15. Battery cover
16. Terminal block
17. 9V Battery
Your message should be similar to: “[Your nameʼs ] security system has been activated.
Please enter a command.” (Optionally you may wish to list the commands: “1#”-Monitor
Room, “2#”-Broadcast, “3#”-End Call or “6#”-Disarm System.)
screws
1
2
Have the person on the other end enter one of the following commands: “1#”-Monitor Room,“2#”-Broadcast,“3#”-End
Call or “6#”-Disarm System.
When the siren feature is turned on, the Control Unit will sound an alarm when the security system is activated, and then dial the telephone number(s) contained in the list of telephone number(s). If the security system is not “DISARMED” after activation, the alarm will sound for 30 seconds, remain silent for 30 seconds, sound again for 30 seconds, and then will reset. After the siren resets, the system will remain in the “ARM” mode. When the siren feature is turned off, the security system will silently dial the telephone number(s) contained in the list of telephone number(s) so as not to alert the intruder. The default setting for the siren feature is on. To change the siren setting, follow these steps:
“1” then “#”,
“2” then “#”,
“5” then “#”,
“6” then “#”,
“3” then “#”.
until ress until
To purchase additional security items, including accessories for your alarm system, please visit www.mace.com
610-01808-006R