Philips Original radio mini OR2000M

Always there to help you
Register your product and get support at
www.philips.com/welcome
Question?
Contact
Philips
User manual
OR2000M
Contents
1Safety
2
2 What's in the box
3
3 Connect power
4
4 Power on
5
5 Adjust volume
6
6 Listen to radio
7
7 Listen to an external device 8
8Troubleshooting
9
Congratulations on your purchase, and welcome
to Philips! To fully benefit from the support that
Philips offers, register your product at www.
philips.com/welcome.
9 Product information
10
General information
10
Tuner10
Speakers10
Amplifier
10
10Notice
11
Compliance11
Care of the environment
11
Copyright11
EN
1
1Safety
Read and understand all instructions before you
use this product. If damage is caused by failure
to follow the instructions, the warranty does
not apply.
Risk of electric shock or fire!
• Never expose the product and accessories
to rain or water. Never place liquid
containers, such as vases, near the product.
If liquids are spilt on or into the product,
disconnect it from the power outlet
immediately. Contact Philips Consumer
Care to have the product checked before
use.
• Never place the product and accessories
near naked flames or other heat sources,
including direct sunlight.
• Never insert objects into the ventilation
slots or other openings on the product.
• Where the mains plug or an appliance
coupler is used as the disconnect device,
the disconnect device shall remain readily
operable.
• Disconnect the product from the power
outlet before lightning storms.
• When you disconnect the power cord,
always pull the plug, never the cable.
Risk of short circuit or fire!
• Before you connect the product to the
power outlet, make sure that the power
voltage matches the value printed on the
back of the product. Never connect the
product to the power outlet if the voltage
is different.
• Never expose the product to rain, water,
sunshine, or excessive heat.
• Avoid force coming onto power plugs.
Loose power plugs can cause arcing or fire.
Risk of injury or damage to the product!
• This product shall not be exposed to
dripping or splashing!
2
EN
•
•
•
Do not place any sources of danger on this
product (e.g. liquid filled objects, lighted
candles).
Never place the product or any objects
on power cords or on other electrical
equipment.
If the product is transported in
temperatures below 5°C, unpack the
product and wait until its temperature
matches room temperature before
connecting it to the power outlet.
Risk of overheating!
• Never install this product in a confined
space. Always leave a space of at least four
inches around the product for ventilation.
• Make sure that curtains or other objects
never cover the ventilation slots on the
product.
Note
•• The rated power voltage and frequency are printed on
the back of the product. The model number and serial
number are printed on the bottom.
2 What's in the
box
Check and identify the contents of the package:
OR2000M
User Manual
EN
3
3 Connect power
Connect the power plug to the AC power
outlet.
4
EN
4 Power on
Turn the left knob clockwise until you hear a
"click" sound.
• To power off, turn the left knob anticlockwise until you hear a "click" sound.
EN
5
5 Adjust volume
•
•
6
To increase the volume, turn the left knob
clockwise.
To decrease the volume, turn the left knob
anti-clockwise.
EN
6 Listen to radio
Note
•• For optimal reception, fully extend the antenna and
adjust its position, or connect an outdoor antenna.
1
2
Press down FM/MW to switch the tuner
band to MW.
• To switch the tuner band to FM, press
FM/MW again to release it.
Turn the right knob anti-clockwise or
clockwise to adjust the frequency.
»» The red LED bar points at the current
frequency.
EN
7
7 Listen to an
external device
You can also listen to an external audio device,
for example, MP3 player, through this product.
1
2
Connect an audio input cable with a 3.5
mm connector on both ends to
• the AUDIO-IN socket on the back
panel of this product, and
• the headphone socket on the external
device.
Play audio on the external device (refer to
its user manual).
Note
•• If you want to listen to radio, disconnect the audio
input cable from the product.
8
EN
8Troubleshooting
Warning
•• Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
product, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the product is nearby and the
model number and serial number are available.
No power
•• Make sure that the AC power cord is
properly connected.
•• Make sure that there is power at the AC
power outlet.
No sound
• Adjust the volume.
• When listening to an external device, make
sure that the external device is not muted.
• When listening to radio, make sure that
the audio input cable is disconnected from
the AUDIO-IN socket on the back of this
product.
No response from the product
• Make sure that the power is available.
• Power off the product, and then power on
again.
Poor radio reception
•• Due to the interference from other
electrics or building obstacles, the signals
become weak. Move the product to a
place free of interference.
•• Make sure that the antenna is fully
extended. Adjust the position of the
antenna.
EN
9
9Product
information
Note
Speakers
Speaker Impedance
Speaker Driver
Sensitivity
8 Ohm
3" full range
> 82 dB/m/W
•• Product information is subject to change without prior
notice.
Amplifier
General information
AC Power Rating
Operation Power
Consumption
Dimensions
(Main Unit)
Weight (Main Unit)
220-240 V~, 50 Hz
9W
245 x 123 x 122 mm
1.33 kg
Tuner
Tuning Range
Total Harmonic
Distortion
Signal to Noise Ratio
10
EN
FM: 87.50 - 108.00
MHz;
MW: 531 - 1,602 kHz
< 2%
> 50 dBA
Output Power
Frequency Response
Signal to Noise Ratio
Audio Input
3 W RMS
60 Hz - 16 kHz,
±3 dB
> 65 dBA
0.5 V RMS 20 kOhm
10Notice
Any changes or modifications made to this
device that are not expressly approved by
Philips Consumer Lifestyle may void the user’s
authority to operate the equipment.
Compliance
This product complies with the radio
interference requirements of the European
Community.
Please act according to your local rules and
do not dispose of your old products with your
normal household waste.
Correct disposal of your old product helps to
prevent potential negative consequences for the
environment and human health.
Environmental information
All unnecessary packaging has been omitted.
We have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can
be recycled and reused if disassembled by
a specialized company. Please observe the
local regulations regarding the disposal of
packaging materials, exhausted batteries and old
equipment.
Copyright
This is CLASS II apparatus with double
insulation, and no protective earth provided.
Care of the environment
2013 © Koninklijke Philips Electronics N.V.
Specifications are subject to change without
notice. Trademarks are the property of
Koninklijke Philips Electronics N.V or their
respective owners. Philips reserves the right
to change products at any time without being
obliged to adjust earlier supplies accordingly.
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
When this crossed-out wheeled bin symbol is
attached to a product it means that the product
is covered by the European Directive 2002/96/
EC. Please inform yourself about the local
separate collection system for electrical and
electronic products.
EN
11
Specifications are subject to change without notice
© 2013 Koninklijke Philips Electronics N.V.
All rights reserved.
OR2000M_12_UM_V1.0