Philips Clock Radio AJ3116

Register your product and get support at
www.philips.com/welcome
EN
User manual
AJ3116
a
b
c
d
SLEEP
15
30
60
OFF
90
120
e
1
2
PRESET/
SET TIME
2 sec
HR
3
4
MIN
PRESET/
SET TIME
f
1
2
RADIO
ON/OFF
TUNING
2 sec
MIN
3
4
TUNING
HR
2 sec
VOLUME
VOLUME
g
1
2
2 sec
HR
3
4
MIN
h
AL1 FM
AL1
English
1Important
• Read these instructions.
• Heed all warnings.
• Follow all instructions.
• Do not block any ventilation openings. Install in accordance with the
manufacturer’s instructions.
• Do not install near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including amplifiers) that produce heat.
• Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point where
they exit from the clock radio.
• Only use attachments/accessories specified by the manufacturer.
• Unplug this clock radio during lightning storms or when unused for
long periods of time.
• Refer all servicing to qualified service personnel. Servicing is required
when the clock radio has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects
have fallen into the clock radio, the clock radio has been exposed to
rain or moisture, does not operate normally, or has been dropped.
• Battery usage CAUTION – To prevent battery leakage which may
result in bodily injury, property damage, or damage to the clock radio:
• Install the battery correctly, + and - as marked on the clock radio.
• Remove the battery when the clock radio is not used for a long
time.
• The battery shall not be exposed to excessive heat such as
sunshine, fire or the like.
• This clock radio shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the clock radio (e.g. liquid
filled objects, lighted candles).
• Where the plug of the Direct Plug-in Adapter is used as the
disconnect device, the disconnect device shall remain readily
operable.
2
Your clock radio
Congratulations on your purchase, and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/welcome.
What’s in the box (Fig.
3
)
Get started
Always follow the instructions in this chapter in sequence.
Install battery
The battery can only back up clock and alarm settings.
Caution
•• Risk of explosion! Keep the battery away from heat, sunshine or fire. Never
discard battery in fire.
•• The battery contains chemical substances, so it should be disposed of
properly.
Insert one 9V 6F22 battery (not supplied) with correct polarity (+/-) as
illustrated. (Fig. )
Tip
•• The display backlight is off when AC power is disconnected.
Connect power (Fig.
)
Caution
•• Risk of product damage! Make sure that the power voltage corresponds to
the voltage printed on the back or underside of the clock radio.
•• Risk of electric shock! When you unplug the power adapter, always pull the
plug from the socket. Never pull the cord.
Note
•• The type plate is located at the bottom of the clock radio.
Set time (Fig.
)
Note
•• You can only set time in standby mode.
4
Listen to FM radio
Note
•• Keep the clock radio away from other electronic devices to avoid radio
interference.
•• For better reception, fully extend and adjust the position of the FM antenna.
Tune to FM radio stations (Fig.
)
Store FM radio stations manually
You can store up to 10 FM radio stations.
1 Tune to an FM radio station.
2 Press and hold PRESET for two seconds.
»»The preset number begins to blink.
3 Press
TUNING
repeatedly to select a number.
4 Press PRESET again to confirm.
5 Repeat steps 1 to 4 to store other stations.
Tip
•• To remove a pre-stored station, store another station in its place.
Select a preset radio station
In tuner mode, press PRESET repeatedly to select a preset number.
Adjust volume
While listening, press - VOLUME + to adjust volume.
5
Other features
Set alarm timer
Set alarm
Note
•• You can only set the alarm in standby mode.
•• When alarm sounds, volume rises gradually. You cannot adjust the alarm
volume manually.
•• Make sure that you have set the clock correctly.
Follow the illustration to set the first alarm. (Fig.
• AL1: set the first alarm.
• AL2: set the second alarm.
)
Tip
•• The clock radio exits alarm setting mode when being idle for 10 seconds.
Select alarm source
You can select FM radio or buzzer as the alarm source. (Fig.
»» The corresponding alarm icon lights up.
)
Activate/deactivate the alarm timer
Press AL1 or AL2 repeatedly to activate or deactivate the alarm timer.
(Fig. )
»» If the alarm timer is deactivated, the alarm indicator turns off.
»» The alarm repeats ringing for the next day.
Snooze the alarm
When alarm sounds, press SNOOZE.
»» The alarm snoozes and repeats ringing nine minutes later.
Set sleep timer
This clock radio can switch to standby mode automatically after a preset
period. (Fig. )
To deactivate the sleep timer:
• Press SLEEP repeatedly until [OFF] (off) appears.
6
Product information
Note
•• Product information is subject to change without prior notice.
Specifications
Amplifier
Total Output Power
200 mW RMS
Tuner (FM)
Tuning range
Tuning grid
Sensitivity
- Mono, 26 dB S/N Ratio
- Stereo, 46 dB S/N Ratio
Total Harmonic Distortion
Signal to Noise Ratio
87.5-108 MHz
50 KHz
<22 dBf
<51.5 dBf
<3%
>50 dBA
General information
AC power (power adapter)
Operation Power Consumption
Standby Power Consumption
Dimensions:
Main Unit (W x H x D)
Weight:
-Main Unit
-With Packing
Brand name: Philips;
Model: AS030-060-EE050;
Input: 100-240 V~, 50/60 Hz;
0.15 A;
0.5 A
Output: 6 V
5W
<1 W
130 x 46 x 130 mm
0.26 kg
0.4 kg
7Troubleshooting
Warning
•• Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/support). When
you contact Philips, ensure that the apparatus is nearby and the model
number and serial number are available.
No power
•• Ensure that the AC power plug of the unit is connected properly.
•• Ensure that there is power at the AC outlet.
No sound
•• Adjust the volume.
No response from the unit
•• Disconnect and reconnect the AC power plug, then turn on the unit
again.
Poor radio reception
•• Increase the distance between the unit and your TV or VCR.
•• Fully extend the FM antenna.
Alarm does not work
•• Set the clock/alarm correctly.
Clock/alarm setting erased
•• Power has been interrupted or the power plug has been
disconnected.
•• Reset the clock/alarm.
8Notice
Any changes or modifications made to this device that are not expressly
approved by Philips Consumer Lifestyle may void the user’s authority to
operate the equipment.
This product complies with the radio interference
requirements of the European Community. Your product is designed and manufactured with high quality
materials and components, which can be recycled and
reused.
When this crossed-out wheeled bin symbol is attached
to a product it means that the product is covered by the
European Directive 2002/96/EC.
Please inform yourself about the local separate collection
system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old
products with your normal household waste. Correct disposal of your
old product helps to prevent potential negative consequences for the
environment and human health.
Your product contains batteries covered by the European
Directive 2006/66/EC, which cannot be disposed with
normal household waste.Please inform yourself about
the local rules on separate collection of batteries because
correct disposal helps to prevent negative consequences for the
environmental and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
All registered and unregistered trademarks are property of their
respective owners.
© 2012 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ3116_91_UM_V1.0