Philips Wireless Rear Audio module RWSS5512

Register your product and get support at
www.philips.com/welcome
RWSS5512
User manual
用户手册
使用手冊
Benutzerhandbuch
Gebruiksaanwijzing
Mode d'emploi
Manuale utente
Manual do Usuário
Manual del usuario
Руководство пользователя
1Notice
2
Compliance
Important
2
2
2Connect
3
3
3
4
4
3Troubleshooting
4
4 Product specifications
5
Place the wireless receiver
Connect the wireless transmitter
Connect rear speakers to wireless receiver
Connect power cord
English
Contents
EN
1
1Notice
•
•
Compliance
This product is in compliance with the essential
requirements and other relevant provisions of
Directives 2006/95/EC (Low Voltage), 2004/108/
EC (EMC).
* Wireless and Ethernet LAN functions are authorized
for indoor use only.
Hereby, Philips Consumer Lifestyle, declares that
this product is in compliance with the essential
requirements and other relevant provisions of
Directive 1999/5/EC.
A copy of the EC declaration of Conformity is available
in the Portable Document Format (PDF) version of
the user manual at www.philips.com/support.
Note
•• This equipment has been tested and found to
comply with the limits for a Class B,C digital device,
pursuant to Part 15 of the FCC Rules.These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation.This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
2
EN
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
Important
Read and understand all instructions before you
use your product. If damage is caused by failure to
follow instructions, the warranty does not apply.
Safety
Risk of electric shock or fire!
• Never expose the product and accessories to
rain or water. Never place liquid containers,
such as vases, near the product. If liquids are
spilt on or into the product, disconnect it
from the power outlet immediately. Contact
Philips Consumer Care to have the product
checked before use.
• Never place the product and accessories
near naked flames or other heat sources,
including direct sunlight.
•• Never insert objects into the ventilation slots
or other openings on the product.
•• Where the mains plug or an appliance coupler
is used as the disconnect device, the disconnect
device shall remain readily operable.
•• Disconnect the product from the power
outlet before lightning storms.
•• When you disconnect the power cord, always
pull the plug, never the cable.
Risk of short circuit or fire!
•• Before you connect the product to the
power outlet, ensure that the power voltage
matches the value printed on the back or
bottom of the product. Never connect the
product to the power outlet if the voltage is
different.
Risk of injury or damage to the product!
•• Never place the product or any objects
on power cords or on other electrical
equipment.
•• If the product is transported in temperatures
below 5°C, unpack the product and wait until
its temperature matches room temperature
before connecting it to the power outlet.
Risk of overheating!
•• Never install this product in a confined space.
Always leave a space of at least four inches
around the product for ventilation. Ensure
curtains or other objects never cover the
ventilation slots on the product.
2Connect
Your product is designed and manufactured with
high quality materials and components, which can
be recycled and reused.
Place the wireless receiver
English
Care of the environment
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC. Please inform yourself about the local separate
collection system for electrical and electronic
products.
Please act according to your local rules and do not
dispose of your old products with your normal
household waste.
Correct disposal of your old product helps to
prevent potential negative consequences for the
environment and human health.
Place the wireless receiver near the AC outlet and
in between the rear speakers. Align the wireless
receiver with the home theater, with Philips logo
facing the home theater.
WIRELESS
RECEIVER
Your product contains batteries covered by the
European Directive 2006/66/EC, which cannot be
disposed with normal household waste.
Please inform yourself about the local rules on
separate collection of batteries because correct
disposal helps to prevent negative consequences
for the environmental and human health.
Note
•• For best reception, make sure that the line-of-
site between the wireless receiver and the home
theater is not blocked by furniture, walls and
other objects.
Connect the wireless transmitter
Connect the wireless transmitter to the Wireless
Rear Audio connector on the back of the home
theater.
EN
3
Connect rear speakers to
wireless receiver
Note
•• The rear speakers in the picture showed may vary.
3Troubleshooting
Follow these steps if:
• there is no sound from the rear speakers, and
• the indicator on the wireless receiver blinks
continuously for more than one minute.
For Blu-ray home theater
Connect the home theater, wireless
transmitter, and wireless receiver correctly
(see 'Connect' on page 3).
Insert a pin into the pairing pinhole at the
back of the wireless receiver.
»» The indicator on the wireless receiver
blinks for thirty seconds. Complete the
remaining steps within thirty seconds.
1
REAR
LEFT
REAR
RIGHT
2
3
4
Connect the rear left and rear right speakers
to the matching connectors at the back of the
wireless receiver.
Connect power cord
Warning
•• Risk of product damage! Ensure that the power
supply voltage corresponds to the voltage
printed on the back or the underside of the
product.
