Q
Quuiicckk FFaaccttss
DISH 1000
Highlights
Description
•
The DISH 1000 provides reception
from the 110°, 119° and 129° DBS
orbital locations using a dish
antenna size similar to a DISH 500.
•
Receives signal from
110°, 119° and 129° DBS
orbital locations
Includes a DP Plus Twin
and a DP Dual (or DP
Single) LNBF – no switch
need for up to two
receivers
•
Can be configured with
other LNBF combinations
if needed
•
Dish antenna size similar
to DISH 500
110° 119° 129°
Part Number: 140348
Standard Configuration
Includes a DISH Pro Plus Twin LNBF
and a DISH Pro Dual (or DP Single)
LNBF:
– DP Plus Twin LNBF for 110°,119°
– DP Dual LNBF for 129°
• Valid receiver combinations
include:
– Any DISH Pro or DISH Pro Plus
receiver.
ƒ Up to two DISH Pro Plus
receivers each with DISH
Pro Plus Separators for the
single-cable installation
advantage.
– One Legacy receiver with one
DISH Pro or DISH Pro Plus
receiver.
• Receivers NOT supported:
– 1 Legacy receiver alone
– 2 Legacy receivers
• The following Legacy receivers
will not have 129° software
support: Models 1000, 2000,
3000, 4000, 5000, JVC-DVHS and
DishPlayer 7100/7200.
Standard Configuration
Installation Considerations
Standard Configuration
Installation Considerations
(continued)
• An RG-6 cable 5-1/2 feet in
length must connect the DP LNBF
port to the DP Plus Twin LNB IN
port. This length of cable is
necessary to ensure the turn is
not too tight, reducing the
likelihood of premature cable
failure, and providing slack for
LNBF replacement.
Receiver Considerations
Receivers that support 129°will
display 129°in one of two ways:
• After peaking and taking the
download, 129° is displayed in
the Point Dish Satellite list with
all other possible orbital
locations.
• After peaking, taking the
download and running a check
switch, 129° is displayed in the
Point Dish Satellite list with
orbital locations available to that
receiver.
• Standard cable limitations apply
from LNBFs to receiver:
— 200 ft. for DP/DP Plus
— 150 ft. for Legacy
• Use the DISH Pro/DISH Pro Plus
Compatible Accessories List.
TM
Contents subject to change without notice.
EchoStar Technologies Corporation
Page 1 of 2
Rev. 10/31/2005
DISH 1000
Q
Quuiicckk FFaaccttss
Optional Configurations
Optional Configurations
(continued)
The standard configuration LNBFs
can be removed and replaced
with other LNBFs and/or used
with switches for additional
receivers or an additional orbital
location.
Replace with DISH Pro LNBFs:
• Use a DP Twin (or DP Quad) and
the DP Dual LNBF with a
DP Plus 44 switch or DP34
switch for additional receiver
support.
Add a DP Plus 44 Switch: the
DP Plus Twin with DP Dual (or
DP Single) LNBF configuration
can support additional receivers
or an additional orbital location
when connected to a DP Plus 44
switch. Both DP Plus Twin output
ports and one DP LNBF output
port are connected to the
DP Plus 44 switch. The DP Plus
Twin’s LNB IN port is not
operational when the LNBF is
connected to the switch.
• Use three DP Dual LNBFs with
either a DP34 switch or a DP
Plus 44 switch as needed.
REMEMBER: The DP Plus Twin and
DP34 switch cannot be used in
the same installation.
Replace all LNBFs with
Legacy LNBFs:
• Use three Legacy Dual LNBFs
and an SW64 switch.
Dimensions:
Port 1
• Reflector: 22.8” W, 18” H.
• Mast Outside Diameter: 1.66”
Port 2
Frequently Asked Questions
The DISH 1000 parts look a
lot like a DISH 500 – are they
interchangeable?
No, the DISH 1000’s W-bracket
will not fit on a DISH 500 LNBF
arm. Also, while the foot is the
same as a DISH 500, the mast on
a DISH 1000 is longer, to allow
for full azimuth rotation.
Why must a Legacy receiver
be installed with a DISH Pro
or DISH Pro Plus receiver?
One Legacy receiver alone
cannot power the DP Plus Twin
LNBF.
If two Legacy receivers are
installed, they will not be able to
turn on the DP Plus Twin’s LNB IN
port to view 129°.
Should I peak on 119°, then
fine-tune the signal on 110°
and 129°?
No. The dish is designed to
automatically provide the
strongest signal for 110° and
129° when fully peaked on 119°.
For More Information
To Receivers
DP Plus Twin & DP Dual
connected to a DP Plus 44 Switch
• DISH 1000 Product Launch
Bulletin
• DISH 1000 Installation Guide
• DISH Pro Plus Twin LNBF
Installation Guide
• DISH Pro Plus Twin Quick Facts
and Installation Considerations
TM
Contents subject to change without notice.
EchoStar Technologies Corporation
Page 2 of 2
Rev. 10/31/2005
Open as PDF
Similar pages