advertisement
▼
Scroll to page 2
of 15
EVERFOCUS Weatherproof Long Range IR Camera Operation Instructions Model No. EZ230E/235E/330E/335E Please read this manual first for correct installation and operation. This manual should be retained for future reference. The information in this manual was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. PRECAUTIONS 1. 2. 3. 4. 5. 6. 7. 8. 9. Do not place any object on top of the cover. Be careful when handling the camera, do not drop it or subject it to strong shock or vibration to prevent any damages to it. Do not disassemble it or place it on an unstable base. Install the camera away from TV, radio transmitter, magnet, electric motor, transformer, audio speakers because the magnetic fields generate from above devices will distort the video image. Install the camera away from stoves, or other heat generating devices as the high temperature could cause deformation, discoloration or other damages of the camera. Install the camera at where the temperature range will stay between -40℃ to 50℃ (-40℉ to 122℉). Never aim the camera at the sun or other extremely bright objects whether it is in use or not. Do not touch the surface of CCD sensor by hand directly. Use a soft cloth to remove the dirt from the camera body. Use lens tissue or a cotton tipped applicator and ethanol to clean the CCD sensor and the camera lens. When the camera is not in use, put the cover cap on the lens mount. All warnings on the products and in the operating instructions should be adhered to. Do not use attachments not recommended by the appliance manufacturer as they may cause hazards. Do not allow anything to rest on the power cord. Do not locate this appliance where the cord will be abused by persons walking on it. 10. Do not overload wall outlets and extension cords as this can result in fire or electric shock. 11. Never push objects of any kind into his appliance through cabinet slots as they may touch dangerous voltage points or short out parts that could result in fire or electric shock. 12. Refer all work related to the installation of this product to qualified service personnel or system installers. 1 PREFACE EZ230E/235E/330E/335E series camera is a true day/night, weather-proof, long range IR color camera, designed with the 1/3” SONY HAD color CCD to provide a high performance in low LUX environment. It is ideal for outdoor applications such as parking lots, gas stations and shopping malls. FEATURES z The electronic shutter and AGC functions allow the camera to be used in environment z with varying light levels The advanced 1/3” SONY Super HAD color CCD provides low light sensitivity 0.3 Lux/F=1.2 (AGC ON) for EZ230E/EZ235E and 0.4 Lux/F=1.2 (AGC ON) for EZ330E/335E Vari-frequency IR control z Long IR distance: 30 meters/98 feet for EZ230E/EZ330E and 50 meters/164 feet for z z z z z z EZ235E/EZ335E Lifespan of High Light IR LED is 20,000 hours IP66 weatherproof rated Built-in heater for camera to work in low temperature environment Cables covered by the bracket, to prevent from intentional destruction Internal cable connection provides installation without additional waterproof connection box Vandal proof design z 2 STANDARD ACCESSORIES ¾ ¾ ¾ ¾ ¾ IR Long Range Camera x 1 Operation Instructions x 1 (this document) Waterproof Connector x 1 (connected to the camera body) Bracket x 1 Mounting kit includes: -Long Screws x 4 (for mounting bracket) -Short Screws x 4 (for connecting camera body to bracket) -Expanding Screws x 4 -Hex key x 1 (for adjusting bracket) -Hexagon wrench x 1 (for adjusting sunshield) 3 DIMENSIONS Dimension of holes to holes Dimension of Bracket 215mm/8.6” 84mm/3.36” 45mm/1.8” 100mm/4” 95mm/3.8” 80mm/3.2” 196mm/7.84” The dimension of whole camera with bracket 217mm/8.68” 350mm/14” 4 NAMES AND FUNCTIONS OF BACK PANEL 24VAC model 1 ○ 110V~240VAC model 2 ○ 3 ○ 1 ○ 2 ○ 1 ○ 3 ○ Video Output Connector Connect the video output of the camera to a color monitor or other video devices through a 75 Ohm type coaxial cable with BNC female connector at backside of the camera. 2 ○ Power Input Terminal Connect to the appropriate power to each model. N/L is used to connect to power in. PE is a ground pin. 3 ○ Cable clips Used to fix power cable. 5 INSTALLATION GUIDE Sun shield Fixing screw for sunshield Bracket Power connector Video output 6 1. Wire coaxial cable and power cable through the bracket. Note: Please use RG59/5C2V coaxial cable without connector 2. Fix the bracket to wall by using 4 screws. 