Optical
Bluetooth®
Mouse
USER GUIDE
Visit our Website at www.targus.com Features and
specifications subject to change without notice.
© 2007 Targus Group International, Inc. and Targus, Inc.
Bluetooth Qualified Product
ID# B0
AMB06US / 410-1183-001A
30
TARGUS OPTICAL
BLUETOOTH® MOUSE
Introduction
Congratulations on your purchase of the Targus Optical Bluetooth
Mouse. This mouse uses Bluetooth wireless technology which
provides seamless connections up to 30ft (10M) in range.
System Requirements
Hardware
• Bluetooth-enabled notebook or desktop PC
Operating System
• Windows® 2000 / XP
• Windows VistaTM
• Mac OS X 10.2.8 (or greater)
1
Targus Optical Bluetooth Mouse
Installing the Batteries (Included)
• Use the two AAA-size rechargeable NIMH batteries (Included)
• Remove the battery cover from the top of the mouse by sliding off the
cover of the mouse.
• Insert the batteries, making sure that the positive (+) and negative (-)
ends of each battery match the polarity indicators inside the battery
housing
WARNINGS: WHEN REPLACING THE BATTERIES, ALWAYS REPLACE WITH NiMH
BATTERIES OR OTHER RECHARGEABLE BATTERIES. NEVER USE ALKALINE
BATTERIES IN A DEVICE. AVOID MIXING NEW AND USED BATTERIES IN A DEVICE.
• Snap the battery cover back into position.
• Turn on the mouse by sliding on/off switch on the bottom of the mouse
to the “on” position.
2
Targus Optical Bluetooth Mouse
Mouse Power Management
• To power the mouse on and off, slide the on/off switch at the bottom
of the mouse to the desired position.
• During operation, the power saving feature puts the mouse into
"sleep mode" after 8 minutes of inactivity. Click any mouse button to
re-activate the mouse.
• To save battery power, turn off the mouse while traveling or while not
in use.
• The scroll wheel will glow when the batteries are low. To recharge the
mouse, plug in the USB Recharging Cable to the mouse, and plug USB
connector into any available USB port on the computer. While
charging, the mouse remains operational and connected via the
wireless Bluetooth technology.
Charging the Rechargeable Batteries
Charge the mouse for 8 hours before use. Plug in the USB charge
cable to the mouse and to an available USB port on the computer.
For USB Recharging Cable
(Power Use ONLY)
3
Targus Optical Bluetooth Mouse
1. Charge the mouse for at least 8 hours before using it. And please
make sure only rechargeable batteries (included) are used.
2. Your computer needs to stay powered on for the mouse to charge.
Follow these steps to prevent your computer from going in to Standby
or Hibernate:
a) Click “Start”
b) Click “Control Panel”
c) Click “Performance and Maintenance” (Skip in Classic View)
d) Click “Power Options”
e) Make sure “System Standby:” and “System Hibernates:” under
“Plugged in” are set to “Never”
3. If you use your notebook computer’s LCD monitor, please do not
close the lid. (Please ignore this step if you use an external monitor
with your notebook lid closed.)
4. If your mouse does not respond after a period of inactivity, please
wake it up by pressing one of the buttons on the mouse and moving the
mouse around.
4
Targus Optical Bluetooth Mouse
Establishing a Communications Link
Initial Configuration
Before you can begin using Bluetooth connectivity on your computer
and other Bluetooth devices, you must set up your Bluetooth connection correctly. Please make sure this is performed before establishing
the connection with the Bluetooth device.
The Targus Optical Bluetooth Mouse is designed to work with the four
major software stack (protocol) standards: WIDCOMM, Toshiba and
Microsoft and Mac OS X. Please check your computer’s documentation
to see which software stack your computer has. Please contact your
system vendor if your system does not support one of the following
Bluetooth software standards.
NOTE: PLEASE USE THE LATEST BLUETOOTH DEVICE DRIVER. INSTRUCTION
SCREENS MIGHT VARY DEPENDING ON THE VERSION OF YOUR BLUETOOTH DEVICE
DRIVER.
Connecting with Bluetooth Software:
WIDCOMM or Microsoft (Windows XP & Windows Vista)
1. Go to the Bluetooth Places icon located on your desktop or in the
system tray and double click, then click Add a Bluetooth Device.
(Windows XP)
(Windows Vista)
5
Targus Optical Bluetooth Mouse
2. The Bluetooth Wizard screen will prompt. Please follow the onscreen instructions.
(Windows Vista)
(Windows XP)
3. Please turn on the mouse and press the connection ID button
located at the bottom of the mouse until the LED on the mouse blinks
red (discovery mode). Click Next to continue pairing and the computer
will search for the mouse.
