Philips Clock radio for iPod/ iPhone AJ3270D

Register your product and get support at
EN
User manual
AJ3270D
A
e
f
g
h
i
a
b
c
j
d
k
l
m
n
B
C
D
E
F
G
VOL +/-
H
a
b
RADIO
a
b
RADIO
TUNING +/HR
HR
I
PM
FM
EN
1 Important
Safety
•
•
•
•
•
•
•
•
•
•
•
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not block any ventilation openings. Install in accordance with
the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the clock radio.
Only use attachments/accessories specified by the
manufacturer.
Unplug this clock radio during lightning storms or when unused
for long periods of time.
Refer all servicing to qualified service personnel. Servicing is
required when the clock radio has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the clock radio, the clock
radio has been exposed to rain or moisture, does not operate
normally, or has been dropped.
This clock radio shall not be exposed to dripping or splashing.
Do not place any sources of danger on the clock radio (e.g.
liquid filled objects, lighted candles).
•
Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
2 Your clock radio
Congratulations on your purchase, and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
Introduction
With this clock radio, you can:
• listen to FM radio;
• enjoy audio from iPod/iPhone;
• know the time; and
• wake up by buzzer alarm, radio, or audio in iPod/iPhone.
What’s in the box
Check and identify the contents of your package:
• Main unit (with a battery)
• AC adapter
• User manual
Overview of the main unit A
a iPhone
• Select or exit iPhone/iPod mode.
b HR/TUNING +/• Set hour.
• Tune to radio stations.
c MIN/PRESET +/• Set minute.
• Select a preset radio station.
d Display panel
• Show current information.
e SLEEP
• Set sleep timer.
f SCAN/PROG/SET TIME
• Scan/store radio stations.
• Set time.
g VOL +/• Adjust volume.
h RADIO
• Turn on/off radio.
i AL1/AL2
• Set alarm.
• Turn on/off alarm.
• View alarm settings.
j BRIGHTNESS/SNOOZE
• Snooze alarm.
• Adjust display brightness.
k DOCK for iPhone/iPod
l FM ANT
• FM antenna.
m DC IN 5V/2A
• Power supply socket.
n AL1/AL2 RADIO·BUZZ·iPhone
• Select alarm source.
3 Get started
Always follow the instructions in this chapter in sequence.
Install battery
Warning
•• Risk of explosion! Keep batteries away from heat, sunshine or fire.
Never discard batteries in fire.
•• Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
•• The battery contains chemical substances, so it should be disposed
of properly.
•• Keep children away from the battery.
Note
•• You can only use AC power as power supply. The lithium CR2032
battery is only for back-up purpose.
•• When power is disconnected, the display backlight is off.
For first-time use:
Remove the protective tab to activate the battery. B
To replace the battery: C
Connect power D
Caution
•• Risk of product damage! Ensure that the power voltage corresponds
to the voltage printed on the back or underside of the clock radio.
•• Risk of electric shock! When you unplug the AC adapter, always pull
the plug from the socket. Never pull the cord.
Set clock
1
2
3
4
5
In standby mode, press and hold SET TIME for two seconds.
»» The current time is displayed.
»» The hour and minute digits begin to blink.
Press HR+/- and MIN+/- repeatedly to set hour and minute.
Press SET TIME again to confirm.
»» [12H] or [24H] is displayed.
Press HR+/- (or MIN+/-) to select 12/24 hour format.
Press SET TIME to confirm.
Note
•• When iPhone/iPod is connected, the clock radio synchronizes time
with iPhone/iPod automatically.
4 Play from iPhone/iPod
You can enjoy audio from iPhone/iPod through this clock radio.
Compatible iPhone/iPod
The clock radio supports these iPod and iPhone models:
Made for.
• iPod touch (1st, 2nd, 3rd, and 4th generation)
• iPod classic
• iPod with video
• iPod nano (1st, 2nd, 3rd, 4th, 5th, and 6th generation)
• iPod with color display
• iPod mini
• iPhone 4
• iPhone 3GS
• iPhone 3G
• iPhone
Listen to audio from iPhone/iPod E
1
2
3
Place the iPhone/iPod in the dock.
Press iPhone to activate iPhone/iPod mode.
Start to play audio from the iPhone/iPod.
Tip
•• Press iPhone again to switch to standby mode.
Remove the iPhone/iPod F
Pull the iPhone/iPod out of the dock.
Charge the iPhone/iPod
When the clock radio is connected to power, the docked iPhone/iPod
starts charging.
Adjust volume G
5 Listen to FM radio
Tune to FM radio stations H
Tip
•• Position the antenna as far as possible from TV, VCR, or other
radiation source.
•• For better reception, fully extend and adjust the position of the
antenna.
Note
•• To turn on/off radio, press RADIO.
Store FM radio stations automatically
You can store a maximum of 20 FM radio stations.