7 3. Open camera’s back cover: Loose the 2 screws from the back panel, then open the back cover. Screws for back panel 4. Take off the cap of waterproof connector which is under the camera. Power cable Coaxial cable 8 Reserved Note: 1. The holes of waterproof connector were plugged by stoppers, please remove the stoppers when you need to use it for connection. 2. Please always keep the smallest hole (5 mm) plugged by stopper, to avoid any possible damage caused by humidity. This is a reserved hole. 5. Take coaxial cable and power cable to pass through waterproof connector, place them into camera housing. Note: Do not connect BNC connector to coaxial cable until coaxial cable has passed through camera housing 9 Video cable and power cable Note: 1. Power cable’s diameter must be under 10mm 2. Only use RG59/5C2V coaxial cable 6. Close the waterproof cap and fix waterproof connector to the base of camera firmly. 10 7. Fix the camera body to bracket by using the 4 shorter screws. 8. Connect RG59 coaxial cable with BNC connector. 9. Unscrew the cable clips, wire power cable through the cable clips. Then, screw the cable clips to rear panel. Power cable Coaxial cable Cable Clips 11 10. Close the back cover and screw the 2 screws firmly. Now, you are done with the installation. Screws for back panel ADJUSTMENT Adjust camera’s angle vertically or horizontally by using hex key included in package. Loose this screw to make angle adjustment vertically Loose this screw to make angle adjustment horizontally 12 SPECIFICATIONS Type EZ230E EZ235E Horizontal Resolution EZ335E 1/3” SONY Super HAD CCD Pickup Device Picture Elements EZ330E 510 x 492 (NTSC) 768 x 494 (NTSC) 500 x 582 (PAL) 752 x 582 (PAL) 380 TVL 520 TVL BNC 1.0Vp-p, 75ohm Video Output *Lens Type 6mm, 8mm 8mm, 16mm, 25mm 6mm, 8mm 8mm, 16mm, 25mm Sensitivity 0.3 Lux/F=1.2 (AGC ON) 0.4 Lux/F=1.2 (AGC ON) 0 Lux (IR On) 0 Lux (IR On) 0.45 Gamma Correction Over 48 dB (AGC off) S/N Ratio Auto White Balance Yes Black Light Comp. Yes Auto Gain Control Yes Sync. Mode Internal Sync. IR LED Lifespan 20,000 hours Weatherproof IP66 Power Source 2 types: 24VAC ; 100VAC~240VAC 24VAC / 100VAC~240VAC : 16W max. Power Consumption Dimensions Operating Temperature 115mm(W) x 115mm(H) x 275mm(D) ; 4.5"(W) x 4.5" (H) x 10.8"(D) -40°C to +50°C ; -40℉ to 122℉ (20%~80% Humidity) 2.5 kg ; 5.5 lbs (with bracket) Weight IR Distance 30M / 98 feet 50M / 164 feet 30M / 98 feet 850nm IR Wavelength FCC/CE Certifications *Lens models and availability vary in different regions 13 50M / 164 feet EverFocus Electronics Corp. Head Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886-2-26982334 FAX: +886-2-26982380 www.everfocus.com.tw USA L.A. Office: 1801 Highland Ave. Unit A Duarte, CA 91010, U.S.A. TEL: +1-626-844-8888 FAX: +1-626-844-8838 www.everfocus.com USA N.Y. Office: 415 Oser Avenue Unit S Hauppauge, NY 11788 TEL: 631-436-5070 FAX: 631-436-5027 www.everfocus.com Your EverFocus product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life, should be disposed of separately from your household waste. Please, dispose of this equipment at your local community waste collection/recycling centre. In the European Union there are separate collection systems for used electrical and electronic product. Please, help us to conserve the environment we live in! Europe Office: Albert-Einstein-Strasse 1 D-46446 Emmerich, Germany TEL: 49-2822-9394-0 www.everfocus.de China Office: Room 609, Technology Trade Building, Shangdi Information Industry Base, Haidian District, Beijing,China 10085 TEL: +86-10-62973336/37/38/39 FAX: +86-10-62971423 www.everfocus.com.cn Japan Office: 1809 WBG MARIBU East 18F, 2-6 Nakase.Mihama-ku. Chiba city 261-7118, Japan TEL: +81-43-212-8188 FAX: +81-43-297-0081 www.everfocus.com Ihr EverFocus Produkt wurde entwickelt und hergestellt mit qualitativ hochwertigen Materialien und Komponenten, die recycelt und wieder verwendet werden können. Dieses Symbol bedeutet, dass elektrische und elektronische Geräte am Ende ihrer Nutzungsdauer vom Hausmüll getrennt entsorgt werden sollen. Bitte entsorgen Sie dieses Gerät bei Ihrer örtlichen kommunalen Sammelstelle oder im Recycling Centre. Helfen Sie uns bitte, die Umwelt zu erhalten, in der wir leben! P/N: MZ23G00210_Ver.D 14
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement