Maxsa 40241 lighting spot Manual

motion-activated

ANYWHERE LIGHT

TM

40240, 40241

ABOUT YOUR MOTION-ACTIVATED ANYWHERE LIGHT TM

Totally portable and weatherproof.

Perfect outdoors for doors, steps, decks, sheds, garages, pathways, porches, and anywhere additional light is needed.

Also perfect indoors for hallways, stairways,closets, and bathrooms.

Built-in motion sensor automatically turns on the light when movement is detected in the area. The light remains on while motion continues to be detected in the area.

Built-in photosensor enables the light to only turn on at night.

The 4 super bright LEDs have an estimated life of 30,000 hours, so they never need changing.

Requires 4 D cell batteries (not included). The batteries typically last up to 1 year under normal use.

3.

D

4.

1. To access the battery compartment, twist open the back half

of the light counterclockwise.

Anywhere TM

2. Remove the battery compartment cover by squeezing the

two tabs on the cover inward.

5. Reassemble the Motion-Activated Anywhere Light by twisting

the back half of the light clockwise tightly to ensure a weather

proof seal.

TM

TM fresh

Anywhere TM

Anywhere

1. In order to mount the light securely to a wall or other stable

surfaces, the mounting base needs to be installed. Slide the

the mounting place to separate it from the main body.

2. If you are installing the mounting place on a very hard

surface, you may need to drill holes for the screws first.

The included screw anchors can be used for drywall,

cement, brick, or similar surfaces.

3. Use the two screws supplied to install the mounting plate.

Anywhere TM

Anywhere TM

25 feet

because

Anywhere TM

1. Align the base to the mounting plate. Slide the main body

onto the mounting plate until it snaps into place.

Anywhere TM

Depending on your preferences, you can rotate the base on the mounting plate or make the motion sensor and the light swivel to aim at different directions.

At night, the LED lights will remain on for approximately 40 seconds after the last detected movement. If a movement is detected while the lights are on, the light duration will be reset and remain on for another 40 seconds.

approx. 40 seconds

3 [email protected]

2010 v10.1

3