1 Press RADIO to turn on the radio.
2 Press and hold PROG for two seconds.
»» The clock radio stores all the available FM radio stations and
broadcasts the first available station automatically.
Store FM radio stations manually
1
2
3
4
5
Tune to an FM radio station.
Press PROG.
»» The preset number begins to blink.
Press PRESET +/- or TUNING +/- repeatedly to select a
number.
Press PROG again to confirm.
Repeat steps 1 to 4 to store other stations.
Note
•• To remove a pre-stored station, store another station in its place.
Select a preset radio station
In tuner mode, press PRESET +/- to select a preset number.
6 Other features
Set alarm timer
Set alarm time I
You can set two alarms to ring at different time.
Note
•• Make sure that you have set the clock correctly.
1
2
3
Press and hold AL1/AL2 for 2 seconds to enter alarm setting
mode.
»» The hour and minute digits begin to blink.
»» or is displayed accordingly.
Press HR+/- and MIN+/- repeatedly to set hour and minute.
Press AL1/AL2 again to confirm.
Select alarm sound
For the alarm sound, you can select buzzer, your last heard radio or
played track in iPhone/iPod.
Adjust AL1/AL2 RADIO·BUZZ·iPhone to select alarm sound for
both alarms.
Tip
•• When alarm time arrives and you are listening to radio or audio in
iPhone/iPod, buzzer can only be activated as alarm sound.
•• If you have selected iPhone/iPod source, while no iPhone/iPod is
connected, the clock radio switches to buzzer source instead.
Activate/deactivate alarm timer
1
2
Press AL1/AL2 to view alarm settings.
Press AL1/AL2 again to activate or deactivate the alarm timer.
»» or appears if alarm timer is on and disappears if it is off.
• To stop alarm, press the corresponding AL1/AL2.
• The alarm repeats ringing for the next day.
Snooze alarm
When alarm sounds, press SNOOZE.
»» The alarm snoozes and repeats ringing five minutes later.
To adjust alarm interval (in minutes), press SNOOZE repeatedly.
5
10
15
20
25
30
Set sleep timer
This clock radio can switch to standby mode automatically after a preset
period.
Press SLEEP repeatedly to select the sleep timer period (in minutes).
»» When the sleep timer is activated,
appears.
To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off)
appears.
15
30
60
90
120
off
Adjust display brightness
Press BRIGHTNESS repeatedly to select different brightness levels: high,
mid, and low.
7 Product information
Note
•• Product information is subject to change without prior notice.
Specifications
Amplifier
Rated Output Power
2W RMS
Tuner
Tuning Range
FM: 87.5 - 108 MHz
Tuning grid
FM: 50 KHz
Sensitivity
- Mono, 26dB S/N Ratio
FM: <22 dBu
Search Selectivity
FM: <28 dBu
Total Harmonic Distortion
FM: <3%
Signal to Noise Ratio
FM: >45 dB
General information
AC Power
Model: AS100-050-AB200;
Input: 100-240 V ~, 50/60Hz,
0.5A;Output: 5 V , 2.0A
Operation Power Consumption
<10 W
Standby Power Consumption
<2 W
Dimensions
- Main Unit (W x H x D)
130 x 66 x 145.8 mm
Weight
- With Packing
- Main Unit
0.6 kg
0.4 kg
8 Troubleshooting
Warning
•• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/welcome). When
you contact Philips, ensure that the apparatus is nearby and the model
number and serial number are available.
No response from the unit
•• Disconnect and reconnect the AC power plug, then turn on the
unit again.
Poor radio reception
•• Increase the distance between the unit and your TV or VCR.
•• Fully extend the FM antenna.
9 Notice
Any changes or modifications made to this device that are not expressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.
Note
•• The type plate is located on the bottom of the apparatus.
“Made for iPod” and “Made for iPhone” mean that an electronic
accessory has been designed to connect specifically to iPod or iPhone
respectively, and has been certified by the developer to meet Apple
performance standards. Apple is not responsible for the operation of
this device or its compliance with safety and regulatory standards. Please
note that the use of this accessory with iPod or iPhone may affect
wireless performance.
iPod and iPhone are trademarks of Apple Inc., registered in the U.S. and
other countries.
Your product is designed and manufactured with high quality materials
and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product it
means that the product is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate collection system for
electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. Correct disposal of your
old product helps to prevent potential negative consequences for the
environment and human health.
Your product contains batteries covered by the European Directive
2006/66/EC, which cannot be disposed with normal household
waste.Please inform yourself about the local rules on separate collection
of batteries because correct disposal helps to prevent negative
consequences for the environmental and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
2011 © Koninklijke Philips Electronics N.V. All rights reserved.
Specifications are subject to change without notice. Trademarks are
the property of Koninklijke Philips Electronics N.V. or their respective
owners. Philips reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.
© 2011 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ3270D_93_UM_V1.0