Parrot UNIKA for SUBARU IMPREZA

Parrot UNIKA is a universal interface that allows you to control the Parrot MKI9000 directly with the

OEM steering wheel commands. Parrot UNIKA can work with car protocols such as CAN, KBUS or resistive systems.

Before installing the UNIKA, make sure you have the latest software update on your Parrot MKI9000.

If you have a Parrot MKi9100, make sure you also have the 3.1 display version. To do so, select Settings > Advanced settings > Information.

Installation

Compatibility Car models SUBARU IMPREZA > 2007

Parrot reference For Parrot MKI9000

Parrot UNIKA: PI090020AB

Installation

Installation of the Parrot MKi

Selecting the protocol

We recommend you to install the Parrot MKi before installing the

UNIKA. Make sure the installation is correctly performed by checking if the

«Good bye» message is displayed when you turn off the ignition.

► Refer to the documentation of your Parrot MKi for more information.

Use the DIP switches located on one side of the UNIKA to select the protocol (resistive or CAN Bus / KBus) on which the vehicle is based.

Warning: Make sure the UNIKA is not powered before selecting the protocol.

Set the DIP this way if you have an OEM radio.

Set the DIP this way if you don’t have an OEM radio.

Power supply The power supply for the UNIKA interface is taken from the power cable of the Parrot MKi. It is important to follow the color code of the power cable wires: the red wire of the kit’s cable corresponds to the permanent

12V supply; the orange wire corresponds to the ignition 12V ; the black wire is for ground ; the yellow wire corresponds to the Parrot mute output.

Warning : Connect the ignition to the Parrot car kit if the vehicle is based on a resistive or a K-Bus protocol. Don’t connect the ignition if the vehicle is based on a CAN protocol.

On some vehicles, the 12V power wires may be reversed, in which case you must reverse the red and orange wires of the hands-free kit’s power supply. This can easily be done by reversing the two fuse holders on the kit’s power cable.

12V ignition is not provided.

Get the 12 V ignition from the car.

Resistive protocol

The wires corresponding to the resistive protocol must be connected correctly to your car stereo’s. It is important to follow the wiring diagram for your vehicle.

Checking the wiring

Once your UNIKA interface has been fitted, the LED should light up green and should turn amber while pressing a button on your steering wheel.

If the LED does not light up, check the power supply connections. If the

LED is red or blinks red, check the connections.

Warning : Once the installation is complete, turn the ignition off until the UNIKA LED switches off.

Reset procedure

In case of problem or if you have installed the UNIKA interface in another car, reset the UNIKA by holding down the Reset button until the LED turns off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (resistive protocol). You can then release the reset button.

Car Radio

UNIKA www.parrot.com

Mute in 1 2 3

Mute cap brown/ black & green/ red yellow & blue red black yellow & red

Parrot MKi9000

RESIS Configuration SUBARU

The wires corresponding to the RESIS protocol must be connected correctly to your car stereo’s

RESIS information. It is important to follow the wiring diagram for your vehicle. We would advise our customers to have the interface fitted by a professional.

If your car stereo supports mute signal management, then your actions on the steering wheel commands while using a Parrot MKI9000 will not be taken into account by the car stereo.

To find out the mute position of your car stereo, refer to the documentation of your device or contact the car manufacturer.

1- Programming Parrot UNIKA for your car

The wires corresponding to the resistive protocol must be connected correctly to your car stereo’s. It is important to follow the wiring diagram for your vehicle.

Defining the mode

If your vehicle is based on a resistive protocol, you have to define the mode manually:

1. Turn the ignition on.

> The LED blinks red once.

2. Press the buttons on the steering wheel in the following order: src .

> Each time you press a button, the LED blinks in red.

Reset procedure

In case of problem or if you have installed the UNIKA interface in another car, reset the UNIKA by holding down the Reset button until the LED turns off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (resistive protocol). You can then release the reset button.