Connect the power cords for home theater,
wireless receiver and other devices after you have
made all of the other connections.
»» The wireless indicator lights and the
wireless receiver is ready to use.
4
EN
Switch the home theater to either AUX
source or MUSIC iLINK source.
Press and hold the Navigation button
(right) until PAIRING (PAIRING) blinks on
the home theater display panel.
»» 'PAIRED (PAIRED) is displayed.
• If FAILED (FAILED) is displayed, repeat
steps 1 to 3.
For DVD home theater
Connect the home theater, wireless
transmitter, and wireless receiver correctly
(see 'Connect' on page 3)..
Insert a pin into the pairing pinhole at the
back of the wireless receiver.
»» The indicator on the wireless receiver
blinks for thirty seconds. Complete the
remaining steps within thirty seconds.
1
2
3
4
Press .
Press 1, then press SURR within five seconds.
»» PAIRED' (PAIRED) is displayed.
• If FAILED (FAILED) is displayed, repeat
steps 1 to 3.
English
4Product
specifications
Note
•• Specification and design are subject to change
without notice.
Wireless receiver
•• Power supply rating: 110-240V; ~50-60 Hz
•• Total output power: 250 W (RMS)
•• Power consumption: 50 W
•• Standby power consumption: ≤ 0.45 W
•• Frequency response: 150 Hz ~ 20 kHz
•• S/N Ratio: 65 dB (A-Weighted)
•• Distortion: 1%
•• Dimensions (WxHxD): 126 x 131 x 126
(mm)
•• Weight: 1.1 kg
Wireless transmitter
•• RF frequency: 5.8 GHz
•• Dimensions (WxHxD): 30 x 8 x 53 (mm)
•• Weight: 0.009 kg
EN
5
Philips Consumer Lifestyle
SGP-1208-CE-RWSS5512/00
CE2012
..............................................................
(Report No. / Numéro du Rapport)
........................................................................................
(Year in which the CE mark is affixed / Année au cours
de laquelle le marquage CE a été apposé)
EC DECLARATION OF CONFORMITY
(DECLARATION DE CONFORMITE CE)
We / Nous, PHILIPS CONSUMER LIFESTYLE B.V.
(Name / Nom de l’entreprise)
TUSSENDIEPEN 4, 9206 AD DRACHTEN, THE NETHERLANDS
(address / adresse)
Declare under our responsibility that the electrical product(s):
(Déclarons sous notre propre responsabilité que le(s) produit(s) électrique(s):)
PHILIPS
............................................................ ...........
(brand name, nom de la marque)
RWSS5512/00
....................................................... ....
(Type version or model, référence ou modèle)
Wireless Rear Audio
..............................................................................................
(product description, description du produit)
_
To which this declaration relates is in confirmity with the following harmonized standards:
(Auquel cette déclaration se rapporte, est conforme aux normes harmonisées suivantes)
(title, number and date of issue of the standard / titre, numéro et date de parution de la norme)
EN60065:2002, A1:2006, A11:2008, A2:2010, A12:2011
EN55022:2006, A1:2007
EN61000-4-2:2009
EN61000-4-3:2006; A1:2008; A2:2010
EN62311:2008
IEC62087:2008
IEC62301:2005
EN300 440-1 V1.6.1:2010
EN300 440-2 V1.4.1:2010
EN301 489-1 V1.8.1:2008
EN301 489-3 V1.4.1:2002
_
Following the provisions of :
(Conformément aux exigences essentielles et autres dispositions pertinentes de:)
2006/95/EC (Low Voltage Directive / Directive Basse Tension 2006/95/CE)
2004/108/EC (EMC Directive / Directive EMC 2004/108/CE)
1999/5/EC (R&TTE Directive / Directive R&TTE 1999/5/CE)
2009/125/EC (ErP Directive / Directive ErP 2009/125/CE)
EC1275/2008 (Regulation for ErP Directive / Reglement pour les ErP Directive)
And are produced under a quality scheme at least in conformity with ISO 9001 or CENELEC
Permanent Documents
(Et sont fabriqués conformément à une qualité au moins conforme à la norme ISO 9001 ou aux Documents Permanents CENELEC)
Safety
EMC
EMF
RTTE
Remarks:
: NO66615
: NEI-ETSE-1-1111C158
: NEI-ETSP-2-1111C158
: NEI-ETSP-1-1111C158
(Remarques:)
Drachten, Netherlands, February 21, 2012
...........................................................
(place,date / lieu, date)
6
EN
A. Speelman, CL Compliance Manager
.....................................................................................................
(signature, name and function / signature, nom et fonction)
_
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
Sgpam_1150_RWSS5512_00_v1