Targus Wireless Keypad + Mouse

Wireless
Keypad and
Optical Mouse
Combo
USER GUIDE
TARGUS WIRELESS
KEYPAD AND
OPTICAL MOUSE
COMBO
Introduction
Congratulations on your purchase of the Targus wireless
keypad and opitcal mouse combo. This combo set offers the
latest technology for interference free operation with 2.4 GHz
wireless connection. Both keypad and mouse feature on/off
switch and power saving management for effective power
conservation.
Contents
In addition to this user’s guide, this package contains:
› Targus Wireless Keypad
› Targus Wireless Optical Mouse
› USB Receiver
› 2 AAA batteries (for mouse)
› 1 AA battery (for keypad)
System Requirements
Hardware
• PC with an Intel® Pentium® processor or equivalent
• USB 1.1 or 2.0 interface
1
Targus wireless keypad and opitcal mouse combo
Operating System
• Windows® 2000/XP
• Windows Vista™
Installing the Batteries
Optical Mouse
Removing the battery cover
1 Insert the supplied batteries , making sure that the positive
(+) and negative (-) ends of each battery match the polarity
indicators inside the battery housing.
WARNINGS: WHEN REPLACING THE BATTERIES, YOU MAY USE ALKALINE OR
OTHER HEAVY-DUTY NIMH BATTERIES. NEVER COMBINE AN ALKALINE WITH
A NIMH BATTERY IN A DEVICE. AVOID MIXING NEW AND USED BATTERIES IN
A DEVICE.
2 Slide the battery cover back in to position until it “clicks”
firmly into place.
3 Turn on the mouse by sliding the on/off switch on the bottom
of the mouse to the “on” position.
The optical sensor, located on the bottom of the mouse, glows
red.
2
Targus wireless keypad and opitcal mouse combo
Wireless Keypad
1 Remove the battery cover located on the bottom of the
keypad.
2 Insert the supplied batteries , making sure that the positive
(+) and negative (-) ends of each battery match the polarity
indicators inside the battery housing.
3 Turn on the keypad by sliding the Power switch on the back
side of the keypad to the “on” position.
Setup Key
Power
Switch
Connecting the Receiver
Plug the USB receiver into an available USB port on your
computer.
You are now ready to set the identification code to establish a
communication link with the receiver.
3
Targus wireless keypad and opitcal mouse combo
Setting the Identification Code
After your computer detects the USB receiver you must set
the ID code between the receiver and the mouse as well as
between the receiver and the keypad BEFORE you can use
them. To do this, do the following:
NOTE: MAKE SURE THAT YOUR COMPUTER IS TURNED ON AND HAS DETECTED
THE USB RECEIVER BEFORE YOU SET THE ID CODE.
Optical Mouse
1 Plug the USB receiver into an available USB port on your
computer. The LED on the receiver will flash for 60 seconds to
indicate ID search mode.
2 Press the setup key on the bottom of the mouse.
Setup Key
Power switch
When the LED on the receiver is lit, the mouse is set up with
an ID and the receiver is locked.
You are now ready to use the mouse.
Proceed to setting the ID code with the keypad.
4
Targus wireless keypad and opitcal mouse combo
Wireless Keypad
1 The LED on the receiver will flash for 60 seconds to
indicate ID search mode. During this time, press and
release the connection button on the back of the keypad.
2 When the light emitter diode (LED) on the receiver is lit, the
keypad is set up with an ID and the receiver is locked.
You are now ready to use the keypad.
Setup Key
Power switch
5
Targus wireless keypad and opitcal mouse combo
Using the Keypad
Definition of the Keypad Keys:
.
Del
NumLock on - inserts a decimal point
NumLock off - deletes a number
0
Ins
NumLock on - enters “0” on the display
NumLock off - emulates the Insert key
00
,
NumLock on - enters “00”
NumLock off - inserts a comma ( , )
1
End
2

3
PgDn
4

5
6

NumLock on - enters “1” on the display
NumLock off - emulates the End key
NumLock on - enters “2” on the display
NumLock off - moves the cursor down one
line of text
NumLock on - enters “3” on the display
NumLock off - emulates the Page Down key
NumLock on - enters “4” on the display
NumLock off - moves one character to the
left of the cursor position
NumLock on - enters “5” on the display
NumLock off - No function
NumLock on - enters “6” on the display
NumLock off - moves one character to the
right of the cursor position
6
Targus wireless keypad and opitcal mouse combo
7
Home
8