Specific case If you do not have 7 buttons on your steering wheel, hold down the last button for two seconds until the LED turns green.

Warning : Once the installation is complete, turn the ignition off until the UNIKA LED switches off.

Your system runs on B mode.

Resistive protocol

The wires corresponding to the resistive protocol must be connected correctly to your car stereo’s. It is important to follow the wiring diagram for your vehicle.

Checking the wiring

Once your UNIKA interface has been fitted, the LED should light up green and should turn amber while pressing a button on your steering wheel.

If the LED does not light up, check the power supply connections. If the

LED is red or blinks red, check the connections.

Warning : Once the installation is complete, turn the ignition off until the UNIKA LED switches off.

Reset procedure

In case of problem or if you have installed the UNIKA interface in another car, reset the UNIKA by holding down the Reset button until the LED turns off (if the vehicle is based on a CAN Bus / KBus protocol) or blinks red (resistive protocol). You can then release the reset button.

/ src src

/ src src src src src src src src src

/

Mode B

Enter the menu / Entrer dans le menu / Entrar en el menú / Öffnen eines Menüs / Accedere al menu / Het hoofdmenu openen src

Navigate through the menus / Naviguer dans le menu / Navegar por los menús / Navigation in den Menüs / Consente di utilizzare i menu /

In de menu’s navigeren

Confirm menu choice / Confirmer / Validar la selección / Bestätigung einer Auswahl / Confermare la selezione / De selectie valideren

Back menu / Menu précédent / Menú anterior / Rückkehr zum vorhergehenden Menü / Consente di tornare al menu precedente / Vorige menu

Adjust the volume / Modifier le volume / Ajustar el volumen / Einstellung der Lautstärke / Modificare il volume / De geluidssterkte regelen

Answer an incoming call / Répondre à un appel / Descolgar una llamada

/ Entgegennehmen eines eingehenden Anrufs / Rispondere a una chiamata / Een inkomend gesprek opnemen

Refuse an incoming call / Refuser un appel / Colgar una llamada / Beenden eines eingehenden Anrufs / Rifiutare una chiamata / en inkomend gesprek weigeren

Hang up / Raccrocher / Rechazar / Ablehnen / Riagganciare / Ophangen

Discreet mode / Mode discret / Modo discreto / Diskreter Modus / Modalità privata / Privacy modus

Exit discreet mode / Sortir du mode discret / Salir del modo discreto /

Beenden des Diskreter Modus / Disattivare la modalità privata / De discrete modus opheffen

Start the voice recognition feature / Lancer la reconnaissance vocale /

Iniciar el modo de reconocimiento de voz / Aktivieren der Spracherkennung / Attivare la funzione di ricon. vocale / De modus Spraakherkenning sluiten

Redial function / Fonction Bis / Función de rellamada / Wiederholung des letzten Anrufs / Funzione Bis / Bis functie

Mute Mic / Couper le microphone / Desactivar el micrófono / Das Mikrofon deaktivieren / Disattivare il microfono / De microfoon in- of uitschakelen

Next - previous track / Morceau suivant - précédent / Pista siguiente

- precedente / Vorhergehende - nächsten Stück / Brano precedente - successivo

Play - Pause / Parar - reproducir música / Anhalten - Fortsetzen der

Wiedergabe / Interrompere - riprendere la lettura /

2 - Features

Depending on the steering wheel control in your vehicle, the UNIKA interface will enable you to take full advantage of the telephone and music functions in 4 different modes: Mode A (4 buttons), Mode B (5 buttons), Mode C (6 buttons) and Mode D

(7 buttons).The selection of this mode depends on the protocol of the vehicle.

Note : Pictograms on the buttons depend on the model of the vehicles.

src

Short press

2 short presses

Long press

Volume

Seek

Source

Pick up - Hang up

Warning : The mode you will use depends on the number of available buttons and not on the pictograms. For instance, if you have the buttons, you will use the

UNIKA in mode B : consider the src buttons is replaced by the button.