Breo iDream3S User manual
Add to my manuals
10 Pages
Breo iDream3S adopts air pressure, vibration, and hot compress massaging technology to massage your head and ocular regions. It has built-in relaxing music and an adjustable fit for a comfortable experience. You can use it to relieve stress, improve sleep, and reduce eye strain.
advertisement
iDream3S
HEAD MASSAGER
USER
MANUAL
OBM Distribution / Breo-USA
13900 Sycamore Way
Chino, CA 91710 http://www.breousa.com
Thank you for purchasing
BREO iDream3S.
Please read this manual carefully before using the product, and keep it in a safe place for future reference.
Contents
Introduction
Inside the Package
Function Deployment
Preparation
Operation
Precautions
Troubleshooting
Technical Parameters
Storage
3
5
5 -- 6
3
4
7 -- 8
9
9
9
2
Introduction
iDream3S adopts air pressure, vibration, and hot compress massaging technology to massage the head and ocular regions. It comes with built-in relaxing music. You can now enjoy wonderful music while massaging, further relaxing your brain.
Inside the Package
The package includes: Main Unit
, Power Charger, User Manual, Earphones
Main Unit
Power Charger Earphones
Manual
3
Function Deployment
Main Unit
D. A.
C. B.
A.
Pressure Reduction Valve
B.
DC Power Port
C.
D.
Earphone Jack
On/Off Switch
4
Preparation
Prior to use, check the integrity of the machine and accessories.
1.
No damage on power charger
2.
Battery power is sufficient
Operation
Charging of Main Unit
1.
2.
3.
Open the cover of the DC power port on the main unit.
Insert the plug of the power charger to the DC port.
During charging, the light of the power charger is red. The light turns green when fully charged.
Attention:
1.
Push the power switch on the main unit to Level “O”. Keep the massager turned OFF while charging. Charging time is approximately 3-4 hours.
2.
If the massager is turned on while recharging, all functions of the product will run normally. The machine will automatically stop charging to prevent damage to the
3.
device.
If the power of the battery is lower than 3.2+-0.1V, the machine will automatically turn off. If the LED indicator of the main unit flashes, it means the lithium battery is low.
Recharge the main unit.
5
Wear
1.
Use the back dial to adjust the distance between head to establish the most comfortable fit, and wear main unit.
2.
Use the top dial in setting the distance above head.
Power On/Off
1.
2.
Power ON – Push the ON/OFF switch on the main unit to Level “I”
(Picture 1)
The main unit is powered by a high performance, environment-friendly lithium battery.
Preset default is air pressure (circulates automatically from low to high), 15 minutes duration, vibration (at the final two minutes), hot compress (39-42°C)
Power OFF – Push the ON/OFF switch on the main unit to Level “O” to Level “I”
(picture 1)
Attention:
When you feel the air pressure is too much and/or uncomfortable, press the Pressure
Reduction Valve on the main unit to release air.
6
Precautions
1.
Please read the manual carefully and operate accordingly.
2.
Children under 7 years old cannot use the massager.
3.
This massager should not be used by people who suffer from a brain disease, have had brain surgery, or have a physical or mental disorder.
4.
Take off contact lenses/eye glasses before use.
5.
Put on/wear the unit first BEFORE turning the power on.
6.
Do not use while walking or driving.
7.
Keep your eyes closed for a few seconds after use, then open them slowly.
8.
Keep the massager away from humidity, heat, and/or corrosive gas.
9.
This massager is designed as a personal care product. It is not for diagnosis/treatment of any health disorder, nor meant for commercialuse.
10.
To clean, wipe with aseptic cotton and alcohol. Do not wash or immerse in water.
11.
This product is not a substitute for healthcare professionals' advice and treatment. In case of doubt or if necessary, please consult your healthcare professional.
12.
You must push the Power Switch Protection Key to level “0” to stop using this product.
13.
Please use DC4.5V power charger from our company in a safe manner.
14.
Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
7
15.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio ommunications. However, there is no guarantee that interference will not occur in a will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help
8
Troubleshooting , Technical
Parameters, & Storage
When operational problems occur, please refer to the chart below.
Do not disassemble the machine or try to repair it by yourself.
Problem Possible Reason Possible Solution
Power Switch Protection key is not turned on
Push this key to Level I
Power-On Failure
Lithium battery of the main unit is low
Recharge the main unit at once.
Weak air pressure or vibration
Lithium battery of the main unit is low
Recharge the main unit at once.
Technical Parameters
Power supply
:
Ideal environment
:
Dimension
:
Net Weight
:
Power
:
Storage
1.
DC: 4.5V
Temperature: 5°C - 40°C
Relative humidity:
:≤80%
Atmospheric Pressure: 860-1060hpa
Main Unit: 282mm X 206mm X 254mm
1000g
4.5W
If left unused, checking the product/turning the power on every 6 months is recommended.
2.
3.
Do not store near the floor, wall or roof.
Maintain good ventilation and keep away from direct sunlight and corrosive gases.
9
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement