Digitus 2 x DB9 M User manual

SERIAL I/O, 2-PORT

PCI EXPRESS ADD-ON CARD

User Manual

DS-30000-1

Features and Benefits

1. Compliant with PCI Express Base spec 1.1

2. Compliant with PCI Power Management 1.2

3. Supports 2 x UART serial port

4. Built-in 16C950 compatible UART

5. 128-byte deep transmit/receive FIFOs

6. Serial data transfer rate up to 230400bps

2 x DB9 male serial connectors

System Requirements

Windows ® 2000, XP/2003 32/64 bit, Vista , Win 7

PCI Express-enabled system with an available PCI Express slot

Package Contents

1 x PCIe Serial Card 2 Ports

1 x Driver CD

1 x User’s Manual

Hardware Installation

1. Turn off the power to your computer.

2. Unplug the power cord and remove your computer’s cover.

3. Remove the slot bracket from an available PCIe slot.

4. To install the card, carefully align the card’s bus connector with the selected PCIe slot on the motherboard. Push the board down firmly.

5. Replace the slot bracket’s holding screw to secure the card.

6. Replace the computer cover and reconnect the power cord.

Driver Installation

For Windows ® 2000/ XP / Server 2003 / XP / Vista / Win 7

1. Insert the Driver CD into the CD-ROM drive.

2. At the Found New Hardware Wizard, click Next.

3. Select Search for a suitable driver for my device

(recommended), and click Next.

4. Check CD-ROM drives, uncheck the other boxes, then click

Next.

5. Click Next.

6. Click Finish.

7. Repeat steps 1-5 one more time.

To Verify Windows

®

Driver Installation

Click on the Device Manager tab in System Properties, which you access from the Windows Control Panel. You should see two PCI

Express UART Port … installed under Ports (COM & LPT) item, and one PCI Express Multiport Serial Adapter installed under

Multi-port serial adapters item.