Refill Instructions - HP CB337EE (No.351)

Refill Instructions HP CB337EE (No.351)
fig.1
fig.2
fig.3
HP Photosmart C4280 HP Deskjet D4260
HP Photosmart C5280 HP Officejet J5780 2510.
Cyan
Filling
Holes
Items Required
Original HP 351 Cartridge, Syringe, Drill Bit & Filling
Tube Cyan Ink 5ml, Magenta Ink 5ml, Yellow Ink 5ml
1. The filler holes are located under the coloured top
of the cartridge (fig.1)
2. Peel label back on top of cartridge.(fig.2)
3. Assemble syringe and steel filling tube and fill with
appropriate colour ink.
4. Insert the steel filling tube into the appropriate filling
holes. (fig.3,4 & 5). Push down into centre of the
sponge.
IMPORTANT: Cartridge contains a sponge and a
slight resistant may be felt.
5. SLOWLY Inject ink. When ink overflows from filling
hole or starts to leak from print heads cartridge is full.
Stop injecting immediately.
Blot printer heads with tissue before continuing to fill
next colour.
IMPORTANT: Clean syringe with water and dry
before refilling next colour.
6. After refilling replace label back over filling hole.
7. Leave the cartridge to stand overnight on nonabsorbent surface this will ensure no
leakage and give the ink time to fully saturate the
sponge.
IMPORTANT: DO NOT LEAVE ON TISSUE.
8. Install cartridge and run a priming cycle.
PLEASE NOTE: The ink indicator level may need to
be turned off. Check your HP instructions manual for
details.
fig.4
Magenta
Filling
Hole
fig.5
Yellow
Filling Hole
Open as PDF
Similar pages