9
PgUp
+
=
NumLock on - enters “7” on the display
NumLock off - emulates the Home key
NumLock on - enters “8” on the display
NumLock off - moves the cursor up one line
of text
NumLock on - enters “9” on the display
NumLock off - emulates the Page Up key
NumLock on
NumLock off
NOTE: THE NUMLOCK KEY ON YOUR COMPUTER WILL NOT AFFECT THE
NUMLOCK STATUS OF THE KEYPAD.
7
Targus wireless keypad and opitcal mouse combo
Using the multimedia/internet controls
To switch between the two modes, press the Mode key.
Media keys
Key
Function
Previous Track
Next Track
Play / Pause
Mute
Volume Up
Volume Down
Stop
Internet keys
Default E-mail Program
Default Internet browser
Internet page forward
Internet page backward
Refresh page
Stop page
Favorite
8
Targus wireless keypad and opitcal mouse combo
Power Management
To power the keypad and mouse on and off, slide the on/off
switch to the desired position.
When power is on, the mouse goes into “power saving mode”
after 4 minutes of inactivity. To activate the mouse, move the
mouse or press any button.
To save battery power, turn off the keypad and mouse while
traveling or when you’re not using them.
Operating Hints
For optimal performance and RF reception:
• Place the receiver at least 20 cm away from all electrical
devices, such as your monitor, speakers or external storage
devices.
• Avoid using the optical mouse on a metal surface. Metals,
such as iron, aluminum or copper, shield the radio frequency
transmission and may slow down the mouse’s response time
or cause the mouse to fail temporarily.
• The mouse will enter a suspend mode at the same time
your computer does. To activate the mouse, press any of the
buttons.
9
Targus wireless keypad and opitcal mouse combo
• If your computer has a metal case that contains aluminum
or magnesium, use the optical mouse to the side. The display
panel may interfere with the radio frequency signal if you use
the mouse directly in front of the computer.
• Never use the optical mouse on a glass or mirrored surface
as these surfaces will cause the mouse to fail temporarily.
• To maximize battery life, use the optical mouse on a white,
or light colored surface. Dark surfaces cause the mouse’s LED
to glow brighter, which causes the battery to discharge more
rapidly.
Troubleshooting
What do I do if the mouse does not work?
• Make sure that the polarity of the batteries is correct. The
positive (+) and negative (- ) ends of each battery must match
the positive (+) and nega tive (-) connections in the battery
housing.
• Check that the receiver’s USB connector is firmly attached to
the USB port on your computer.
• Verify that the device drivers are installed.
• Make sure you have established a communication link
between the mouse and its receiver. See “Setting the
Identification Code”.
10
Targus wireless keypad and opitcal mouse combo
When I use the mouse, other wireless devices work
more slowly or fail temporarily – what should I do?
• The mouse may cause interference with any cordless, radiobased device that operates at 2.4 GHz, such as a telephone,
baby monitor, or toy. To reduce interference, move the mouse’s
receiver and the base unit of the affected device as far away
from each other as possible.
• You can also reset the mouse’s identification code. The mouse
has identification codes that allow the mouse and its receiver
to operate without interference from other radio frequency
devices. To do this, see “Setting the Identification Code”.
What do I do if the response time of the mouse is slow
or the mouse intermittently stops working?
Try one or more of the following:
• Increase the distance between the mouse’s receiver and the
rest of your computer equipment.
• Increase the distance between the mouse’s receiver and the
base units of other wireless devices.
• Turn off any wireless devices and their base units that are
near the mouse’s receiver.
• If you are using the mouse on a metal surface, move it and
the receiver to a non-metal surface. Metals, such as iron,
aluminum or copper, shield the radio frequency transmission
and may slow down the mouse’s response time or cause the
mouse to fail temporarily.
• Replace the batteries.
11
Targus wireless keypad and opitcal mouse combo
Specifications
Operation Frequency
2.4 GHz
Operating Distance
Up to 10m
Operating Voltage
Keypad:
2.4V
Receiver:
5V
Mouse:
3V
Keypad:
10mA maximum
Receiver:
16mA maximum
Mouse:
11mA maximum
Keypad:
Below 300 uA
Mouse:
Below 1 mA
Keypad:
155 x 92 x 27 mm
Receiver:
58 x 16 x 10 mm
Mouse:
98 x 60 x 33.5mm
Keypad:
111g
Receiver:
14g
Mouse:
80g
Operating Current
Suspend Mode
Dimensions
Weight
12
Targus wireless keypad and opitcal mouse combo
Technical Support
For technical questions, please visit:
US Australia New Zealand Internet: www.targus.com/support.asp
Internet: www.targus.com/au
Email: infoaust@targus.com
Telephone: 1800-641-645
Telephone: 0800-633-222
Product Registration
Targus recommends that you register your Targus accessory
shortly after purchasing it. Go to:
http://www.targus.com/registration.asp.
You will need to provide your full name, email address, country of
residence and product information.
Warranty
Targus warrants this product to be free from defects in materials
and workmanship for one year. If your Targus accessory is found
to be defective within that time, we will promptly repair or replace
it. This warranty does not cover accidental damage, wear and tear,
or consequential or incidental loss. Under no conditions is Targus
liable for loss of, or damage to devices; nor loss of, or damage
to, programs, records, or data; nor any consequential or incidental
damages, even if Targus has been informed of their possibility. This
warranty does not affect your statutory rights.
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause
undesired operation.
13
Targus wireless keypad and opitcal mouse combo
FCC Statement
Tested to Comply
This equipment has been tested and found to comply with the limits
of a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna;
• Increase the separation between the equipment and receiver;
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected;
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not authorized by the party responsible
for compliance could void the user’s authority to operate this
product.
Declaration of Conformity
Hereby, Targus, declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive
1999/5/EC.
Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks
of Microsoft Corporation in the United States and/or other countries. All trademarks and
registered trademarks are the property of their respective owners. All rights reserved. Features
and specifications are subject to change without notice. © 2008. Targus Group International,
Inc. and Targus, Inc., Anaheim, CA 92806 USA
14
Visit our website at www.targus.com
Features and specifications are subject to change without notice.
© 2008 Targus Group International, Inc. and Targus, Inc.
AKM10US/ 410-1449-001A