(Windows XP)
(Windows Vista)
6
Targus Optical Bluetooth Mouse
4. The confirmation window will appear after the computer finishes
detecting the Bluetooth devices. Select the Bluetooth Wireless Mouse
and click Next to continue. (There may be one or more different
Bluetooth devices detected.) If the mouse is not detected, please make
sure the power is on and in discovery mode. Press Search Again to
re-pair the device.
(Windows Vista)
(Windows XP)
5. After selecting the correct device, the computer will finish establishing the connection. Please wait until the setup is completed.
(Windows Vista)
(Windows XP)
7
Targus Optical Bluetooth Mouse
Connecting with Bluetooth Software:
TOSHIBA
(Windows Vista)
1. Double click on the Bluetooth Manager icon in the system tray, and
then click Add New Connection.
2. Please turn on the mouse and press the connection ID button
located at the bottom of the mouse until the LED on the mouse blinks
red (discovery mode). Click Next to continue pairing and the computer
will search for the mouse.
8
Targus Optical Bluetooth Mouse
3. The computer will now search for the Bluetooth mouse and other
Bluetooth devices. Please wait until the search is completed. Choose
the device you wish to connect. There may be more than one Bluetooth
device detected. Select Bluetooth Wireless Mouse and click Next to
continue. If the mouse is not detected, please make sure the mouse is
in discovery mode and click Refresh.
4. The computer will begin connecting with the device.
9
Targus Optical Bluetooth Mouse
5. The connection is established and setup is complete. The device is
ready to use. If the connection is not successful, please click Back and
search the device again. You can continue to add other Bluetooth
devices or close the window.
10
Targus Optical Bluetooth Mouse
Bluetooth Software: Mac
1. Go to the Bluetooth icon located on your desktop or in the system
bar and click the icon to begin setup. Select “Turn Bluetooth On” to
enable the device.
2. Scroll down the list to “Set up Bluetooth Device...” and select the
option.
3. Bluetooth Setup Assistant will begin. Please follow the on-screen
instructions.
11
Targus Optical Bluetooth Mouse
4. Please select “mouse” and click continue to proceed with setup.
Please make sure your mouse is in “discovery” mode. To enable
“discovery” mode, turn on the mouse and press the connection ID
button located at the bottom of the device until the light in the middle
blinks red light.
5. Your computer will begin to search for the mouse. Once the mouse
is found, it will show up in the list. Highlight the mouse in the list you
wish to connect and press continue to proceed with setup.
12
Targus Optical Bluetooth Mouse
6. The Bluetooth mouse will now begin pairing. Click continue to
proceed.
7. Congratulations. Your Bluetooth mouse is setup and is ready to use.
You can choose to setup another device or click Quit to exit setup.
13
Targus Optical Bluetooth Mouse
Troubleshooting
What do I do if the device does not work?
• Make sure that the polarity of the battery is correct. The positive (+)
and negative (-) ends must match the positive (+) and negative (-)
connections in the battery housing.
• Make sure you have established a communications link. See
“Establishing a Communications Link.”
What do I do if the response time of the device is slow or it
intermittently stops working?
• Increase the distance between the receiver and the base units of
other wireless devices.
• Replace the batteries.
14
Targus Optical Bluetooth Mouse
Technical Support
For technical questions, please visit:
US
Australia
New Zealand
Internet: www.targus.com/support.asp
Internet: www.targus.com/au
Email: infoaust@targus.com
Telephone: 1800-641-645
Telephone: 0800-633-222
Product Registration
Targus recommends that you register your Targus
accessory shortly after purchasing it. Go to:
http://www.targus.com/registration.asp.
You will need to provide your full name, email address,
country of residence and product information.
Warranty
Targus warrants this product to be free from defects in
materials and workmanship for one year. If your Targus
accessory is found to be defective within that time, we will
promptly repair or replace it. This warranty does not cover
accidental damage, wear and tear, or consequential or
incidental loss. Under no conditions is Targus liable for loss
of, or damage to devices; nor loss of, or damage to,
programs, records, or data; nor any consequential or
incidental damages, even if Targus has been informed of
their possibility. This warranty does not affect your
statutory rights.
Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
15
Targus Optical Bluetooth Mouse
FCC Statement
Tested to Comply
This equipment has been tested and found to comply with the limits
of a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna;
• Increase the separation between the equipment and receiver;
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected;
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not authorized by the party responsible for
compliance could void the user’s authority to operate this product.
Declaration of Conformity
Hereby, Targus, declares that this device is in compliance with the
essential requirements and other relevant provisions of Directive
1999/5/EC.
Microsoft, Windows, and Windows Vista are either registered trademarks or trademarks of
Microsoft Corporation in the United States and/or other countries. All trademarks and
registered trademarks are the property of their respective owners. All rights reserved.
Features and specifications are subject to change without notice. © 2007, Targus Group
International, Inc. and Targus, Inc., Anaheim, CA 92806 USA
16