain, 308 Industrial Park Road, Starkville,
Mississippi 39759, USA and must be accompanied by a letter describing the
problem in detail along with a copy of your dated proof-of-purchase.
This warranty gives you specific rights, and you may also have other rights which
vary from state to state.