- No category
advertisement
440140 PARKING BRAKE KIT
BILLY GOAT FORCE BLOWER
Parking Brake Manual
PARKING BRAKE
Effective and Easy to use.
P/N 440140
Part No 440144 - 1 - Form No F081409A
440140 PARKING BRAKE KIT
ASSEMBLY
To install parking brake, first install the bushings (item #3) into the rear holes located on the base next to the rear wheels (see figure below). Next place two washers (item #2) on the fork shaft, against the stop washer. Then gently push shaft through the bushings and hole until it rests against stop washer. Finally place two washers (item 2) and a pal nut (item #4) on opposing end. To install stop bolt, place washer face nut (item #6) on screwcap (item #5) until nut reaches the end of the threads. Next insert the screwcap into the hole located in front of the brake and use second washer face nut (item #6) on the interior and tighten it.
NOTE: For older model frames (square front forks) you will need to drill the hole for the screw (item 5) to 5/16” and only use one washer (item 2) on the same side as the brake lever.
1
5 6
2
3 2
6
4
5
6
3
4
1
2
Parts List
Part No.
Description
440143 ROD BRAKE WA
8172011 WASHER 1/2 SAE
500130 BUSHING SHIFTER
840089 NUT PAL 1/2
8041036 SCREWCAP 5/16"-18 X 3"
350346 NUT 5/16"-18 SER. HX WASHER
440140 PARKING BRAKE KIT
1
2
1
2
1
Qty
1
4
To apply parking brake, simply rotate forks to till they rest against the back end of the tire.
Place once foot on top fork and gently put downward pressure on the fork while carefully pushing unit forward. The forward motion of the tire will help to roll the forks into a fixed position. To remove from braking position pull unit backwards rotating the tire, which will rotate the forks away from locked position on wheel.
Part No 440144 - 2 - Form No F081409A
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project