DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 1
Operating Instructions
VACUUM CLEANER
❈ Before
❈ Indoor
operating this unit, please read the instructions carefully.
use only.
Register your product at www.samsung.com/register
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 2
IMPORTANT SAFEGUARDS
1. Read all instructions carefully. Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the rating plate on the bottom of the
cleaner.
2. WARNING: Do not use the vacuum cleaner when rug or floor is wet.
Do not use to suck up water.
3. Close supervision is necessary when any appliance is used by or near children. Do not
allow the vacuum cleaner to be used as a toy. Do not allow the vacuum cleaner to run
unattended at any time. Use the vacuum cleaner only for its intended use as described in
these instructions.
4. Do not use the vacuum cleaner without a dust bin. Empty the dust bin before it is full in
order to maintain the best efficiency.
5. Do not use the vacuum cleaner to pick up matches, live ashes or cigarette butts. Keep the
vacuum cleaner away from stoves and other heat sources. Heat can deform and discolour
the plastic parts of the unit.
6. Avoid picking up hard, sharp objects with the vacuum cleaner as they may damage the
cleaner parts. Do not stand on the hose assembly. Do not put weight on the hose. Do not
block the suction or the exhaust port.
7. Switch the vacuum cleaner off on the body of the machine before unplugging from the
electrical outlet. Disconnect the plug from the electrical outlet before changing the dust
bag or dust container. To avoid damage, please remove the plug by grasping the plug
itself, not by pulling on the cord.
8. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
9. The plug must be removed from the socket outlet before cleaning or maintaining the appliance.
10. The use of an extension cord is not recommended.
11. If your vacuum cleaner is not operating correctly, switch off the power supply and consult
an authorized service agent.
12. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a similarly qualified person in order to avoid a hazard.
13. Don’t carry the vacuum cleaner by holding the hose.
Use the handle on the vacuum cleaner set.
1
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 3
1 ASSEMBLING THE CLEANER
OPTION
▼
OPTION
Features may vary according to model.
CAUTION : Please do not use dust bin handle
when carrying machine.
For storage, park the floor nozzle.
2
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 4
2 OPERATING THE CLEANER
2-1 ON/OFF SWITCH
2-2 POWER CORD
NOTE
When removing the
plug from the
electrical outlet, grasp the
plug, not the cord.
2-3 POWER CONTROL (INFRARED CONTROL)
1) REMOTE CONTROL TYPE
- HOSE
SENDER
HANDLE CONTROL
1. Vacuum cleaner ON/OFF
Press the ON/OFF button to operate the vacuum
cleaner.
Press again to stop the vacuum cleaner.
2. Vacuum cleaner MIN/MID
Press the MIN/MID button to operate the vacuum at a
low level (for curtain cleaning, etc.).
Press again to operate the vacuum in a MID mode.
3. Using at MAX
Press the MAX button to operate the vacuum at maximum intake.
[The cleaner is controlled by using
infrared signals.]
- BODY
OPTIONAL - DIGITAL SIGNAL
POWER CONTROL
Press the power control button repeatedly to select
the correct mode.
(ON(MIN) → MID → MAX → OFF)
NOTE : If the remote handle control is not
working, the cleaner can be operated
using the control button on the body
of the machine.
RECEIVER
3
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 5
2) BODY-CONTROL TYPE
- HOSE
- BODY
To reduce suction for cleaning draperies,
small rugs, and other light fabrics, pull the
tap air until the hole is open.
MIN = For delicate surface e.g. net curtains.
MAX = For hard floors and heavily soiled carpets.
▼
2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES
Features may vary according to model.
PIPE
Adjust the length of the telescopic pipe
by sliding the length control button located in the center of the telescopic pipe
back and forth.
To check for blockages, separate the telescopic pipe and adjust to shorten. This allows
for easier removal of waste clogging the tube.
ACCESSORY
Push the accessory on to
the end of the hose handle.
Pull out and turn the dusting brush for cleaning delicate areas.
To use the upholstery tool,
push the accessory on to
the end of the hose handle
in the opposite direction.
ELBOW EXTENDING TUBE 1
(OPTION)
2
3
4
5
1. Connect the elbow extending tube to connecting part for hose knob and
telescopic pipe.
2. Fit the telescopic pipe to the lower part of the elbow extending tube.
3. Press the PUSH button.
4. With the PUSH button pressed, the elbow extending tube is folded.
5. Using the elbow extending tube allows hard to reach areas (e.g. under
furniture)to be cleaned without having to kneel down.
4
DJ68-00321F (EN) (0.9)
OPTION
12/15/09 1:25 PM
Page 6
ŠCarpet
Cleaning
ŠFloor
Cleaning
Adjust the inlet lever according to the
floor surface.
Remove waste matter completely if the
inlet is blocked.
OPTION
Vacuum dust in wide area at once
Remove waste matter completely
if the inlet is blocked.
OPTION
Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to
matters tangled around the drum. In this case, clean the drum with care.
1
2
3
Remove waste matter
Remove the brushbar such as dust and hair
Push the Open button of
from the transparent tangled around the
the transparent screen
brushbar using scissors.
cover to separate the cover. screen.
4
5
6
For improved pickup of pet hair and
fibre on carpets
Remove dust inside the Insert brushbar into
brush housing using a
rotating belt and
dry duster or crevice tool. assemble.
OPTION
Click the transparent
screen cover back into
place to reassemble.
Clogs on turbine keeps brush from turning, and in this case, take care of it.
Turbine
Brush
Remove waste
To reassemble, align the cover to the
Turn the lock button to
matter comfront of the main body and close. After
‘UNLOCK’, and remove
closing the cover, ensure that the lock
For picking up pet hair pletely when
waste matter.
button is turned to the ‘LOCK’ position.
and fibre on upholstery inlet is blocked.
Warning : Use for bedclothes only. Be cautious not to damage brush during unclogging.
and bed linen.
Brush for blanket
5
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 7
3 EMPTYING THE DUST BIN
1
2
Once dust reaches the dust full
mark, or once the dust
full light is on, empty the dust bin.
4
3
Take the dust bin out by
pressing the button.
5
Throw away dust in
the bin.
CLICK
6
Close the dust bin cover.
Before use, push the dust bin
into the main body of the vacuum cleaner until you hear
the "click" sound.
- Empty into a plastic bag
(recommended for asthma/allergy sufferers)
NOTE
You may rinse the dust bin with cold water
6
Separate the dust
bin cover.
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 8
4 CLEANING THE DUST PACK
4-1. WHEN TO CLEAN THE DUST PACK
- If suction is noticeably reduced during cleaning, please check the dust pack as indicated
below.
Suction is significantly weakened during cleaning.
Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard.
SENDER
Turn the vacuum power to 'MAX'
HANDLE CONTROL
If the filter check indicator turns red
with the inlet floating 10 cm above
flat floor, clean it.
When the indicator light comes
on, please empty the Dust
Pack(4-2) as shown in the following illustrations.
7
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 9
4-2 CLEANING THE DUST PACK
1
2
Remove the dust bin and dust
pack as shown.
3
Remove the fixed frame
of the dust pack cover.
5
4
Wash the sponge and the filter
of the dust pack with water.
7
Remove the sponge and filter
from the dust pack.
6
Let the sponge and filter dry in
the shade for more than
12 hours.
Put the sponge and filter
into the dust pack.
8
Before reassembly,
align the dust pack cover
and dust pack correctly.
Put the assembled dust pack
into the main body.
NOTE : Make sure the filter is completely dry before putting it back into the vacuum
cleaner. Allow 12 hours for it to dry.
8
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 10
5 CLEANING THE MOTOR PROTECTION FILTER
Remove the motor protection filter from
the vacuum cleaner.
Shake and tap the dust from it and put
back in machine.
Take out both the dust bin and the
dust pack.
6 CLEANING THE OUTLET FILTER
Press the fixed frame
part at the back of the
main body to remove.
Pull out the HEPA Filter Dust the HEPA filter.
using the tab.
Put the HEPA filter into
the main body until you
hear a ‘click’ sound.
OPTION - MICRO CARBON FILTER
NOTE : Replacement filters
are available at your
local Samsung distributor.
Remove and replace the blocked outlet filter.
9
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 11
7 CHANGE THE BATTERY(OPTIONAL)
BATTERY TYPE : AA Size
NOTE
1. When the vacuum cleaner does not work, replace the batteries.
If the problem persists, please contact our authorized dealer.
2. Use 2 batteries of size AA.
1. Never disassemble or recharge the batteries.
WARNING 2. Never heat up the batteries or throw them into fire.
3. Do not reverse (+),(-) poles.
4. Dispose of the batteries properly.
- IF YOU HAVE A PROBLEM
PROBLEM
CAUSE
Motor does not start.
REMEDY 0
No power supply.
Thermal cut-out.
Nozzle, suction hose or tube
is blocked.
Check cable, plug and socket.
Leave to cool.
Check for blockage and
remove it.
Check that the cord is not
twisted or wound unevenly.
Pull the cord out 2-3m and
push the cord rewind button.
Vacuum cleaner does not
pick up dirt.
Crack or hole in hose.
Check hose and replace if
required.
Low or decreasing suction
Filter is full of dust.
Please check filter and, if
necessary, clean as illustrated in the instructions.
Suction force is gradually
decreasing.
Cord does not rewind fully.
This Vacuum cleaner is approved the following.
EMC Directive : 2004/108/EEC
Low Voltage Directive : 2006/95/EC
If you have any questions or comments relating to Samsung products,
please contact the SAMSUNG customer care center.
Country
U.K
SOUTH AFRICA
Customer Care Center ☎
0845 SAMSUNG (7267864)
0860 7267864 (SAMSUNG)
10
Web Site
www.samsung.com/uk
www.samsung.com/za
DJ68-00321F (EN) (0.9)
12/15/09 1:25 PM
Page 12
DJ68-00321F REV(0.9)